All-optical 1300-nm to 1550-nm wavelength conversion using cross-phase modulation in a semiconductor optical amplifier

All-optical 1300-nm to 1550-nm wavelength converters may be important components in lightwave networks which use both the 1300-nm and the 1550-nm low-loss transmission windows of silica optical fiber. We describe a new all-optical 1300-nm to 1550-nm wavelength converter, based on cross-phase modulation in a 1300-nm semiconductor optical amplifier. We demonstrate operation of the wavelength converter at 1.25 Gb/s, and present bit-error rate measurements. The wavelength converter demonstrated here potentially operates at high speed, with low input power and low polarization-sensitivity.     

双辅助光作用下半导体光放大器性能分析

半导体光放大器以其良好的非线性在全光网络中具有广泛应用,但较长的载流子恢复时间一直是制约其用于超快全光信号处理的速率瓶颈,基于包含自发辐射噪声的半导体光放大器模型,探讨了提高半导体光放大器增益恢复时间的有效途径,通过对制约透明波长移动,增益饱和与有效载流子寿命的相关因素进行数值分析,得出以下结论:与单辅助光相比,采用双辅助光可以在不牺牲信号增益的前提下进一步缩短载流子寿命,因而是提高半导体光放大器增益恢复时间的有效途径,这一点对工程设计和应用具有一定的指导意义.     

Regenerative properties of wavelength converters based on FWM in a semiconductor optical amplifier

A detailed experimental investigation of the regenerative properties of the four-wave mixing (FWM) for the conventional nonreturn-to-zero data format is reported. A key feature in the proposed scheme, and contrary to the conventional approach, is application of the ON-OFF keying modulation on the pump wave. Measurement of the static transfer functions of the FWM process in a semiconductor optical amplifier shows that certain operating regimes exist, mainly related to the power levels "one" and "zero" of the modulated pump, where a significant improvement of the extinction ratio (ER) can be achieved. This conclusion has been confirmed by dynamic measurements at 2.4 Gb/s, where up to 3-dB improvement in the ER has been observed.     

Small-signal theory of wavelength converters based on cross-gain modulation in semiconductor optical amplifiers

We give the exact closed form solution of the coupled-mode equations describing frequency converters based on cross-gain modulation in semiconductor optical amplifiers. We show that the frequency response of the converter is strongly affected by the waveguide internal loss.     

10 Gbit=s RZ-OOK to BPSK format conversion by cross-phase modulation in single semiconductor optical amplifier

A simple and power-efficient, all-optical format conversion from 10 Gbit/s RZ-OOK to BPSK is demonstrated using a single semiconductor optical amplifier and optical bandpass filtering. A receiver sensitivity penalty of ~1 dB relative to baseline RZ-OOK was obtained for ~-0.17 nm filter detuning relative to the probe carrier wavelength     

XGM全光波长变换性能分析与优化设计

对基于半导体光放大器（ＳＯＡ）交叉增益调制（ＸＧＭ）的全光波长变换（ＡＯＷＣ）进行了性能分析,并提出了ＡＯＷＣ的简化系统模型,利用此模型详细分析了码速为２．５,５和１０Ｇｂｉｔ／ｓ归雾码的变换光消光比（ＥＲ）和信噪比（ＳＮＲ）与探测光功率（Ｐｃｗ）、信号光功率（Ｐｓ）和泵浦电流的关系,分析了优化设计ＡＯＷＣ的途径。     

80 Gbit/s wavelength conversion using semiconductor optical amplifier and optical bandpass filter

A wavelength converter is presented that is made out of a semiconductor optical amplifier and an optical bandpass filter. Error-free inverted wavelength conversion is demonstrated at a bitrate of 80 Gbit/s. This approach can be exploited at higher bitrates. A clear open eye indicating error-free wavelength conversion at 160 Gbit/s is also presented. This wavelength converter has a simple configuration and allows photonic integration.     

Widely tunable wavelength converter using a double-ring fiber laser with a semiconductor optical amplifier

Widely tunable wavelength conversion has been demonstrated using broad-band orthogonal-pump four-wave mixing in a semiconductor optical amplifier placed at the intersection of two fiber ring lasers. The all-optical wavelength converter operates without using any external pump source. A 3-dB conversion-range over 40 nm is obtained. The measured power penalty is 1.5 dB for a 2.5-Gb/s converted signal at 10/sup -9/ bit error rate.     

Performance of networks using wavelength converters based onfour-wave mixing in semiconductor optical amplifiers

In this paper, we examine the blocking performance of networks in which connections may be blocked due to either insufficient capacity or due to limitations in the transmission network. We use analytical expressions and network simulations to examine blocking in networks in which the quality of the received signal may be so poor that the connection is effectively blocked. In particular, we apply our analysis to networks which use wavelength converters based on four-wave mixing (FWM) in semiconductor optical amplifiers. We show that the performance improvements obtained using these wavelength converters can be significant, but this depends on whether the network uses fixed-frequency or tunable transmitters and receivers     

Optical preamplifier using optical modulation of amplified spontaneous emission in saturated semiconductor optical amplifier

This paper demonstrates a novel optical preamplifier using optical modulation of amplified spontaneous emission (ASE) emitted from a saturated semiconductor optical amplifier (SOA). Requirements on optical alignments and antireflection coating for SOAs can be relaxed and the elimination of an optical filter gives us a large tolerance of an input light wavelength in the proposed optical preamplifier. A small-signal gain of a fabricated preamplifier was over 13.5 dB for an input power of below -20 dBm. An optical gain bandwidth was over 60 nm. We measured the small-signal response of the optically modulated ASE. The 3 dB bandwidths at SOA bias currents of 200, 300, and 400 mA were 5.8, 12.6, and 16.5 GHz, respectively. We also investigated improvements in receiver sensitivities with the proposed optical preamplifier. Our calculation shows a possibility of 10 dB improvement in receiver sensitivities by using the optical preamplifier at 10 Gb/s. The measured receiver sensitivity was -22.7 dBm at 10 Gb/s with the optical preamplifier, which is corresponding to an improvement of 2.5 dB in the receiver sensitivity. Further improvements of the receiver sensitivity can be expected by optimizing the structure of SOAs for saturating ASE.     

基于半导体放大器实现多功能超宽带调制的研究

基于半导体放大器(SOA)的增益饱和效应,提出了一种简单的实现多功能超宽带(UWB)调制的方案。方案采用一个光源和单个SOA,可以实现脉冲波形调制(PSM)、脉冲幅度调制(PAM)和脉冲极性调制(BPM),因此实现容易、结构简单和成本低。利用OptiSystem软件对方案进行了仿真研究,分析了各参数对调制信号的影响以及信号的传输特性。结果表明,本方案对光源的波长和光源的光功率的变化不敏感,仿真输出的调制信号在单模光纤(SMF)中可传输35km。     

Signal-induced birefringence and dichroism in a tensile-strained bulk semiconductor optical amplifier and its application to wavelength conversion

Signal-induced birefringence and dichroism in a tensile-strained bulk semiconductor optical amplifier (SOA) are demonstrated in a counterpropagation scheme. The polarization azimuth rotation and the change of ellipticity angle of the probe light are presented on the Poincare/spl acute/ sphere and can be calculated by the Stokes parameters. All-optical wavelength conversion (inverted/noninverted and upconversion/downconversion) based on cross polarization modulation (XPolM) in SOAs are investigated. It is shown that a bit error rate (BER) of <10/sup -9/ can be achieved and an extinction ratio of > 9 dB can be obtained at a bit rate of 2.488 Gb/s with a 2/sup 31/-1 non-return-to-zero (NRZ) pseudorandom bit sequence (PRBS). Because of the larger birefringence effect induced by the pump light in the longer wavelength range, upconversion shows better performance than downconversion. Compared with the noninverted case, inverted wavelength conversion shows better performance due to the positive contribution from cross gain modulation (XGM), which takes place simultaneously with XPolM.     

半导体光放大器四波混频的波长转换器理论分析

从理论上探讨了半导体光放大器四波混频机制,并由耦合波方程,推导了波长转换效率的表达式。进一步分析了如何提高波长转换效率的方法,既可从放大器本身入手,也可通过优化其工作条件入手,为改善波长转换器的性能提供了理论依据。     

Lossless electroabsorption modulator monolithically integrated with a semiconductor optical amplifier and dual-waveguide spot-size converters

Semiconductor optical amplifier and electroabsorption modulator monolithically integrated with dual-waveguide spot-size converters at the input and output ports is demonstrated by means of selective area growth, quantum-well intermixing, and asymmetric twin waveguide technologies. At the wavelength range of 1550/spl sim/1600 nm, lossless operation with extinction ratios of 25-dB dc and 11.8-dB radio frequency and more than 10-GHz 3-dB modulation bandwidth is successfully achieved. The output beam divergence angles of the device in the horizontal and vertical directions are as small as 7.3/spl deg//spl times/10.6/spl deg/, respectively, resulting in 3.0-dB coupling loss with cleaved single-mode optical fiber.     

All-optical wavelength shifting of microwave subcarriers by using four-wave mixing in a semiconductor optical amplifier

We demonstrate all-optical wavelength shifting over 9 nm for two microwave subcarriers by using four-wave mixing in a semiconductor optical amplifier. In our experiment, the RF spectrum is relatively unaffected by wavelength shifting and the resultant system power penalty is /spl sim/0.5 dB. Such a transparent wavelength shifter may be a critical component in WDM networks supporting both subcarrier multiplexed (SCM) and high speed digital transmission.     

Switches and frequency converters based on cross-gain modulation in semiconductor optical amplifiers

The large-signal theory of frequency converters based on cross-gain and cross-phase modulations in a semiconductor optical amplifier is developed, for the case in which pump and probe are injected from the same facet (co-propagating case). Simple expressions for the bandwidth of cross-gain modulation are derived for single and cascaded SOA's, and large-signal simulations are carried out for cascaded SOA's, pointing out some important system issues. In the cascaded case, the effect of the loss between the SOA's is highlighted.     

A novel hybrid WDM/SCM-PON sharing wavelength for up- and down-link using reflective semiconductor optical amplifier

A hybrid wavelength-division multiplexed/subcarrier multiplexed passive optical network (WDM/SCM-PON) which shares the same wavelength both up-link and down-link is presented by using a reflective semiconductor optical amplifier (RSOA) as a modulator. We investigated down-link of 622 Mb/s using distributed feedback laser diode with direct modulation and 100-Mb/s up-link using an RSOA as a modulator with 900-MHz SCM signal. In our scheme, a novel efficient and cost-effective WDM/SCM-PON using the same wavelength for down/up-link at each optical network unit is proposed and experimentally demonstrated.     

Folded-path self-pumped wavelength converter based on four-wave mixing in a semiconductor optical amplifier

A four-wave mixing wavelength converter with no external pump laser and very low input signal power requirements is characterized. The wavelength conversion occurs inside a high-reflection/antireflection coated semiconductor optical amplifier pigtailed with a fiber Bragg grating. The pump signal is provided by the lasing mode at the Bragg wavelength. A 1-mW optical signal modulated at 2.5 Gb/s is converted over 9 mm with error rates below 10/sup -9/.     

80-Gb/s wavelength conversion based on cross-phase modulation inhigh-nonlinearity dispersion-shifted fiber and optical filtering

Using cross-phase modulation in a 1-km high-nonlinearity dispersion-shifted fiber with subsequent filtering by a tunable optical filter, 80-Gb/s pulsewidth maintained wavelength conversion is realized. Penalty-free transmission over 80-km conventional single-mode fiber and 12-km dispersion-compensating fiber for 80-Gb/s converted signal is realized     

Optimization of pump and signal powers for wavelength converters based on FWM in semiconductor optical amplifiers

We investigate the effect of input pump and signal powers on the noise performance and intersymbol interference (ISI) in a frequency-converter based on four-wave mixing (FWM) in a semiconductor optical amplifier. We demonstrate that there is an input pump power at which the noise figure of the frequency converter is a minimum, and a corresponding input signal power for which the output signal-to-noise ratio (SNR) is a maximum. We report bit-error-rate measurements which show that there is a trade-off between maximizing the output SNR, and minimizing intersymbol interference in the SOA. Consequently, the power penalty incurred in the frequency conversion can be minimized by careful selection of the input signal power. We show that power penalties of less than 1 dB are achievable.