共查询到20条相似文献,搜索用时 156 毫秒
1.
2.
3.
4.
5.
6.
随着粮食低温储藏技术的推广应用,仓房屋顶作为仓外温度导入的一个主要途径,成为了制约低温储粮技术应用的一个障碍.仓顶隔热改造的目的就是通过对粮仓仓顶的隔热层进行技术改造,使粮仓内的粮食温度始终保持在一个相对低的状态.试验选用菱镁材料和聚苯乙烯泡沫粘结的复合板作为改造材料,通过在屋顶安装保温隔热层,从而起到隔热和防雨的双重功效.试验证明,改造后的粮仓在天气温度较高时,效果比较理想. 相似文献
7.
采用常规储藏,整仓环流结合压盖储粮技术对东北地区偏高水分稻谷度夏储藏期间(180 d)的粮温、水分、储藏品质、种用品质和糊化品质进行对比分析。在检测期间,整仓环流结合压盖技术比常规储藏表层粮温低25.8%。整仓环流结合压盖储藏下储粮水分为14.77%,比常规储藏高0.41%。整仓环流结合压盖方式下脂肪酸值为18.66 mgKOH/100g,比常规储藏低4.86 mgKOH/100g。整仓环流结合压盖方式下发芽率为94%。糊化品质分析结果表明整仓环流结合压盖方式储藏的稻谷具有良好的加工稳定性。在东北地区采用整仓环流结合压盖储粮技术储藏偏高水分稻谷能够有效控制粮温,提高粮食的保水率,滞后脂肪酸的上升速率,保证稻谷品质。 相似文献
8.
9.
采用上海良宝公司生产的隔热材料PEF与拱板仓内顶粘合,有效地降低了来自仓顶的温度,从而降低仓内温度,减缓粮温上升速度,延缓粮食陈化,增加了经济效益和社会效益。 相似文献
10.
1 应用仓房及设备5号廒间仓为省粮食设计所设计的 85 0 1号通用仓。长 2 5m ,宽 18m ,堆粮高度 5m。设计容量为稻谷 12 5 0t ,小麦 1665t。仓顶为水泥板屋面 ,屋架为钢混拱形。特点 :夏不隔热 ,冬不恒温 ,仓温变化梯度大。地下通风槽设计为两机两进风接口 ,一机三风槽呈“Ψ”形。通风机采用广汉市粮机厂生产的7 5kW离心式风机两台。2 储粮状况该仓储存稻谷 12 4 9t ,粮高 4 88m ,储存方式为“双低”薄膜压盖。入库时间为 1996年 8月 ,害虫防治手段为采用PH3 发生器预埋熏蒸系统 (范华胜著《新编储粮害虫与防治》312页 ) ,入… 相似文献
11.
12.
国家粮食储备多以平房仓为主要存储仓型,储粮粮堆在夏季时受到外界持续传热而会达到较高温度,而且微生物生长繁殖会进一步引起粮堆内部发热,对安全储粮产生危害。为了确保储粮品质,控制储粮温度,粮仓温度场预测系统的研究与应用就愈显重要。基于神经网络模型,以BP神经网络预测模型为主要研究对象,并选取典型高大平房仓实际粮情监测数据为实例,在MATLAB平台进行仿真,通过实测数据进行训练,构建实测模型。分析了粮食温度场的影响因素,采用SPSS统计学软件确定了影响因素的权重大小,并采用神经网络方法验证了主成分分析的结果。 相似文献
13.
Zhang Wenwu 《四川粮油科技》2006,(2)
为了控制夏季高温对粮温的影响,分别采用喷水降温、谷物冷却机降温和气囊压盖保温的方法延缓粮温上升。试验结果表明三种方法都能有效地延缓储粮温度的上升,但喷水降温最为经济、有效,可操作性强。 相似文献
14.
15.
本实验基于多孔介质热湿传递原理和粮粒吸湿/解吸湿理论,建立了通风过程中粮堆内部热湿耦合传递方程,采用数值预测的方法,研究了吨粮通风量不变、粮堆初始温度与通风空气温度差8℃情况下,粮堆初始平衡湿度与通风空气湿度差分别为-5%、0%和5%时,粮堆内部温度和水分随时间的变化规律。探究了通风湿度对稻谷横向保水降温通风过程中粮堆温度和水分的影响,分析了一定初始粮温和水分时通风空气温湿度对降温保水的效果,得到了稻谷横向降温保水通风的最佳湿度。研究结果可以丰富和完善横向降温保水通风工艺,同时也为横向降温保水通风的操作提供依据。 相似文献
16.
温湿度是影响粮食安全储存的重要因素,为保证储粮安全,采用机械通风,使粮堆和粮粒的温度和水分含量可以得到有效控制。该文基于多孔介质的传热传质理论,建立了仓储稻谷通风过程中粮堆内部流动和热湿耦合传递的数学模型以及粮粒的热量传递和水分输运模型。采用计算流体力学的方法,从粮堆尺度和粮粒尺度,分析了机械通风过程中仓储粮堆和粮粒内部的温度、水分分布规律。研究发现,通风过程阶段,粮堆内部温度降温显著,粮堆整体平均水分呈降低趋势,且粮堆内部温湿度受外界环境温湿度的影响很大;研究还发现粮粒水分扩散速度远小于温度扩散速度。研究结果可以为储粮横向通风保水降温的工作以及粮堆局部霉变、发热和害虫的发育的预防提供参考。 相似文献
17.
18.
Temperature fluctuations and moisture migration in wheat stored for 15 months in a metal silo in Canada 总被引:6,自引:0,他引:6
Temperatures and moisture contents inside a metal silo filled with 20 t of wheat were monitored from August 2003 to October 2004 in Western Canada. In the summer and then repeated in the autumn of 2005, grain moisture contents inside small columns, inserted in the top of the grain bulk in the same metal silo, were measured after 4 and 8 weeks. The columns had the following configurations: 1) both the top and bottom of the column were open; 2) the top of the column was open and the bottom was sealed; and 3) the top of the column was sealed and the bottom was open.During the 15-month period, headspace temperature averaged 2.9 ± 0.2 °C higher than that of the ambient air with a maximum of 18.3 °C and a minimum of 0 °C. There was larger temperature fluctuation in the headspace than inside the grain mass. The average temperature gradient was 5.09 ± 1.24 °C/m inside the grain mass. The highest temperature gradient was 32.4 °C/m and it was located at the center of the bin at 1.6 m high. “Inside” grain had a lower moisture change than the surface grain.Grain in the top section of the column with the column configuration of Top End Open had the largest change of its moisture content, and grain in the middle section of the column with any of the configurations did not change. Grain inside the small columns at different locations in the silo had different moisture movement trends. These trends were consistent with the measured moisture migration in the entire silo. These results confirm that even in a small silo there were temperature gradients large enough to drive air movement and the induced convection currents could cause moisture migration. 相似文献
19.