Effect of lead on formation and dielectric tunability of (Pbx,Sr1? x )0.85Bi0.1TiO3 thin films

(Pb_x,Sr_1−x )_0.85Bi_0.1TiO₃ thin films with the perovskite phase structure were prepared on an ITO glass substrate by sol-gel method. X-ray diffraction (XRD), scanning electron microscopy (SEM) and an impedance analyzer were respectively used in order to characterize the phase status, morphology and dielectric properties of the thin films. The results show that during the formation process of (Pb_x,Sr_1−x )_0.85Bi_0.1TiO₃ thin films, the nucleus of the perovskite phase are initially formed and then congregated. These aggregated nucleus are then transformed as the perovskite-phase crystalline in the thin film. Finally, the crystalline phase grows and separates gradually to form the perfect crystalline-phase structure. The content of the perovskite phase formed in the thin film under rapid thermal process (RTP) is more than that formed under traditional heat treatment with kinetic equilibrium. This is due to the high active decomposed ions that form the perovskite phase directly when heat-treated by RTP. The formation of the perovskite phase therefore overcomes a much lower barrier under RTP than that under traditional calcinations. The structure of the perovskite phase has a close relation to the ratio of Pb/Sr in the system because of the radius difference between Pb²⁺ and Sr²⁺. The transformation temperature between the cubic and the tetragonal structures of the perovskite phase increases with increasing Pb²⁺ content because the radius of Pb²⁺ is larger than that of Sr²⁺. It appears at room temperature when the content of Pb²⁺/Sr²⁺ is about 40/60 in the thin film. Meanwhile, the tetragonality of the perovskite phase is increased when Pb²⁺ ions increase due to its high polarization. The higher tunability of the (Pb_x,Sr_1−x )_0.85Bi_0.1TiO₃ thin film is exhibited when the film composition is close to the transformation point between the paraelectric and ferroelectric phases. Pb²⁺ ions show a dominant factor to affect the Curie point of the system and then changing tunability. Translated from Journal of Inorganic Materials, 2006, 21(2): 466–472 译自: 无机材料学报]