共查询到20条相似文献,搜索用时 109 毫秒
1.
2.
3.
4.
介绍了一种基于吸收式热泵的污泥烘干除湿系统,包括干燥机、空气降温除湿装置、空气循环风机、空气加热装置、溴化锂吸收式热泵。干燥机、空气降温除湿装置、空气循环风机、空气加热装置依次串联;空气降温除湿装置及空气加热装置分别与溴化锂吸收式热泵相连;设置冷却装置,当溴化锂吸收式热泵需要停机检修时备用。将溴化锂吸收式热泵作为污泥烘干除湿的动力热源和动力冷源,可以实现污泥烘干除湿的同时,回收污泥冷凝除湿过程中的热量,降低污泥烘干除湿过程中的能源消耗,提高了污泥烘干除湿的效率。系统运行经济,未造成空气的二次污染。 相似文献
5.
6.
8.
高温热泵室内模拟试验及工业应用 总被引:1,自引:0,他引:1
针对一些工业企业(如石油、化工、动力和钢铁等)生产过程中存在大量低温余热且很少利用的情况,在研制的高温热泵试验台上进行了余热回收模拟试验研究。根据试验数据及计算结果,回归了以R142b为工质、热源温度在35~45℃、供热温度在60~85℃及压缩机耗功在2.3~3.7 kW之间变化时,各性能指标的经验关联式,并分析了参数变化对系统指标的影响关系。随后利用引进的工业用热泵,结合石油生产企业情况进行了工业试验。试验结果表明,以热泵装置回收石油生产过程中的低温余热,节能效益显著。实际运行过程中热泵回收系统运行成本与燃气加热炉系统相差不大,限制了热泵的推广。 相似文献
9.
10.
11.
Seung Sun An Chung Woo Jung Minsung Kim Seong Ryong Park Chaedong Kang Yong Tae Kang 《Journal of Mechanical Science and Technology》2013,27(12):3903-3909
This research conducts an experiment for a hybrid heat pump system, using ammonia-water as a working fluid, to obtain a hot water of about 80°C. The hybrid heat pump system is the combination of vapor compression cycle and absorption cycle to improve the performance of the heat pump system. The hybrid heat pump system uses a low temperature heat source of about 50°C from the industrial waste heat. The system consists of absorber, desorber, solution heat exchanger, oil heat exchanger, rectifier, compressor and a solution pump. Parametric analysis is carried out experimentally and numerically for the key parameters such as the capacity of the absorber, the internal pressure change. From the present experimental study, it is found that the maximum hot water temperature is obtained to be 79.33°C. 相似文献
12.
太阳能-地源热泵系统运行特性的试验研究 总被引:1,自引:0,他引:1
在已建成的太阳能-地热能综合利用多功能热泵试验系统上进行了太阳能-地源热泵系统联合与交替供暖运行特性的试验测试,结果表明:联合运行模式不仅可以提高日间系统运行效率,且U型埋管可作为热源缓冲体自动储存日间富余太阳能,以改善夜间运行效率,联合运行测试期内太阳能与地热能热源的承担比例为43.3%:50.2%;交替运行模式可以在充分利用太阳能的前提下有效恢复埋管周围土壤温度,从而可提高太阳能与地热能的综合利用效率;整个供暖测试期内,地源热泵与日间太阳能热泵的平均COP分别为2.37、2.72,对应的太阳能-地源热泵系统联合运行模式、昼夜交替运行模式及太阳能-U型埋管补热交替运行模式的平均COP分别为2.69、2.65及2.56. 相似文献
13.
水源热泵机组的变工况特性研究 总被引:3,自引:0,他引:3
通过对某水源热泵机组的压缩机、冷凝器和蒸发器的变工况特性分析和计算,得到该水源热泵机组变工况特性模型。对该模型进行误差检验,其误差均在允许范围内。应用水源热泵机组变工况模型,可以清楚、方便地对水源热泵机组进行变工况分析研究,对于以后水源热泵机组及其空调系统的优化设计等其它方面的研究也具有一定的参考和实用价值。 相似文献
14.
15.
Mohammed Awwad Ali Al-Dabbas 《Journal of Mechanical Science and Technology》2011,25(8):2013-2023
Geothermal energy in Jordan is a low-emission and renewable source that could provide households and commercial buildings
with heating and cooling. Access to this ‘free’ energy may be available just a few feet underground. Thus, the objectives
of this research are designing a ground heat exchanger that utilizes geothermal energy in heating to exchange the primary
geothermal fluid with a secondary clean fluid, determining the feasibility of designing a ground heat exchanger system to
pump geothermal energy under the weather conditions of the Ma’en area in Jordan and calculating the amount of energy saved.
The design procedure involves applying energy and momentum equations around the geothermal fluid circuit. The FLUENT software
program is used to calculate the ground heat exchanger parameters and the amount of energy saved. Finally, the feasibility
study shows that the Geoexchange systems represent a savings to homeowners of around 70% in the heating mode, and up to 50%
in the cooling mode compared to conventional fossil fuel systems. 相似文献
16.
17.
地下岩土的热物性参数是地源热泵地热换热器的设计中所需要的很重要的参数。热物性参数的大小对钻孔的数量及钻孔的深度具有显著的影响,进而影响地源热泵系统的初投资。为了能够现场测量地下岩土的热物性参数,研制了便携式测试仪器,用该测试仪现场采集到的数据,再利用参数估计的方法确定地下岩土的热物性参数。概述了岩土热物性测试仪的检测原理、结构构成及检测结果,并指出了该检测仪的应用推广前景。 相似文献
18.
分析了喷气增焓系统、改进的翅片管以及喷液旁通对空气源热泵热工性能的影响,并进行额定制冷、制热、融霜以及低温制热的实验研究。实验结果表明:喷液增焓能够改善低温制热时的热工性能,制热量能够提高5%~15%;翅片管的改进能够延长结霜时间,缩短融霜时间;制冷时的喷液能够有效降低压缩机吸排气温度,对制冷量和功率的影响极小。3种技术的使用,改善了机组在恶劣工况下的热工性能。 相似文献
19.