Personal computer-basedcamac system for data acquisition

A single board auxiliarycamac crate controller for a Z80-A based personal computer ZX-spectrum to drive thecamac crate housing multipleadc, tdc, dac and 16 I/O ports has been developed. Thecamac crate controller used in this system is of A2 type which supports multiple auxiliary crate controllers. Acamac exerciser/training software for the use ofcamac commands in process control as well as data acquisition has been developed.     

Recent advances in open cycle MHD electrical power generation

The report attempts to summarise the recent developments in the field ofmhd electric power generation and identify the problem areas needing further R and D efforts to achieve commercial acceptance of the process. During the last two decades there has been active interest in the development of this technology. A large volume of literature is available in published form, apart from the unpublished information of commercial value. Judging from this standpoint this report cannot be considered exhaustive. Nevertheless it integrates the scattered information in a condensed volume which would be useful in extrapolating the future trends of development while assessing the present status of the technology. To make this report self-contained and complete, the fundamental principles ofmhd power generation have also been included. Themhd project in India is fully sponsored by the Department of Science and Technology under whose auspices this report has been prepared.     

Performance ofesprit in the presence of gain and phase mismatches in sensor doublets

esprit, an acronym for Estimation of Signal Parameters via Rotational Invariance Technique, is a novel method for estimating the Directions of Arrival (doa) of plane waves using an arbitrary array of sensor doublets. However,esprit requires an identical pair of sensors in each doublet, that is the gain and phase characteristics of the sensors in a doublet have to be matched, which may be difficult to ensure in practical situations. In this paper, assuming the sources to be uncorrelated, we analyse the performance ofesprit when the gain and phase characteristics of the sensors in a doublet are not identical. It is shown that the angle estimates are unbiased and expressions are derived for the variance in the estimates ofdoa, when gain and phase mismatches exist in doublets. Computer simulation results are also presented to assert the theoretical predictions.     

Fuzzy medial axis transformation (fmat): Image representation,skeleton extraction and uncertainty management in computer vision

The problem of extraction of medial axis transformation of a gray image with reference to skeletonization, image representation and uncertainty management in a vision system has been addressed. The Fuzzy Medial Axis Transformation (fmat) of a fuzzy setf is a set of fuzzy disks whose sup isf. Unfortunately, specifying thefmat sometimes requires more storage space than specifyingf itself. The present paper describes some techniques to improve the compact representation offmat; thereby making it practically useful to an image for its skeleton extraction and compact representation, for shape analysis and template matching, for representation and retrieval, for uncertainty management in recognition and for creating new images of various poses. The algorithms involve reduction of redundancy infmat, its approximation, and reduction of the searching spaces for its computation. Computational aspects for the convenience of writing an efficient program have been described. Some applications of thefmat have also been mentioned. This work was done while SKP held annrc-nasa Senior Research Associateship at the Lyndon B Johnson Space Center, Houston, Texas.     

X-ray spectroscopy and local structures in glasses

X-ray spectroscopy which is a combination of two techniques, namely x-ray absorption near edge structure (xanes) and extended x-ray absorption fine structure (EXAFS) analyses, is a unique technique for the study of local structures in glasses. Availability of synchrotron radiation sources has made the technique quite attractive and useful because the photon flux from synchrotrons is very intense and polarized. In this article, a brief summary ofxanes andEXAFS techniques is given along with a few applications to the study of local structures in glasses. Communication No. 323 from Solid State and Structural Chemistry Unit.     

On the mechanism of pairing in thebcs theory

An explanation has been offered for the mechanism of cooper pairing in thebcs theory of superconductivity on the basis of the relativistic Darwin interaction. The theory leads to an expression for critical temperature which depends on a few atomic parameters. Calculated values ofT _c for elements and alloys are in good agreement with experiment.     

A note on ‘ferroelectricity in polymer films containing TGS powder’

Ferroelectric polymer films have been made by dispersingtgs powder. The dielectric constant ε′ of the films has been measured. The thermal behaviour of ε′ is also reported. Data have been obtained from samples prepared with different weight concentrations (10–75%) oftgs.     

High voltage electron microscope irradiation and observations in metallic glasses

High voltage electron microscope (hvem) has been extensively used to produce radiation damage and to study the characteristics of defects so produced in crystalline solids. To understand the defect production in metallic glasses and to evaluate the influence of such defects on physical properties like crystallisation temperature etc., high voltage microscopy and subsequentin situ heating and observation has been extremely useful technique. This paper gives a qualitative overview of such work performed in metallic glasses. In particular results obtained on a nickel based metallic glass using ahvem and an electron accelerator are presented. The advantages and limitations ofhvem irradiation are highlighted.     

Study of a complex water resources system with screening and simulation models

The study describes a sequential iterative modelling process for a complex water resource system. Two types of analytical models are used to find a reasonably small set of possible systems optimal design alternatives for a complex river basin. These models are a linear programming deterministic continuous (lpdc) model and a linear programing deterministic discontinous (lpdd) model. Linear programing has been used with linear approximation of the nonlinear functions. A simulation program has been developed which continues screening on the basis of the information obtained from the linear programing model. The models are developed in the context of analysis of the Narmada river, a large river basin in India, for which in the first instance alternative combinations and capacities of six major dams have to be decided.     

Electron transport in non-crystalline garnet films

Thin films of yttrium iron garnet (yig) and Gd-substitutedyig of different thickness have been prepared by flash evaporation. The surfacedc andac electrical resistivity and thermopower in these films have been studied. The results are explained on the basis of Mott and Davis model in which narrow tails of localised states exist at the extreme valence and conduction bands and a band of localised levels near the middle of the gap. For the temperature range studied, the main conduction mechanism is on account of excitation of carriers into localised states at the band edges and hopping at energies close to the band tails.     

Advances in the acoustics of flow ducts and mufflers

This review paper deals with advances made in the last two decades in the acoustics of flow ducts for heating, ventilation and air-conditioning (hvac) systems and engine mufflers. The context, concepts, methods used and results have been highlighted. Frequency-domain one-dimensional analysis of reflective mufflers has been emphasized because of its basic importance and wide application. Finally, problems needing further research have been identified.     

Parametric study of the electrical to thermal power conversion in an inductively coupledrf plasma torch

An inductively coupled (ic) radio-frequency (rf) stabilized argon plasma was generated in a quartz tube using a 7 MHzrf generator. The electrical and thermal powers were measured and the efficiency of energy conversion was computed. The results indicate that for a constant power input, there is an optimum argon flow rate for which maximum energy conversion efficiency occurs.     

Infrared absorption in spinel ferrites

Their spectra of a number of ferrites, MFe₂O₄, M(Mn, Fe, Co, Ni, Cu and Zn) have been studied at room temperature in the range 200–1000 cm⁻¹. In all the cases the spectrum consists of four bands, two of which have strong absorption while the other two have weak absorption and often appear as shoulders on the main band. However up to 20% of the inverse ferrite, the shoulder in the low energy side appears as a band. In this paper we have analysed the origin of the above bands.     

Thermal properties of some α-amino acids in aqueous solutions

The thermal properties (thermal conductivity, thermal diffusivity, and volumetric heat capacity) of aqueous solutions of -amino acids [R-CH(NH₂)COOH]—glycine, dl-alanine, l-valine, and dl-leucine, were measured in the temperature range 20–90C using the hot-wire technique. The results show that the values of the thermal properties depend mainly on the amino acid concentration in the medium, the substituted alkyl group of the substances under investigation, and the temperatures. The mechanism of heat transfer is discussed, and the roles of both radiation and convection are taken into consideration.     

Influence of anode roughness and buffer layer nature on organic solar cells performance

Fluorine doped transparent conductive tin oxide thin films (FTO) of different surface roughness have been deposited by chemical vapor deposition (FTO_SOL), classical chemical spray pyrolysis (FTO_CSP), and spray pyrolysis onto heated substrates using infra red irradiation (FTO_IRSP); the three deposition methods inducing different surface roughness. It was found that the different FTOs presented similar electrical properties while their structural, morphological and optical properties were related to surface properties. These FTO films have been used as anode in multilayer organic solar cells, based on coupled donor/acceptor-copper phthalocyanine/fullerene. To improve solar cell performance, buffer layers of different natures have been tried at the anode/organic material interface. Deposition of a thin molybdenum oxide film onto FTO smooth films afforded reproducible devices with performance similar to those obtained with indium tin oxide anodes. However, cell efficiency decreased as FTO surface roughness increased. The degree of degradation depended on the nature of the buffer layer. We show that it is necessary to use buffer layer material that allows consistency and completeness of the electrode coverage.     

Thetranair rectangular grid approach to solving the nonlinear full-potential equation about complex configurations

This paper describestranair, a numerical method that uses a rectangular grid to solve the nonlinear full-potential equation about general complex configurations. The grid is locally refined to resolve the high velocity gradients arising from leading edge expansions or shock waves. The grid penetrates the boundary (described by networks of quadrilateral panels) and is generated automatically. Discrete operators are constructed using the finite element method. The system of nonlinear discrete equations is solved iteratively using an orthogonal conjugate gradient method preconditioned by an exterior Poisson solver and a direct sparse solver. The primary emphasis of this work is to provide design engineers with an aerodynamics analysis tool (thetranair code) which is as accurate, reliable, economical, and flexible to use as panel methods. Results obtained by usingtranair to analyse several interesting configurations are presented. This work was supported in part bynasa (Contractnas2-12513) and theirad funds of The Boeing Company.     

Embedding of reduced pressure-chemical vapor deposition grown Ge nanocrystals in a high quality SiO2 matrix for non-volatile memory applications

We have obtained thanks to reduced pressure-chemical vapor deposition germanium nanocrystals in a high quality SiO₂ matrix. A perfect control of (i) the tunnel and control oxide layer thicknesses and (ii) the germanium nanocrystals' density and diameter has been achieved. Scanning electron microscopy was used to (i) determine the nucleation and growth rate of the germanium nanocrystals and (ii) evaluate their morphological stability during their embedding. We have also studied the influence of thin selectively grown Si films in order to passivate the surface of the germanium nanocrystals. X-ray photoelectron spectroscopy has shown that the germanium nanocrystals' surface properties are better with a Si capping. The polycrystalline state of the nanocrystals has been evaluated with X-ray diffraction. Transmission electron microscopy image reveals the lack of germanium diffusion and precipitation in the SiO₂ matrix.     

Inherent safety concepts in nuclear power reactors

Different inherent safety concepts being considered in fast and thermal reactors are presented after outlining the basic goals of nuclear reactor safety, the ‘defence in depth’ philosophy to achieve these goals and the characteristics affecting the safety of liquid metal fast breeder and light water reactors. The inherent safety potential of fast reactors with respect to different sizes and types of fuel is also discussed. Finally, the approach proposed for the Indian Prototype Fast Breeder Reactor (Pfbr), which is in the detailed design stage, is also presented.     

Preparation and characterization of flash-evaporated CuInSe2 thin films

Thin films of CuInSe₂ have been evaporated onto glass substrates by flash evaporation. The as-deposited films are amorphous and annealing in selenium atmosphere produces polycrystalline films. The films were characterized bytem and x-ray diffraction techniques. The optical absorption of the films shows three energy gaps of 1·03, 1·07 and 1·22 eV. The crystal field and spin-orbit splitting are thus found to be 0·04 eV and 0·16 eV respectively. The percentaged-character of the valence band states is ∼35%. The Arrhenius plot of electrical conductivity of films showed impurity ionization ofE _A = 75 meV.     

Factorial design preparation of transparent conducting oxide thin films

Transparent and conducting properties of Cd₂SnO₄ films deposited onto glass substrates by the dip coating technique have been obtained using a 2⁴ factorial design. All films were well adhered onto their substrates, presented porous morphology and inverse spinel structure. Statistical factorial design analysis showed that only substrate withdrawal rate and precursor solution concentration had significant effects on average transmission of the films. Cumulative probability graphs of factorial design model coefficients showed that none of the factor levels have significant effects on resistivity. However the films presented significantly higher resistivities using low withdrawal rates and low concentration levels. This indicates resistivity is a more complex function of the factor variables than transmission. From the factorial design experiments and statistical analysis of their results a highest average transmission of 88% and lowest resistivity of 2.43 × 10^− 4 Ω m were found.