| 筒形件强力旋压工艺模拟及实验研究 |
| |
| 引用本文： | 郭福林,李萍,钱陈豪,张宾宾.筒形件强力旋压工艺模拟及实验研究[J].金属成形工艺,2010(5):13-16. |
| |
| 作者姓名： | 郭福林 李萍 钱陈豪 张宾宾 |
| |
| 作者单位： | 合肥工业大学材料科学与工程学院,合肥230009 |
| |
| 基金项目： | 合肥工业大学大学生创新性实验计划项目（2009CXSY095） |
| |
| 摘 要： | 采用有限元与工艺实验相结合的方法，对筒形件强力旋压工艺进行了研究。对于旋压加工工艺，利用有限元模拟软件建立三维弹塑性模型并进行数值模拟，然后在此基础上分析进给比、减薄率2个工艺参数对筒形件强力旋压成形过程的影响规律。根据数值模拟结果，设计并制造了工装与模具，同时进行了工艺试验，成功试制了壁厚减薄效果良好的筒形件强力旋压样件。
|
| 关 键 词： | 筒形件 强力旋压 数值模拟 工艺参数 |
Simulation and Experiment Research on the Power Spinning Process for Cylindrical Parts |
| |
| GUO Fu-lin,LI Ping,QIAN Chen-hao,ZHANG Bin-bin.Simulation and Experiment Research on the Power Spinning Process for Cylindrical Parts[J].Metal Forming Technology,2010(5):13-16. |
| |
| Authors: | GUO Fu-lin LI Ping QIAN Chen-hao ZHANG Bin-bin |
| |
| Affiliation: | (School of Material Science and Engineering, Hefei University of Technology, Hefei 230009, China) |
| |
| Abstract: | The power spinning process for cylindrical parts was studied by the combined method of experimental process and finite element. By using FEM, three-dimensional elastic plastic model was established and numerical simulation for the spinning process was carried out, then the influence of feed rate and thickness reduction on the power spinning process was ana- lysed. According to the results of numerical simulation, device and mould were designed and manufactured, the process test was conducted. Finally, the power spinning sample with good thickness reduction effect was successfully obtained. |
| |
| Keywords: | cylindrical part power spinning numerical simulation technological parameter |
| 本文献已被 维普 等数据库收录！ |
