| 斜向插削变齿厚内齿轮加工方法的研究 |
| |
| 引用本文： | 毛建忠,李华敏,吴智铭.斜向插削变齿厚内齿轮加工方法的研究[J].机械工程学报,1996(2). |
| |
| 作者姓名： | 毛建忠 李华敏 吴智铭 |
| |
| 作者单位： | 上海交通大学，哈尔滨工业大学 |
| |
| 摘 要： | 提出了变齿厚内齿轮的一种近似加工方法－－斜向插削法。在建立齿廓曲面方程的基础上，对这种加工方法引起的齿形误差和分度圆压力角变化进行了研究，探讨了刀具不同的相对斜插角对内齿轮齿厚的影响，以齿形误差最小和保证内齿轮为鼓形齿的原则优化了刀具相对斜插角，并且进行了试验研究。理论分析和试验结果都责明在齿轮倾斜角小于１２°时，斜向插削工艺是变齿厚内齿轮的一种非常有效的加工方法。
|
| 关 键 词： | 变齿厚内齿轮，斜向插削工艺，齿形误差 |
STUDY ON THE METHOD OF MANUFACTURING INTERNAL BEV0LOID GEAR USING BEVELSLOTTING TECHNOLOGY |
| |
| Mao Jianzhong.STUDY ON THE METHOD OF MANUFACTURING INTERNAL BEV0LOID GEAR USING BEVELSLOTTING TECHNOLOGY[J].Chinese Journal of Mechanical Engineering,1996(2). |
| |
| Authors: | Mao Jianzhong |
| |
| Affiliation: | Mao Jianzhong(Shanghai Jiaotong University) Li Huaming (Harbin Institute of Technology) Wu Zhiming(Shanghai Jiaotong University) |
| |
| Abstract: | Presents an approximate method of manufacturing internal bevoloid gear usingLevel slotting technology. On the basis of deriving its profile surface equations, analysesthe change of transverse pressure angle and the tooth form error caused by this manufa-cturing methed, probes into the infiuence of the relative bevel angle in which theworkpiece is machined upon thinning of tooth thickness, optimizes the relative bevelangle with the aim of crowning tooth and minimizing tooth form error. Theoreticalanalysis and experiment result both show that the bevel slotting technology is aneffective method of manufacturing internal bevoloid gear when its bevel angle is lessthan 12. |
| |
| Keywords: | Internal bevoloid gear Bevel slotting technology Tooth form error |
| 本文献已被 CNKI 等数据库收录！ |
