| O形橡胶密封圈应力与接触压力的有限元分析 |
| |
| 引用本文： | 周志鸿,张康雷,李静,许同乐.O形橡胶密封圈应力与接触压力的有限元分析[J].润滑与密封,2006(4):86-89. |
| |
| 作者姓名： | 周志鸿 张康雷 李静 许同乐 |
| |
| 作者单位： | 1. 北京科技大学,北京,100083
2. 山东理工大学机械学院,山东,淄博,255049 |
| |
| 摘 要： | 利用大型有限元软件ANSYS对O形橡胶密封圈在不同压缩率和油压下的变形与受力情况进行了分析研究,得出了相应情况下范.米塞斯(Von M ises)应力分布及接触压力与最大接触压力的变化关系。结果表明:随着油压的增加,范.米塞斯(Von M ises)应力相应增加,且应力峰区也相应改变,说明O形圈可能出现裂纹的位置是随着油压而变化的;O形橡胶密封圈与轴之间的最大接触压力随着压缩率、油压的增加而增加,在不同油压作用下,最大接触压力始终大于油压,满足O形圈的密封条件。
|
| 关 键 词： | O形橡胶密封圈 应力 接触压力 有限元分析 |
| 文章编号： | 0254-0150(2006)4-086-4 |
| 收稿时间： | 2005-06-20 |
| 修稿时间： | 2005年6月20日 |
Finite Element Analysis of Stress and Contact Pressure on the Rubber Sealing O-ring |
| |
| Zhou Zhihong,Zhang Kanglei,Li Jing,Xu Tongle.Finite Element Analysis of Stress and Contact Pressure on the Rubber Sealing O-ring[J].Lubrication Engineering,2006(4):86-89. |
| |
| Authors: | Zhou Zhihong Zhang Kanglei Li Jing Xu Tongle |
| |
| Abstract: | Deformation and Load of the rubber sealing O-ring in different compressing rate and different oil pressure were analyzed by using finite element analysis software ANSYS,the distribution nephogram of Von Mises stress and the change of contact pressure and the maximal contact pressure were obtained.Results show that with the increase of oil pressure,Von Mises stress increases correspondingly.The changes of Von Mises stress peak district indicate that the position of the crack possible produced on.The maximal pressure between the rubber sealing O-ring and the shaft increases with the increase of compressing rate and oil pressure.Under different oil pressure,the maximal contact pressure is always greater than the oil pressure,which meets the need of O-ring sealing. |
| |
| Keywords: | rubber sealing O-ring stress contact pressure finite element analysis |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《润滑与密封》浏览原始摘要信息 |
|
点击此处可从《润滑与密封》下载全文 |
|
