共查询到19条相似文献,搜索用时 203 毫秒
1.
提高发电机内冷水水质指标的措施 总被引:3,自引:0,他引:3
华能岳阳电厂曾发生发电机线棒烧损的事故,发电机内冷水的水质控制不当是引发该事故的主要因素之一。一般电厂均采用安装内冷水小混床来保证水质指标符合国家标准(pH>6.8、电导率<2μS/cm、铜的质量浓度<40μg/L)。但小混床运行周期短、再生度达不到运行要求、运行费用高。华能南京电厂内冷水水质的pH值或铜的质量浓度严重超标,但改造方案中没有加装小混床,而是在内冷水系统中添加碱性介质,使内冷水调整至碱性工况下运行,以降低内冷水的含侗量。该项改造工程历经三个阶段才完成。改造后的内冷水各项运行水质均符合国家标准。 相似文献
2.
3.
4.
5.
6.
超净化处理系统在定子冷却水系统中的应用 总被引:2,自引:0,他引:2
发电机定子冷却水长期采用小混床 间断换水处理的运行方式时,pH经常小于7.0,铜离子含量大多数时间大于40μg/L,不能满足DL/T801-2002要求。采用定冷水超净化处理系统后,定冷水水质明显改善:电导率0.1μS/cm-μS/cm,pH7.2~7.8,铜离子小于40μg/L。 相似文献
7.
8.
福建大唐国际宁德发电公司2×600 MW机组投产以来,发电机定冷水pH和含铜量经常不合格,为此化学专业人员对4号发电机定冷水的处理方式不断探索改进,从最初使用美国MR450型定冷水处理系统专用树脂,到使用自己处理、配比的出水高pH的混合树脂,以及使用华北电力科学研究院研制开发的NLS-01型发电机定冷水的优化调节装置,定冷水水质不断提高,pH、电导率、含铜量全部达到了电力行业标准的要求。 相似文献
9.
10.
通过对某电厂4台发电机定冷水箱补水水源及定冷水处理方法的介绍、对发电机定冷水指标间相互关系的论述,对比分析了3种不同的水质处理手段(特种混床法、超净化+碱法和离子交换+充氮密封法)在现场的实际运用情况。指出了目前电厂存在着标准更新缓慢、水质处理方法选择不佳、仪表测量准确性不足、指标重视程度不够、定冷水系统运行维护和发电机停备用保护欠妥等方面的问题,从而造成了定冷水p H值和铜含量指标间断性不合格,排污、换水操作频繁,增大环保压力与经济损失的同时,也给发电机的安全运行带来了风险。本文可为今后电厂选择定冷水处理技术,制定相关维护措施提供参考。 相似文献
11.
12.
13.
文章介绍了南通天生港发电有限公司1号机组10号槽静子线棒温度高的原因及处理的方法。通过对SZSY-2定冷水处理装置的使用情况介绍,叙述了应用该装置后,内冷水水质达到规定的水质标准要求,并大幅度降低了发电机铜线棒的腐蚀速度。 相似文献
14.
发电机内冷却水(内冷水)系统腐蚀及腐蚀产物沉积所引起的绝缘性能与通流冷却能力下降,是发电机运行的重要安全隐患。某发电厂发电机内冷水系统出现堵塞、超温异常,其腐蚀产物中单质铜含量高。为消除隐患,首次采用以氨基磺酸为主的复合酸并添加双氧水作为清洗介质,辅以分步去除氧化铜和单质铜的工艺,对该发电机内冷水系统实施了化学清洗。结果表明,所采用的清洗工艺技术有效去除了线棒内的腐蚀产物,且对线棒本体损伤较小;与清洗前相比,清洗后定子线棒最高温度下降了9.9 ℃,线棒间最大温差下降了10 ℃,不同线棒间出水最大温差下降了11 ℃,确保了发电机安全经济运行。 相似文献
15.
16.
简要阐述了发电机内冷水铜导线腐蚀机理,介绍了BF-2铜缓蚀剂在发电机内冷水防腐中的工业应用经验. 相似文献
17.
18.
19.
G. V. Ledukhovsky Yu. E. Barochkin V. P. Zhukov V. N. Vinogradov I. A. Shatova 《Thermal Engineering》2018,65(10):751-755
Results of experimental investigations performed on 210–1200 MWel. power units at thermal and nuclear power stations yielded a statistical correlation of the corrosion rate for cooled copper conductors in water-cooling systems of the stator winding in a hydrogen-water cooled generator vs. cooling water quality characteristics, such as electrical conductivity, pH, and dissolved oxygen content. The content of dissolved oxygen in the cooling water is found to have a pronounced effect on the efficiency of corrosion protection of system elements. An engineering solution is proposed. It calls for installation of a small cavitation deaerator operating on superheated water in the cooling water return pipeline from the turbogenerator stator winding to a vacuum tank from which steam is removed by the main ejector of the turbine unit condenser or the deaerator’s own ejector. Special experimental investigations allowed the determination of the water deaeration efficiency in deaerators of the considered type. It is described by a dependence of a relative decrease in the content by weight of oxygen dissolved in the deaerated water on the water overheating at the deaerator inlet with reference to saturation temperature corresponding to the pressure in the steam suction pipeline. It was established by calculations that the proposed engineering solution decreased the corrosion rate of copper conductors in water-cooling systems of the stator winding, on average, by a factor of 2.1. Results of this investigation can be used in designing new power facilities or retrofitting process systems of operating hydrogen-water cooled turbogenerators. 相似文献