| 基于行波法的段塞流瞬态捕捉模型建立与验证 |
| |
| 引用本文： | 王冬旭,胡其会,李玉星,李爽,王权. 基于行波法的段塞流瞬态捕捉模型建立与验证[J]. 化工进展, 2020, 39(8): 2998-3006. DOI: 10.16085/j.issn.1000-6613.2019-1861 |
| |
| 作者姓名： | 王冬旭 胡其会 李玉星 李爽 王权 |
| |
| 作者单位： | 1.中国石油大学（华东），山东省油气储运安全省级重点实验室，山东 青岛 266580;2.中国市政工程中南设计研究总院有限公司，湖北 武汉 430060 |
| |
| 基金项目： | 国家自然科学基金;国家重点研发计划 |
| |
| 摘 要： | 气液两相流中，准确预测段塞流的特征参数具有重要的现实意义。Renault模型是基于非黏性Kelvin-Helmholtz（IKH）稳定性准则与黏性Kelvin-Helmholtz（VKH）稳定性准则建立的能够捕捉段塞前后界面运动的双流体模型，但该模型在液相单元格之间采用Riemann精确解，求解速度较慢。为简化计算，本文将行波法引入到Renault模型的液相方程求解过程，并对可能出现的干区用薄液膜代替，使行波法适用于所有计算单元，在保证模型精度的条件下，极大地提高了计算速度，运算时间相比Renault模型平均减少28%。对比本模型计算结果与室内小型环道实验数据，持液率与实测结果相一致，压降、段塞长度计算相对误差分别在25%、30%以内，且主要分布在20%以内。说明本文改进的瞬态段塞流模型具备运算快速、计算精度较高的特点，具有一定的工程应用价值。
|
| 关 键 词： | 气液两相流 模型 行波法 段塞流 水力计算 |
Development and verification of the transient capture model of slug flow based on the traveling wave method |
| |
| WANG Dongxu,HU Qihui,LI Yuxing,LI Shuang,WANG Quan. Development and verification of the transient capture model of slug flow based on the traveling wave method[J]. Chemical Industry and Engineering Progress, 2020, 39(8): 2998-3006. DOI: 10.16085/j.issn.1000-6613.2019-1861 |
| |
| Authors: | WANG Dongxu HU Qihui LI Yuxing LI Shuang WANG Quan |
| |
| Affiliation: | 1.Provincial Key Laboratory of Oil and Gas Storage and Transportation Security, China University of Petroleum (East China), Qingdao 266580, Shandong, China
2.Central and Southern China Municipal Engineering Design & Research Institute, Wuhan 430060, Hubei, China |
| |
| Abstract: | It is of great practical significance to accurately predict the characteristic parameters of slug flow in gas-liquid two-phase flow. The Renault model is a two-fluid model based on the non-viscous Kelvin-Helmholtz stability criterion and the viscous Kelvin-Helmholtz stability criterion, which can capture the interface movement of the slug front and rear. However, this model uses Riemann precise solution between liquid phase cells and the solution speed is slow. In order to simplify the calculation, the traveling wave method was introduced into the solution process of the liquid phase equation in the Renault model, and the possible dry areas were replaced with thin liquid film, making the traveling wave method applicable to all computing units. Under the condition of ensuring the accuracy of the model, the calculation speed was greatly improved, and the operation time was reduced by 28% on average compared with the Renault model. By comparing the calculation results of this model with the data of indoor small-scale loop experiment, the liquid holding rate is consistent with the measured results. The relative errors of pressure drop and slug length calculation are respectively within 25% and 30%, and the main distribution is within 20%. It shows that the improved transient slug flow model has the characteristics of fast calculation and high calculation accuracy, and has certain engineering application value. |
| |
| Keywords: | gas-liquid two-phase flow model traveling wave method slug flow hydraulic calculation |
| 本文献已被 万方数据 等数据库收录！ |
| 点击此处可从《化工进展》浏览原始摘要信息 |
|
点击此处可从《化工进展》下载免费的PDF全文 |
|
