Frying Stability of Canola Oil Blended with Palm Olein, Olive, and Corn Oils

The fatty acid composition, peroxide value (PV), acid value (AV), iodine value (IV), total tocopherols (TT) content, and total phenolics (TP) content of canola oil (CAO), palm olein oil (POO), olive oil (OLO), corn oil (COO), and the binary and ternary blends of the CAO with the POO, OLO, and COO were determined. The blends were prepared in the volume ratios of 75:25 (CAO/POO, CAO/OLO, CAO/COO) and 75:15:10 (CAO/POO/OLO, CAO/POO/COO). The CAO and its blends were used to fry potato pieces (7.0 × 0.5 × 0.3 cm) at 180 °C. During the frying process, the total polar compounds (TPC) content, AV, oil/oxidative stability index (OSI), and color index (CI) of the CAO/blends were measured. In general, frying stability of the CAO was significantly (P < 0.05) improved by the blending, and the frying performance of the ternary blends was found to be better than that of the binary blends.     

Degradation and Nutritional Quality Changes of Oil During Frying

The changes in regular canola oil as affected by frying temperature were studied. French fries were fried intermittently in canola oil that was heated for 7 h daily over seven consecutive days. Thermo-oxidative alterations of the oil heated at 185 ± 5 or 215 ± 5 °C were measured by total polar components (TPC), anisidine value (AV), color components formation, and changes in fatty acid composition and tocopherols. Results showed that TPC, AV, color and trans fatty acid content increased significantly (P < 0.05) as a function of frying temperature and time. The oil polyunsaturated fatty acids (PUFA) decreased in direct proportion to frying temperature and time. After 7 days of frying, the amount of PUFA was reduced by half and the trans isomers contribution increased 2.5 times during frying at 215 °C. Of the parameters assessed, total polar component and color had the highest correlation, with correlation coefficients of 0.9650 and 0.9302 for frying at 215 and 185 °C, respectively. TPC formation correlated inversely with the reduction of tocopherols.     

Effect of the Presence and Absence of Potatoes under Repeated Frying Conditions on the Composition of Palm Oil

The effect of repeated deep frying of potatoes versus repeated heating/quenching on the chemical profile of palm oil was investigated. The novelty of the work is that the frying and heating/quenching experiments were conducted under similar time-temperature profiles. The effects of the frying load (potato-to-oil ratio: 1/7 and 1/35 kg_potatoes/l_oil) and of the time-temperature profile were examined. Whole palm oil and its polar fraction were analyzed using high pressure size exclusion chromatography. Both repeated frying and repeated heating/quenching generated polar and polymerization products in palm oil. Interestingly, no hydrolysis or other decomposition products were generated under any of the examined conditions. The presence of potatoes during frying in palm oil increased the concentration of polymerization products and polar compounds compared to oils without potatoes significantly. The effects of frying load on oil quality depended on frying time. No significant effect of frying load was observed up to frying times of 13 h (or 10 frying batches). However, frying oil quality was affected by frying load once frying times exceeded 24 h (or 20 batches).     

Stability of Minor Lipid Components with Emphasis on Phytosterols During Chemical Interesterification of a Blend of Refined Olive Oil and Palm Stearin

Minor compounds such as tocopherols and phytosterols in vegetable oils play an important role in their stability and nutritional value. This study monitored the effects of chemical interesterification on the levels of tocopherols, tocotrienols, phytosterols and phytosterol oxidation products (POPs) in an olive oil and palm stearin blend (50/50 w/w). Tocopherols and tocotrienols were dominated by α-tocopherol (192 ppm) and γ-tocotrienol (70 ppm) and decreased during interesterification. Among the tocopherols, δ-tocotrienol had the highest decrease (35%) at 120 °C. During interesterification at 90 and 120 °C, total sterol content in the oil blend (509 ppm) declined slightly, by 3 and 5%, respectively. Phytosterols were esterified at a higher level at 120 °C (7%) than at 90 °C (4%) during this process. Distribution of fatty acids in the esterified sterols followed the fatty acid composition of the oil blend. Total POP content was 4.3 ppm, and remained generally unchanged during interesterification. Among the nine POPs tentatively identified by their mass spectra, 6-hydroxysitostanol and 6-hydroxycampestanol dominated in the oil blend and in the interesterified product. The formation pathways of these saturated di-hydroxyphytosterols have yet to be identified. Although the interesterification process comprised several treatments, there were only minor losses of tocopherols and phytosterols and virtually no increases in the POPs.     

A kinetic study of oil deterioration during frying and a comparison with heating

The thermooxidative alterations of cottonseed oil during frying of potato chips without oil turnover, in a temperature range of 155–195°C, were studied. The results showed that the content of polar compounds, conjugated dienes, conjugated trienes, and p-anisidine value (p-AV) increased linearly with the time of frying at a rate depending on temperature. The rate constants showed a significant but low increase with temperature, except for the rate constant of conjugated trienes that was not correlated to frying temperature. The alterations induced by heating the oil were also measured and compared with those observed in frying at the same temperature. The major difference observed between frying and heating was related to the p-AV increase, which presented a considerably higher rate during heating. The FA content, as a function of process time during frying at 185°C, showed a significant increase in palmitic acid (C16∶0) and a significant decrease in linoleic acid (C18∶2). Oleic acid (C18∶1) also showed a small but significant decrease. The same results were obtained for the oil heated at 185°C. Examination of p-AV or conjugated dienes with polar compounds showed that both p-AV and conjugated dienes had a linear relationship with total polar compounds, with correlation coefficients of 0.946 and 0.862, respectively.     

Improving the Frying Performance and Oxidative Stability of Refined Soybean Oil by Tocotrienol‐Rich Unsaponifiable Matters of Kolkhoung (Pistacia khinjuk) Hull Oil

Increasing consumer awareness for all natural products has quickly led to growing research on new resources of potent and profitable natural antioxidants. In this context, for the first time, the Kolkhoung hull oil (KHO) (Pistacia khinjuk)‐unsaponifiable matters (USM) (UHO) (100, 200, and 400 mg kg^?1) were incorporated into refined soybean oil (RSO) and the oxidative stability of prepared oils was measured during 32 hours of frying. Then, the obtained results (oxidative stability) were compared to the samples containing tert‐butyl hydroquinone (TBHQ) (100 mg kg^?1) as a common synthetic antioxidant. According to the results of oxidative stability assays of acid values, conjugated diene values and carbonyl values, and total polar compounds, the incorporation of UHO, particularly at a concentration of 200 mg kg^?1, was more efficient in improving the oxidative stability compared to TBHQ. The tocol content of KHO (2043.4 mg kg^?1) was higher than the reported amounts of other conventional edible oils. Furthermore, by incorporation of UHO into RSO, as compared with TBHQ, a better protection of naturally occurring antioxidants (tocopherols and sterols) was found after adding UHO to RSO. This fact was mainly attributed to the UHO's tocotrienol fraction. Hence, the USM of KHO can be used as a potent antioxidant to improve the oxidative stability of frying oils.     

Antioxidative Properties of <Emphasis Type="Italic">Curcuma longa</Emphasis> Leaf Extract in Accelerated Oxidation and Deep Frying Studies

The antioxidative properties of Curcuma longa (turmeric) leaf extract were evaluated in refined, bleached and deodorized (RBD) palm olein using accelerated oxidation and deep frying studies at 180 °C for up to 40 h. The extract was capable of retarding oil oxidation and deterioration significantly (P < 0.05) at 0.2% concentration, better than 0.02% BHT for the Oxidative Stability Index (OSI) in an accelerated oxidation study and also the peroxide value in deep frying studies. In sensory evaluation, the French fries were acceptable and were not significantly different (P < 0.05) from one another for color, oiliness and crispiness throughout the 40-h frying study. Curcuma longa leaf extract, which had a polyphenol content of 116.3 ± 0.2 mg/g, possessed heat-stable antioxidant properties and may be a good natural alternative to existing synthetic antioxidants in the food industry.     

Impact of Canolol‐Enriched Extract from Heat‐Treated Canola Meal to Enhance Oil Quality Parameters in Deep‐Frying: a Comparison with Rosemary Extract and TBHQ‐Fortified Oil Systems

Canolol‐enriched extracts obtained from the extraction of fluidized bed treated canola meal with supercritical carbon dioxide were added to high‐oleic canola oil in different concentrations (200, 500 and 750 mg/kg). After 30 h of deep‐fat frying, oils fortified with canolol‐enriched extracts showed a two to three times better frying performance in comparison to the commonly used antioxidants (TBHQ, 200 mg/kg; rosemary extract, 40 and 200 mg/kg) and a control without antioxidants with regards to the formation of di‐ and polymer triacylglycerols, total polar compounds, secondary degradation products (anisidine value) and the iodine value. The canolol‐enriched extracts were also able to slow down the degradation of α‐ and γ‐tocopherol during frying resulting in significant amounts of tocopherols after 30 h of frying in comparison to the other oils. The influence of the canolol‐enriched extracts indicated strongly concentration‐dependent performance. With increasing concentration of the extract, the thermal stability of the fortified oil was improved. The only disadvantage of the addition of the extracts was an increase in the initial acid value, but within the frying time, only oil fortified with 750 mg canolol‐enriched extract/kg reached the limit given in different countries.