首页 | 本学科首页   官方微博 | 高级检索  
     

液态浸渗后直接挤压铝基复合材料的组织特征
引用本文:胡连喜,罗守靖.液态浸渗后直接挤压铝基复合材料的组织特征[J].特种铸造及有色合金,1996(1):1-3.
作者姓名:胡连喜  罗守靖
作者单位:哈尔滨工业大学
摘    要:实验研究了液态浸渗后直接挤压工艺制备的氧化铝短纤维增强铝基复合材料(Al2O3sf/Al)的组织。发现其主要组织特征为:基体致密,为均匀细小的变形再结晶组织;纤维分布均匀,不存在相互搭桥、缠结和成束聚集现象;纤维保留了较大的长径比,其平均长径比大于临界长径比,能起到较好的增强承载作用。表明液态浸渗后直接挤压工艺具有消除缺陷、强化基体、改善纤维分布并避免纤维在成形过程中的破断与损伤等诸多优点。

关 键 词:液态浸渗,挤压,氧化铝纤维,铝基复合材料,显微组织

Microstructure Features of Al_2O_3sf/Al Composites Infiltrated Liquidly and Extruded Directly
Hu Lianxi,Luo Shoujing,Yang Yiwen.Microstructure Features of Al_2O_3sf/Al Composites Infiltrated Liquidly and Extruded Directly[J].Special Casting & Nonferrous Alloys,1996(1):1-3.
Authors:Hu Lianxi  Luo Shoujing  Yang Yiwen
Affiliation:Harbin Institute of Technology
Abstract:The microstructure of Al-base composites reinforced by Al2O3 short fiber (Al2O3sf/Al), manufactrued by a technique of infiltrating liquidly and extruding directly, was investigated. The mi crostructure features of the composites lie mainly in the dense matrix (uniform and fine grains deformed and recrystallized), the fiber well-distributed,(no-bridging no-tangling and no-bunching), the high as pect ratio of fiber (with the average higher than the critical) and a good reinforcing effect. The results show that this technique has many advantages such as eliminating defects, reinforcing matrix, improving fiber distribution and preventing fracture and injure of the fiber.
Keywords:Infiltrating Liquidly  Extrusion  Al2O3 Fiber  Al-base Composites  Microstructure
本文献已被 CNKI 维普 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号