| 20Cr1Mo1VTiB钢的连续冷却转变行为 |
| |
| 引用本文： | 李兴东,李岩,艾迪,李宇峰,刘瑞良.20Cr1Mo1VTiB钢的连续冷却转变行为[J].机械工程材料,2021,45(2):31-36,89. |
| |
| 作者姓名： | 李兴东 李岩 艾迪 李宇峰 刘瑞良 |
| |
| 作者单位： | 上海航空材料结构检测股份有限公司,上海 201318;哈尔滨电气集团有限责任公司研究院,哈尔滨 150028;哈尔滨汽轮机厂有限责任公司,哈尔滨 150046;哈尔滨汽轮机厂有限责任公司,哈尔滨 150046;哈尔滨工程大学材料科学与化学工程学院,超轻材料与表面技术教育部重点实验室,哈尔滨 150001 |
| |
| 摘 要： | 采用热膨胀仪测定20Cr1MolVTiB钢在不同淬火温度(9501100℃)下的贝氏体转变点和较佳淬火温度下的连续冷却相变点,结合组织观察和硬度测试绘制连续冷却转变曲线;利用经验公式建立相变点和相转变量与冷却速率的关系,并计算相变激活能。结果表明:随着淬火温度升高,试验钢中贝氏体转变温度降低,较佳淬火温度为1050℃;冷却速率不高于0.5℃·s-1时,过冷奥氏体转变产物为先共析铁素体、珠光体和贝氏体,冷却速率超过0.5℃·s-1时则为单一贝氏体;相变点-冷却速率和相转变量-冷却速率拟合曲线与试验结果吻合较好,先共析铁素体和贝氏体相变激活能分别为744.8,274.9 kJ·mol-1。
|
| 关 键 词： | 20Cr1Mo1VTiB钢 CCT曲线 显微组织 相变激活能 |
Continuous Cooling Transformation Behaviour of 20Cr1Mo1VTiB Steel |
| |
| LI Xingdong,LI Yan,AI Di,LI Yufeng,LIU Ruiliang.Continuous Cooling Transformation Behaviour of 20Cr1Mo1VTiB Steel[J].Materials For Mechanical Engineering,2021,45(2):31-36,89. |
| |
| Authors: | LI Xingdong LI Yan AI Di LI Yufeng LIU Ruiliang |
| |
| Affiliation: | (Shanghai Aeronautical Materials&Structures Testing Co.,Ltd.,Shanghai 201318,China;Research Institute of Harbin Electric Corporation,Harbin 150028,China;Harbin Turbine Company Limited,Harbin 150046,China;Key Laboratory of Superlight Material and Surface Technology of Ministry of Education,College of Science and Chemical Engineering,Harbin Engineering University,Harbin 150001,China) |
| |
| Abstract: | The bainite transformation point at different quenching temperatures(950-1100℃)and the continuous cooling phase transformation point at the optimal quenching temperature of 20 CrlMolVTiB steel were measured on a thermal dilatometer.Then the continuous cooling transformation curves were drawn by combination of the phase transformation points,microstructure observation and hardness test.The relationship between the phase transformation point or transformation amount and the cooling rate was established with empirical equations,and the phase transition activation energy was calculated.The results show that the bainite transformation temperature of the test steel decreased with increasing quenching temperature;the preferred quenching temperature was 1050℃.The supercooled austenite transformation products were proeutectoid ferrite,pearlite and bainite with cooling rates not higher than 0.5℃·s-1,and were single bainite with cooling rates higher than 0.5℃·s-1.The fitting curves of phase transformation point-and phase transformation amount-cooling rate were in good agreement with the test results.The activation energy of proeutectoid ferrite and bainite transition was 744.8,274.9 kJ·mol-1,respectively. |
| |
| Keywords: | 20Cr1Mo1VTiB steel CCT curve microstructure phase transition activation energy |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
