首页 | 本学科首页   官方微博 | 高级检索  
     

乳化炸药线型切割器对薄壳弹药销毁效果的数值模拟研究
引用本文:王敏,龙源,钟明寿,谢兴博.乳化炸药线型切割器对薄壳弹药销毁效果的数值模拟研究[J].爆破器材,2018,47(2):39-43.
作者姓名:王敏  龙源  钟明寿  谢兴博
作者单位:解放军陆军工程大学 江苏南京,210007;解放军陆军工程大学 江苏南京,210007;解放军陆军工程大学 江苏南京,210007;解放军陆军工程大学 江苏南京,210007
基金项目:国家自然科学基金,江苏省自然科学基金面上项目
摘    要:针对目前的弹药销毁状况,为了减轻直接爆破的环境压力,利用理论分析及数值模拟的方法,首先对设计的简易乳化炸药线型切割器的药型罩材料进行确定,数值模拟表明:铝质药型罩所形成的射流侵彻能力要比紫铜材质的提高28%,而后利用ANSYS数值模拟得出该切割器最佳炸高为15 mm。最后对乳化炸药线型切割器切割薄壳弹药的过程进行数值模拟,证明该切割器可以达到切去弹药外壳而不产生剧烈爆轰及高速破片的效果。

关 键 词:聚能射流  切割器设计  冲击起爆  数值模拟

Numerical Simulation of Destruction Efficiency of Linear Shaped Charge Cutter with Emulsion Explosive on Thin Shell Ammunition
WANG Min,LONG Yuan,ZHONG Mingshou,XIE Xingbo.Numerical Simulation of Destruction Efficiency of Linear Shaped Charge Cutter with Emulsion Explosive on Thin Shell Ammunition[J].Explosive Materials,2018,47(2):39-43.
Authors:WANG Min  LONG Yuan  ZHONG Mingshou  XIE Xingbo
Abstract:In order to minimize the environmental pressure caused by direct blasting resulting from existing ammuni-tion destruction conditions,theoretical analysis and numerical simulation were used to determine material of linear shaped charge cutter of emulsion explosive. Simulation results show that penetration ability of the jets formed by the aluminum coating is 28% higher than that of the copper. Then ANSYS software assesses to obtain the optimum blast height as 15 mm. Finally,the cutting process of thin shell ammunition by the linear cutter of emulsion explosive was simulated. It has been proved that the designed cutter can ensure the effect of getting rid of the shell of ammunition without generating violent deto-nation and high-speed fragment.
Keywords:
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号