| 型腔模设计中推杆直径的确定 |
| |
| 引用本文： | 陈怀明.型腔模设计中推杆直径的确定[J].模具工业,2001(3):42-44. |
| |
| 作者姓名： | 陈怀明 |
| |
| 作者单位： | 山东建筑工程学院 |
| |
| 摘 要： | 在型腔模设计中 ,推杆直径大小的确定一般是根据经验或依据类比法确定 ,这样确定的推杆往往与生产实际有一定的差距 ,通过对推杆的受力状况进行分析 ,从理论计算角度对推杆直径进行确定。
|
| 关 键 词： | 型腔模 推杆 导向装置 强度 |
| 修稿时间： | 2000年3月24日 |
Determination of the Diameter of the Ejector Pin in the Design of the Cavity Mould |
| |
| Chen Huaiming.Determination of the Diameter of the Ejector Pin in the Design of the Cavity Mould[J].Die & Mould Industry,2001(3):42-44. |
| |
| Authors: | Chen Huaiming |
| |
| Affiliation: | Chen Huaiming |
| |
| Abstract: | In the design of the cavity mould, the diameter of the ejector pin is usually determined based on one's experience or according to analogism. The ejector pin determined in this way usually has certain disparity to the actual production. Through the analysis of the stress exerted on the ejector pin, the diameter of the ejector pin was determined from the perspective of theoretical calculation. |
| |
| Keywords: | cavity mould ejector pin guide system strength |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
