| 三维非轴对称管件缩径旋压成形工艺研究 |
| |
| 引用本文： | 程秀全,夏琴香.三维非轴对称管件缩径旋压成形工艺研究[J].轻合金加工技术,2006,34(8):30-33. |
| |
| 作者姓名： | 程秀全 夏琴香 |
| |
| 作者单位： | 1. 广州民航职业技术学院,广东,广州,510403
2. 华南理工大学,机械工程学院,广东,广州,510640 |
| |
| 基金项目： | 国家自然科学基金;广东省自然科学基金;广东省科技攻关计划 |
| |
| 摘 要： | 以铝质汽车排气歧管为研究对象,探讨了热处理工艺规范、名义压下量、进给比、旋轮运动轨迹等对三维非轴对称偏心及倾斜件多道次缩径旋压成形工艺的影响,通过选择合理工艺参数及旋轮运动轨迹,研制出合格的汽车排气歧管样件。研究结果表明,与冲焊结构相比,采用旋压技术来生产汽车排气歧管,可将缩管率由35%左右提高到60%以上,使零件的加工工序数由26个减少到2个,可以显著降低产品的生产成本和提高产品的生产效率。
|
| 关 键 词： | 旋压 排气歧管 偏心件 倾斜件 工艺参数 |
| 文章编号： | 1007-7235（2006）08-0030-04 |
| 收稿时间： | 2006-06-12 |
| 修稿时间： | 2006年6月12日 |
Research on neck-spinning process of 3D non-axisymmetric tubes |
| |
| CHENG Xiu-quan,XIA Qin-xiang.Research on neck-spinning process of 3D non-axisymmetric tubes[J].Light Alloy Fabrication Technology,2006,34(8):30-33. |
| |
| Authors: | CHENG Xiu-quan XIA Qin-xiang |
| |
| Affiliation: | 1.Guangzhou Civil Aviation Collage, Guangzhou 510403,China; 2.South China University of Technology, Guangzhou, 510640, China |
| |
| Abstract: | The influences of forming parameters,such as specification of heat treatment,nominal reduction of blank radius,feed ratio and roller track,on multi-pass neck-spinning of aluminum exhausted pipe used in vehicle are researched,and sound exhausted pipes are developed by selecting reasonable processing parameters and roller tracks.Comparing manufacturing by stamping and welding,the percentage of reduction of tube radius is increased from 35% to more than 60%,the processing number is decreased from 26 to 2,therefore,the cost of production reduces and productivity increases remarkably. |
| |
| Keywords: | spinning exhausted pipe offset tube oblique tube processing parameter |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
