首页 | 本学科首页   官方微博 | 高级检索  
     

La2O3对激光熔覆铁基合金层硬度及其分布的影响
引用本文:赵高敏,王昆林,刘家浚. La2O3对激光熔覆铁基合金层硬度及其分布的影响[J]. 金属学报, 2004, 40(10): 1115-1120
作者姓名:赵高敏  王昆林  刘家浚
作者单位:清华大学机械工程系,北京,100084
基金项目:清华大学基础研究基金资助项目Jc2001012
摘    要:通过扫描电镜(SEM)研究了稀土氧化物La2O3对铁基合金激光熔覆层组织形貌的影响,用纳米硬度探针测定了熔覆层与基体界面附近和搭接区的硬度和弹性模量,并用MT3型显微硬度计测试了多道熔覆层硬度的面分布.结果表明,稀土的加入细化了晶粒,减小了二次枝晶间距;近界面和搭接区的纳米硬度和弹性模量有不同程度的提高.硬度面分布测量结果表明,加入稀土后熔覆层的平均硬度(HV)约为500,比未加稀土的提高约50,本文还讨论了稀土作用的机理。

关 键 词:激光熔覆 稀土 弹性模量 纳米硬度
文章编号:0412-1961(2004)10-1115-06
收稿时间:2003-11-13
修稿时间:2004-03-14

Effect of La2O3 on Hardness Distributions of Laser Clad Ferrite--Based
ZHAO Gaomin,WANG Kunlin,LIU Jiajun. Effect of La2O3 on Hardness Distributions of Laser Clad Ferrite--Based[J]. Acta Metallurgica Sinica, 2004, 40(10): 1115-1120
Authors:ZHAO Gaomin  WANG Kunlin  LIU Jiajun
Affiliation:Department of Mechanical Engineering, Tsinghua University, Beijing 100084
Abstract:The morphologies of laser clad ferrite-based alloy coatings with different contents of rare earth (RE) were observed by SEM. The nanohardness and the elastic modulus of the near the surface and overlapping area were tested by nanoindentation. The hardness distribution in the coating was measured by microhardness tester. The experimental results show that the microstructure of the coatings with RE was refined, the spacing of second dendrites was reduced, and spacing the nanohardness and elastic modulus were increased. The average hardness (HV) of the coating with RE is about 500, which is 50 higher than that without RE. The mechanism of the RE effect was discussed.
Keywords:laser cladding   rare earth   elastic modulus   nanohardness
本文献已被 CNKI 维普 万方数据 等数据库收录!
点击此处可从《金属学报》浏览原始摘要信息
点击此处可从《金属学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号