| 氧化时间对低合金弹簧钢奥氏体晶粒度测定的影响 |
| |
| 引用本文： | 陈继平,张乐,邢献强,孙国庆,钱健清. 氧化时间对低合金弹簧钢奥氏体晶粒度测定的影响[J]. 金属热处理, 2021, 46(8): 241-245. DOI: 10.13251/j.issn.0254-6051.2021.08.046 |
| |
| 作者姓名： | 陈继平 张乐 邢献强 孙国庆 钱健清 |
| |
| 作者单位： | 1.安徽工业大学 冶金工程学院, 安徽 马鞍山 243032;2.中钢集团郑州金属制品研究院有限公司, 河南 郑州 450001 |
| |
| 基金项目： | 安徽省自然科学基金(1508085ME78) |
| |
| 摘 要： | 氧化法可用于钢中晶粒度的测定.研究控制氧化时间对弹簧钢50CrV奥氏体晶粒度的影响.结果发现,氧化过程大致分为3个阶段:第一阶段,过剩铁素体相不断转变为奥氏体;第二阶段,基体与氧化膜之间的阴阳离子再次加快扩散,下层金属基体继续氧化脱碳,部分之前试样表面的奥氏体晶界被替代;第三阶段,一、二阶段的奥氏体晶粒逐渐长大,新旧氧...
|
| 关 键 词： | 氧化法 晶粒度 弹簧钢 氧化过程 |
| 收稿时间： | 2021-03-26 |
Effect of oxidation time on evaluation of austenite grain size of low alloy spring steel |
| |
| Chen Jiping,Zhang Le,Xing Xianqiang,Sun Guoqing,Qian Jianqing. Effect of oxidation time on evaluation of austenite grain size of low alloy spring steel[J]. Heat Treatment of Metals, 2021, 46(8): 241-245. DOI: 10.13251/j.issn.0254-6051.2021.08.046 |
| |
| Authors: | Chen Jiping Zhang Le Xing Xianqiang Sun Guoqing Qian Jianqing |
| |
| Affiliation: | 1. School of Metallurgical Engineering, Anhui University of Technology, Ma'anshan Anhui 243032, China;2. Sinosteel Zhengzhou Research Institute of Steel Wire Products Co., Ltd., Zhengzhou Henan 450001, China |
| |
| Abstract: | Oxidation method can be used to determine the grain size of steel. The effect of oxidation time on the evaluation of the austenite grain size of spring steel 50CrV was studied. It was found that the oxidation process can be divided into three stages. In the first stage, the excess ferrite phase is continuously transformed into austenite. In the second stage, the diffusion of anions and cations between the substrate and the oxide film is accelerated again, and the underlying metal substrate continues to oxidize and decarburize, and part of the austenite grain boundary on the surface of specimen is replaced. In the third stage, the austenite grains in the first and second stages gradually grow, and the old and new oxide films are superimposed to grow, which are verified in 55SiCr, 60Si2Mn and 65Si2CrV steels. Without affecting the accuracy of the test results, the oxidation time can be shortened from the standard 60 min to about half, and then the grain size can be obtained by modification, which is close to 11.00 grade of direct corrosion method and 11.09 grade of hydrogen induced intergranular fracture. |
| |
| Keywords: | oxidation method grain size spring steel oxidation process |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《金属热处理》浏览原始摘要信息 |
|
点击此处可从《金属热处理》下载免费的PDF全文 |
|
