Nonuniform sequential sampling for signal analysis

New electronic technologies for signal analysis raise the possibility of sampling very rapidly, with a time-varying density, and determining empirically both the sampling rate and the window width as the signal evolves in time. These opportunities also point to the possibility of sequentially sampling in a time-varying way in more traditional problems. Motivated by these ideas, we establish a sampling formula, valid in cases where both sampling rate and window width may be varied. The formula states that, in terms of the ways in which these quantities should alter with time, optimal performance is achieved when the window width is inversely proportional to squared sampling rate, and sampling rate is directly proportional to squared bias.     

Nonuniform sampling of bandlimited modulated signals

In this paper it is shown that an unequally spaced sampling can be implemented on the base of sinc-composition function usually used in the uniform sampling expansion. The nonuniform sampler is based on a level crossing detector (LCD) which produces a sample of carrier whenever the integral of modulating function crosses a threshold level. The information about the modulated signal is contained in the carrier samples taken at the instants which are defined by modulating function. The Riemann-Stieltjes uniform integral sum representation of the Fourier transform of signal is used as a mathematical base for the derivation of the principal results. In the particular case of the representation of single-valued real positive function, the suggested method leads to the signal representation by the equally weighted sampling at the nonuniformly distributed instants. The error estimation and numerical example illustrating the methods are given.     

Optimization techniques for antenna arrays

Various techniques for optimizing the performance indices of antenna arrays are discussed. In particular, methods for maximizing array directivity and signal-to-noise power ratio are reviewed. These performance indices are expressible as a ratio of two Hermitian forms, which has a certain special property to enable the facile determination of both its maximum value and the conditions under which this maximum is attained. Special maximization procedures by excitation amplitude and phase adjustments, by spacing perturbation, by phase adjustments only, and by a coordinate transformation with constraints on the array pattern are examined. For wire antennas the method of moments using a subsectioning technique can be applied to obtain numerical answers which include mutual-coupling effects. Methods for considering large arrays and for the maximization of power gain are indicated.     

Photonic systems for antenna applications

For well over a decade, research groups around the world have been investigating photonic devices for use in antenna, phased-array, and electromagnetic-field-sensor systems. Proposed applications include EMC monitoring, EMP measurements, anechoic-chamber calibration, novel antenna and array designs, remotely located antennas, and smart skins. Photonic antenna links allow immunity from electromagnetic interference, provide an extremely wide working bandwidth, and allow long cable runs with a minimum of loss. Developments in laser technology allow photonic-based links to have very low noise figures and high dynamic range. Opto-electronic devices are now being built in III-V semiconductors (GaAs, InP), which will ultimately lead to opto-electronic integration with MMIC devices. Photonic systems will revolutionize the way in which electromagnetic-measurement and antenna systems will be designed and built in the future. The paper presents an introduction to the types of photonic links and modulator systems available to the antenna engineer     

Nonuniform sampling and antialiasing in image representation

A unified approach to the representation and processing of a class of images which are not bandlimited but belong to the space of locally bandlimited signals is presented. A nonuniform sampling theorem (Clark et al, 1985) for functions belonging to this space is extended, and a class of nonstationary stochastic processes is considered. The space of locally bandlimited signals is shown to be a reproducing-kernel space. A generalized projection theorem can therefore be applied, yielding either a continuous or a discrete projection filter. The former can be used for image conditioning prior to nonuniform sampling, while the latter provides a general tool for image representation by nonuniform sampling schemes. The problem of finding the local bandwidth of a given signal, in order to generate an optimal sampling scheme, is addressed in the context of signal representation in the combined position-frequency space. The stochastic estimation of parameters which characterize the local bandwidth is discussed. Bounds on the error resulting from the utilization of nonexact position-varying signal parameters are derived     

High frequency techniques for antenna analysis

A summary of various high-frequency techniques is presented for analyzing the electromagnetic radiation from antennas in the presence of their host environment. These techniques provide physical insight into antenna radiation mechanisms and are found to be highly efficient and accurate for treating a variety of practical antenna configurations. Examples to which these techniques have been applied include open-ended waveguide antennas, horn and reflector antennas, and antennas on aircraft and spacecraft. The accuracy of these techniques is established via numerical results which are compared with those based on other independent methods or with measurements. These high frequency methods can be combined with other techniques, through a hybrid scheme, to solve an even greater class of problems than those which can be solved in an efficient and tractable manner by any one technique alone     

Tuning techniques for planar inverted-F antenna

User terminals of modern mobile communication systems require efficient, low profile antennas, capable of broadband and multi-band operation. In that respect, planar inverted-F antenna (PIFA) designs have emerged that explore the trade-off between the height above the ground-plane and the achievable effective bandwidth. Further possible bandwidth enhancements are studied, as is multi-band operation by switching and tuning the resonant frequency of the PIFA, while maintaining a low height above the ground plane     

多频共面波导馈电平面开式套简天线研究

提出了一种同时支持诸多频带工作的共面波导馈电平面开式套筒天线.共面波导中心金属导带以及接地板均采用渐变的形状,天线采用开式套筒结构,并加入了一个倒L型寄生贴片,以最大程度地展宽天线带宽.与以往所提出的共面波导馈电天线相比,此天线具有尺寸小,覆盖更宽的频带,可同时支持个人通信系统(PCS),宽带码分多址系统(WCDMA)...     

Miniaturised microstrip antenna for MMIC applications

A novel miniaturised quarter wavelength, H-shaped antenna which will find applications in monolithic microwave integrated circuit (MMIC) design is presented. The antenna occupies approximately one tenth of the substrate area of a half wavelength patch antenna. The effect on the resonance frequency, bandwidth and gain of the antenna are reported     

A compact antenna for ultrawide-band applications

A novel compact and ultrawide-band (UWB) antenna is presented in this paper. The basis for achieving such an UWB operation is through proper magnetic coupling of two adjacent sectorial loop antennas in a symmetrical arrangement. A large number of coupled sectorial loop antennas (CSLA) with different geometrical parameters are fabricated and their measured responses are used to experimentally optimize the geometrical parameters of the antenna for achieving the maximum bandwidth. Through this optimization process an antenna with a VSWR of lower than 2.2 (S/sub 11/<-8.5 dB) across an 8.5:1 frequency range is designed. The maximum dimension of this antenna is smaller than 0.37/spl lambda//sub 0/ at the lowest frequency of operation and provides an excellent polarization purity. Furthermore, the antenna exhibits a relatively consistent radiation pattern. Modified versions of the CSLA are also designed to reduce the overall metallic surface and weight of the antenna while maintaining its wide-band characteristics. This allows modifying its dimensions to design low frequency light-weight UWB antennas.     

Nonuniform sampling theorems for bandpass signals at or below theNyquist density

In this paper, the problem of recovery of bandpass signals from a set of nonuniform samples is discussed. Interpolation formulas for particular sets of irregular samples are given. Issues such as the Nyquist rate are studied, and practical methods for sampling and recovery are suggested     

CLIP antenna for wireless bluetooth applications

In this paper, a novel design for a coplanar waveguide antenna is developed that consists of two U-shaped slots. The antenna is named CLIP. The antenna was designed for a central frequency of 2.4 GHz, with an input impedance of 50 /spl Omega/. The antenna dimensions represent a 72% size reduction compared to a conventional microstrip rectangular-patch antenna. The measured antenna bandwidth was about 11%, while its gain was about 17 dB. These values are fairly acceptable in all wireless communication systems. The antenna configuration has a bidirectional radiation pattern, while a unidirectional radiation pattern was achieved by using a /spl lambda//sub 0//4 reflector with a metal plate. A 2/spl times/2 multi-element sub array was implemented to widen the application area. The mutual coupling between adjacent elements was low. Orthogonal-plane coupling between adjacent elements was introduced to increase the reduction in the mutual coupling. The mutual coupling level was reduced to less than -23 dB in all coupling planes. The CLIP antenna element and arrays were fabricated. Experimental measurements showed very good performance, which agreed well with simulation results.     

Wideband compact antenna for K-band applications

A compact coupled microwave active antenna is presented. This antenna is proximity fed, and consists of a square radiating element array on a polymer dielectric layer. The compactness of the antenna is obtained through technological optical processes and the parasitic patch phenomenon which increases the bandwidth     

Compact uniplanar antenna for WLAN applications

A compact dual-band uniplanar antenna for operation in the 2.4/5.2/5.8 GHz WLAN/HIPERLAN2 communication bands is presented. The dual-band antenna is obtained by modifying one of the lateral strips of a slot line, thereby producing two different current paths. The antenna occupies a very small area of 14.5times16.6 mm² including the ground plane on a substrate having dielectric constant 4.4 and thickness 1.6 mm at 2.2 GHz. The antenna resonates with two bands from 2.2 to 2.52 GHz and from 5 to 10 GHz with good matching, good radiation characteristics and moderate gain     

Novel coordinate transformations for antenna applications

Coordinate transformations commonly encountered in antenna design and analysis are presented. The introduction of a new coordinate system, polarization coordinates, enables one to construct a complete flowchart which can be used to express any coordinate transformation matrix more directly and explicitly without going through the usual step-by-step derivation. Consequently, the computation procedure can often be greatly reduced by avoiding tedious manipulations.     

A novel antenna for ultra-wide-band applications

An ultra-wideband antenna based on a slotline feed structure, a bowtie horn, and a rolled edge termination was developed, analyzed, and measured. Empirical data showed that its beamwidths and bandwidth are dependent on its physical dimensions which are easily controllable by an antenna designer. Measured patterns of models with various radiation properties are shown to substantiate these design rules. A flat plateau-like main beam, low voltage standing-wave ratio (VSWR), the ability to produce both wide (60°) and narrow (30°) half-power beamwidths, low sidelobes and backlobe (40-50 dB down), low cross-polarized levels (20-25 dB down), and independent control of E- and H-plane beamwidths over an ultra-wide bandwidth, say 2-18 GHz, are some of the strong points of this antenna type     

Wideband monopole antenna for DVB-T applications

A novel asymmetric fork-like monopole antenna for digital video broadcasting-terrestrial (DVB-T) signal reception for application in the UHF band is presented. The proposed antenna consists of two two-branch strip monopoles on a rectangular ground plane with a concave. The concavity in the ground pattern serves as an effective means for the gap between the radiating element and the ground plane for impedance matching. The influence of various parameters on antenna characteristics has been investigated. Results show a wide bandwidth of 461 MHz (451?912 MHz) or 70% of DVB-T centred frequency (655 MHz). The proposed antenna has omnidirectional radiation patterns in the yz-plane. Details of the proposed antenna design and experimental results of the constructed prototypes are presented.     

Nonuniform transmission line codirectional couplers for hybridMIMIC and superconductive applications

A new design approach for thin-film codirectional quadrature couplers and their applications is described. An in-depth analysis and semi-empirical design curves are presented for these couplers. Forward-wave coupling is achieved by making use of the difference between even- and odd-mode phase velocities. Modified nonuniform codirectional couplers with a dummy channel for continuously decreasing or increasing taper and employing wiggly, serpentined and smooth coupled edges have been designed and tested. It is found that a wiggly coupler can achieve a 50% length reduction compared to a smooth-edge coupler. A further 60% length reduction compared to a wiggly coupler is achieved by a serpentine coupler. Coupler performance for wiggly and serpentined configurations is computed by choosing a realizable phase velocity function for a given coupler length. Either constant 90° or -90° phase shift is possible with these couplers giving significant design flexibility in some applications. The results for a K_u-band Σ-Δ magic-T circuit employing a 0 dB wiggly coupler and a -3 dB smooth-edge coupler are also presented in the paper     

Nonuniform sampling for random signals bandlimited in the linear canonical transform domain

Multidimensional Systems and Signal Processing - In this paper, we mainly investigate the nonuniform sampling for random signals which are bandlimited in the linear canonical transform (LCT)...     

Nonuniform sampling theorems for random signals in the linear canonical transform domain

Nonuniform sampling can be encountered in various practical processes because of random events or poor timebase. The analysis and applications of the nonuniform sampling for deterministic signals related to the linear canonical transform (LCT) have been well considered and researched, but up to now no papers have been published regarding the various nonuniform sampling theorems for random signals related to the LCT. The aim of this article is to explore the nonuniform sampling and reconstruction of random signals associated with the LCT. First, some special nonuniform sampling models are briefly introduced. Second, based on these models, some reconstruction theorems for random signals from various nonuniform samples associated with the LCT have been derived. Finally, the simulation results are made to prove the accuracy of the sampling theorems. In addition, the latent real practices of the nonuniform sampling for random signals have been also discussed.