共查询到20条相似文献,搜索用时 46 毫秒
1.
详细论述了青海察尔汉盐湖以间卤水为原料,通过盐田滩晒出光卤石矿来生产氯化钾的各条工艺流程及其应用与特性。 相似文献
2.
3.
4.
5.
为提高氯化钾制备的纯度,以盐场中的光卤石作为原材料,以光卤石分解原理作为基础,分析了在不同分解温度、不同分解加水量和不同分解时间下的氯化钾收率与纯度。结果表明,当分解温度为75℃,分解时间为7 min,以及分解加水量在理论值1.1倍的时候,得到的氯化钾纯度较高。通过以上试验,为氯化钾的制备提纯提供了借鉴参考。 相似文献
6.
结合多年光卤石法制取氯化钾工艺厂房建筑防腐蚀设计经验和生产实际的检验结果,介绍了光卤石法制取氯化钾工艺的化工厂房建筑防腐设计的技术措施. 相似文献
7.
光卤石在晒制过程中 ,由于气候条件、环境因素和成矿技术条件的影响 ,在预晒池、钠盐池及调节池中形成部分夹层和鸡窝状光卤石 ,采矿难度大 ,开采时周围的NaCl易掺杂进来使光卤石严重贫化 ,形成高钠低钾光卤石 ,俗称赖矿 ,KCl含量一般在 8%~ 1 0 %左右 ,而NaCl含量则高达5 0 %~ 60 % ,镁钾比 1 .6∶1左右。由于这种原矿的存在 ,影响了盐田晒制光卤石的正常进行 ,解决的办法有新建盐田、清池、淡水溶盐等 ,但费用都比较高。实践表明 :最佳的办法是对这部分矿进行生产利用 ,创造出经济价值。用高钠低钾贫矿生产氯化钾与用精矿生… 相似文献
8.
通过对高硫酸钙光卤石矿的筛分分析实验和饱和卤水溶洗实验,并经浮选对比实验发现,硫酸钙在氯化钾生产过程中的富集会对产品氯化钾质量产生很大的影响。高硫酸钙光卤石矿中,硫酸钙粒径主要集中在0.038 mm以下,占总量的4.84%,若通过筛分可使除钙率达61.82%以上,钾损率只为1.05%。由此可知,用饱和卤水溶洗高硫酸钙光卤石矿,能使光卤石矿中硫酸钙质量分数由1.99%降低到1.4%以下,也能使饱和卤水中硫酸钙发生同离子效应和盐析效应而析出,从而提高卤水的质量。高钙原矿在饱和卤水中的溶洗,可使最终产品中w(KCl)>90%,并进一步确定了高硫酸钙光卤石矿的工业化连续生产的工艺路线。 相似文献
9.
10.
本文以天然光卤石为原料,探讨制取高氨酸钾的新工艺。该工艺采用化学沉淀法,通过对温度、摩尔比的研究,使光由石中钾的回收率达94%左右。得到高氨酸钾(KC1O_4)的产品符合ZBG12005-87的标准。 相似文献
11.
介绍了以高氯酸铵(NH_4ClO_4)沉淀高氯酸钾(KClO_4)以回收光卤石中的钾,所得的KClO_4以一定摩尔比加到磷酸水溶液中,并以叔胺类(N_(235))萃取剂用萃取的方法去除高氯酸(HClO_4)后制得磷酸二氢钾,被萃取的HClO_4经用氢氧化铵(NH_4OH)水溶液反萃后(得到 NH_4ClO_4)可循环使用。通过实验确定了最佳工艺条件。 相似文献
12.
在氯酸钾生产过程中,通过生产工艺的改进、单元操作设备的改造,氯化钾种类的合理搭配等措施,增加了国产氯化钾的用量,达到了降低生产成本,提高产品质量的目的。 相似文献
13.
溶剂萃取法制备农用硝酸钾 总被引:6,自引:0,他引:6
通过实验研究确立了溶剂萃取法制备硝酸钾的新的工艺流程,并优化了操作条件。在所确定的主要条件下,用溶剂Ⅰ、Ⅱ进行低温萃取,可得到氯含量较低的农用硝酸钾产品,经精制可得工业用产品。 相似文献
14.
15.
16.
研究了由硫酸钠法生产硫酸钾过程中,影响硫酸钾结晶长大的主要因素和控制条件,并筛选出一种能改善硫酸钾结晶习性的添加剂。 相似文献
17.
18.
由于旧工艺和设备的不合理性,造成蒸发生产能力低,蒸汽和水的消耗高,碱损大。本文列举了旧工艺存在的问题,阐述了改进后的新工艺特点,并提出了几点节能降耗的措施。 相似文献
19.
The aim of this article is to introduce a new technology for the production of Dead Sea potassium chloride. The new technology depends on using the power of ultrasound waves during a crystallization process to enhance potassium chloride precipitation and to improve the end-use properties of the produced crystals. This environmentally clean technology, which is called sonocrystallization, has received very intensive research in the past few years. It was used in this study to modify the crystallization process of potassium chloride from the decomposition of Dead Sea carnallite. Two crystallization runs were done; the first was performed without the application of ultrasound waves and the second was performed with this application. The effect of sonication on the crystallization process time and on crystal size distribution as well as on the purity of the crystals was studied. It was found that the required time for the un-sonicated process was about 150 min. This time was reduced to about 50 min when sonication was applied. The produced crystals were sieved, and the crystal size distribution (CSD) was determined for the two runs. For the sonicated process, finer but more uniform crystals were obtained with a mean average size of 0.2643 mm in comparison with 0.5727 mm for the un-sonicated process. The produced crystals were found to be of 96.07% KCl for the un-sonicated process and this purity was improved to 97.31% KCl by the application of ultrasound waves. Based on the results of this study, it seems to be feasible and economical to scale up the proposed technology for industrial applications. 相似文献
20.
介绍用溶液滤纸片(SFP)制样,以X—射线荧光(XRF)光谱快速测定光卤石、钡熔剂样品中氯化物组分和结晶水等。采用外部通道输入法,使结晶水和水不溶物参与氯化物测定结果共同作归一化(100%)计算。根据归一化因子(NF)接近1.00为依据,从而判断测量结果可信与否。本方法简便、快速,准确度能满足生产要求 相似文献