共查询到20条相似文献,搜索用时 78 毫秒
1.
2.
我们测量了光纤布喇格光栅在4.2 ̄350K温度范围内布喇格波长与温度的关系。室温时(293K)实测的波长与温度的关系对应折射率与波长的关系,为dn/dT=9.1×10^-6/℃,这与熔凝氧化硅早期的测试结果一致,然而dn/dT值随温度的降低而减小,液态氮温度(77K)时降为3.5×10^-6/℃,而液态氦温度(4.2K)时近似为零。埋置在复合材料中的光纤光栅布喇格波长的温度特性与非埋置光栅相同。 相似文献
3.
4.
5.
6.
7.
8.
介绍和比较了几种制作光纤布喇格光栅的主要方法,并对用这些方法制作的光纤布喇格光栅的性能和特点作了分析及说明。 相似文献
9.
10.
11.
12.
13.
14.
15.
《Optical Fiber Technology》2014,20(5):467-472
This paper studies the performance analysis of wavelength-division multiplexed optical communication systems (WDM). First, flat-gain erbium doped fiber amplifiers (EDFAs) are seriously needed to obtain proper and equal amplification of all channels. Such amplifiers can be designed by intrinsically modifying the host material or extrinsically using proper filters. In this research, we benefit from both the intrinsic and extrinsic methods to achieve sharp flat EDFA output gain using cascaded fiber Bragg gratings (FBGs). Second, the performance of our technique has been evaluated through calculating the bit error rate (BER) and signal-to-noise ratio (SNR) of a WDM system embedded with the reported EDFA flattening system. The parametric simulations of the FWHM of FBGs, SNR, optical power and the transmission distance have shown a noticeable improved performance. Sending data via an optical WDM system will be proven from comprehensive simulations to achieve high quality signal transmission spectrums, increased transmission distances and low power consumption. By extension, the reported design using cascaded FBGs can also be generalized to equalize the gain of any arbitrary profile. 相似文献
16.
光纤光栅传感系统信号解调新技术研究 总被引:1,自引:0,他引:1
信号解调是光纤光栅传感系统实用化所面临的最大难题,其核心问题在于设计高分辨率、低成本的波长检测方案。总结了光纤光栅传感信号解调的一般原理和技术难点,对常用解调方法进行了分类和归纳。目前报道的主要解调方法是滤波法、干涉法和可调光源扫描法。针对不同的解调方法,重点介绍了它们的工作原理及性能特点,评价了其优缺点,并分别给出了它们的实验原理图。对目前最有应用前景的可调谐F-P滤波法进行了详细的介绍和分析,并加入了对原有方案的改进,用气体吸收池代替原来的参考光栅。 相似文献
17.
化学镀Ni-Zn-P FBG及其温度传感特性 总被引:2,自引:0,他引:2
通过化学镀和电镀的方法使光纤布拉格光栅金属化,可对光纤光栅进行保护、增敏,使其具有可焊性,进而可通过焊接嵌入金属或封装在表面监测工作状态。采用化学镀Ni-Zn-P方法对光纤布拉格光栅进行了金属化,通过体视显微镜和金相显微镜观察Ni-Zn-P镀层;对化学镀后的光纤光栅进行了30~70℃温度传感试验,分析了传感特性。结果表明:化学镀后的光纤与镀层结合良好,具有导电性可以进一步电镀;化学镀光栅与裸光栅相比温度传感灵敏度提升1.1倍,存在迟滞误差,随静置时间的推移灵敏度不变,迟滞误差减小。残余应力是产生迟滞误差的主要原因,分析讨论了残余应力的来源和残余应力对金属化光栅中心波长的影响。 相似文献
18.
光纤光栅在高速光通信系统中的新应用 总被引:2,自引:1,他引:1
光纤光栅以其独特的优点,广泛应用于高速光通信系统中,为此介绍了光纡光栅作为EDFA增益均衡器、色散补偿器和偏振模色散补偿器等在高速光纤通信系统中的应用,分别研究了它们的原理,特点及发展状况。 相似文献
19.
A novel temperature-insensitive strain sensor based on a fiber Bragg grating is demonstrated. The front section of the fiber Bragg grating is fixed to a crystal plate, and the other section is linearly etched by HF acid. The reflected power and bandwidth of the grating vary linearly with strain and is insensitive to temperature variation. 相似文献