Decoherence in grazing scattering of fast H and He atoms from a LiF(001) surface

The influence of decoherence on the diffraction during grazing scattering of fast hydrogen and helium atoms from a LiF(001) single crystal surface with projectile energies of some keV, is investigated by two-dimensional angular distributions for scattered projectiles in coincidence with their energy loss and emitted electrons from the target surface. For keV hydrogen atoms, we identify the excitations of electrons and excitons of the target surface as the dominant mechanisms for decoherence, whereas for keV helium atoms these contributions are negligibly small. The suppression of electronic excitations owing to the band gap of insulators plays an essential role for preserving quantum coherence and thus for the application of fast atom diffraction as a surface analytical tool.     

Investigations of thin film structures of WO3 and WO3 with Pd for hydrogen detection in a surface acoustic wave sensor system

A single thin film sensor structure of WO₃ (∼ 50 nm) and bilayer sensor structure of WO₃ (∼ 50 nm) with a very thin film of palladium (Pd ∼ 18 nm) on the top, have been studied for hydrogen gas-sensing application at ∼ 30 °C and ∼ 50 °C. The structures were obtained by vacuum deposition (first the WO₃ and than the Pd film) onto a LiNbO₃ Y-cut Z-propagating substrate making use of the surface acoustic wave method and additionally (in this same technological processes) onto a glass substrate with a planar microelectrode array for simultaneously monitoring of the planar resistance of the structure. In the case of a bilayer structure a very good correlation has been observed between these two methods — frequency changes in SAW method correlate very well with decreases of the bilayer structure resistance. These frequency changes are on the level of 2.4 kHz to 4% of hydrogen concentration in dry air, whereas in the case of a single WO₃ structure almost no frequency shift is observed.     

Liquid-phase epitaxy of 2H-SiC film on a (0001) 4H-SiC substrate in Li-Si melt

We first applied a liquid-phase epitaxy (LPE) method to the growth of 2H-SiC to obtain an oriented 2H-SiC layer. The LPE growth was performed on a (0001) 4H-SiC substrate in a Li-Si-C melt at 850 °C. A LPE layer grew on the carbon face of the (0001) 4H-SiC substrate with the area of about 1 × 1 mm². The thickness and morphology of the LPE layer were confirmed by scanning electron microscope (SEM), and the polytype of the LPE layer was determined using a high-resolution transmission electron microscope (HR-TEM) and a Raman spectroscopy. SEM measurements revealed that the thickness of the LPE layer was 50 μm and that this layer developed with a hexagonal shape. HR-TEM observations and Raman spectral analysis showed that 2H-SiC layer grows on 4H-SiC substrate with the relationship of (0001) 2H-SiC (0001) 4H-SiC. In this study, we first succeeded to grow <0001>-axis-oriented 2H-SiC films and concluded that the LPE technique is applicable to the growth of oriented 2H-SiC films in the Li-Si melt.     

Morphological evolution of the poly(3-hexylthiophene)/[6,6]-phenyl-C61-butyric acid methyl ester, oxidation of the silver electrode, and their influences on the performance of inverted polymer solar cells with a sol-gel derived zinc oxide electron selective layer

The inverted polymer solar cell (PSC) based on a sol-gel derived zinc oxide (ZnO) thin film as an electron selective layer is investigated. The device performance is improved after the fabricated device is placed in air for a few days. The improvement is attributed to the self-organization of the poly(3-hexylthiophene)/[6,6]-phenyl-C₆₁-butyric acid methyl ester layer and oxidation of the silver electrode with time, resulting in a significant enhancement in the short circuit current, fill factor and open circuit voltage. The investigation shows that the inverted PSC based on ZnO thin film exhibits a high efficiency of 3.8% on the 6th day after fabrication without the use of poly(3,4-ethylene dioxythiophene):poly(styrene sulfonate) and encapsulation.     

Use of fluorescence to probe the surface dynamics during disorder-to-order transition and cluster formation in dihalonaphthalene-water thin films on Al2O3(0001)

Amorphous dihalonaphthalenes that are prepared by vacuum deposition onto a cold Al₂O₃ surface form electronically excited dimers when optically pumped, and their emission is characteristically red-shifted, broad and featureless compared to the monomeric fluorescence. If the surface is heated, the adlayer undergoes a disorder-to-order transition at a temperature characteristic of the molecule. Since pure crystalline dihalonaphthalenes typically fluoresce and do not exhibit excimeric features, the transition was studied by taking advantage of the changes in the spectral characteristics of the adlayer. These included transmittance, and emission from fluorescence and excimer. The combination of these methods allowed a close look at the surface dynamics of molecules on the surface of Al₂O₃ as the adlayer was heated from the deposition temperature to desorption.If a bilayer is formed by depositing water onto the surface with the organic adlayer on top, water, with its lower desorption energy, can be made to percolate into the organic layer. The optical probes indicate that the water clearly associates with the organic molecules while the excess water desorbs. By varying the coverage of either the water or the dihalonaphthalene, the stoichiometric composition of the cluster can be determined and are reported here.     

Unconventional pairing in doped band insulators on a honeycomb lattice: the role of the disconnected Fermi surface and a possible application to superconducting β-MNCl (M=Hf,Zr)

We investigate the possibility of realizing unconventional superconductivity in doped band insulators on the square and honeycomb lattices. The latter lattice is found to be a good candidate due to the disconnectivity of the Fermi surface. We propose applying the theory to the superconductivity in doped layered nitride β-MNCl (M= Hf, Zr). Finally, we compare two groups of superconductors with disconnected Fermi surface, β-MNCl and the iron pnictides, which have high critical temperature T_c, despite some faults against superconductivity are present.