Metal‐Free 2D/2D Phosphorene/g‐C3N4 Van der Waals Heterojunction for Highly Enhanced Visible‐Light Photocatalytic H2 Production

The generation of green hydrogen (H₂) energy using sunlight is of great significance to solve the worldwide energy and environmental issues. Particularly, photocatalytic H₂ production is a highly promising strategy for solar‐to‐H₂ conversion. Recently, various heterostructured photocatalysts with high efficiency and good stability have been fabricated. Among them, 2D/2D van der Waals (VDW) heterojunctions have received tremendous attention, since this architecture can promote the interfacial charge separation and transfer and provide massive reactive centers. On the other hand, currently, most photocatalysts are composed of metal elements with high cost, limited reserves, and hazardous environmental impact. Hence, the development of metal‐free photocatalysts is desirable. Here, a novel 2D/2D VDW heterostructure of metal‐free phosphorene/graphitic carbon nitride (g‐C₃N₄) is fabricated. The phosphorene/g‐C₃N₄ nanocomposite shows an enhanced visible‐light photocatalytic H₂ production activity of 571 µmol h^?1 g^?1 in 18 v% lactic acid aqueous solution. This improved performance arises from the intimate electronic coupling at the 2D/2D interface, corroborated by the advanced characterizations techniques, e.g., synchrotron‐based X‐ray absorption near‐edge structure, and theoretical calculations. This work not only reports a new metal‐free phosphorene/g‐C₃N₄ photocatalyst but also sheds lights on the design and fabrication of 2D/2D VDW heterojunction for applications in catalysis, electronics, and optoelectronics.     

SnSe/MoS2 van der Waals Heterostructure Junction Field‐Effect Transistors with Nearly Ideal Subthreshold Slope

The minimization of the subthreshold swing (SS) in transistors is essential for low‐voltage operation and lower power consumption, both critical for mobile devices and internet of things (IoT) devices. The conventional metal‐oxide‐semiconductor field‐effect transistor requires sophisticated dielectric engineering to achieve nearly ideal SS (60 mV dec^?1 at room temperature). However, another type of transistor, the junction field‐effect transistor (JFET) is free of dielectric layer and can reach the theoretical SS limit without complicated dielectric engineering. The construction of a 2D SnSe/MoS₂ van der Waals (vdW) heterostructure‐based JFET with nearly ideal SS is reported. It is shown that the SnSe/MoS₂ vdW heterostructure exhibits excellent p–n diode rectifying characteristics with low saturate current. Using the SnSe as the gate and MoS₂ as the channel, the SnSe/MoS₂ vdW heterostructure exhibit well‐behavioured n‐channel JFET characteristics with a small pinch‐off voltage V_P of ?0.25 V, nearly ideal subthreshold swing SS of 60.3 mV dec^?1 and high ON/OFF ratio over 10⁶, demonstrating excellent electronic performance especially in the subthreshold regime.     

Homogeneous 2D MoTe2 CMOS Inverters and p–n Junctions Formed by Laser‐Irradiation‐Induced p‐Type Doping

Among all typical transition‐metal dichalcogenides (TMDs), the bandgap of α‐MoTe₂ is smallest and is close to that of conventional 3D Si. The properties of α‐MoTe₂ make it a favorable candidate for future electronic devices. Even though there are a few reports regarding fabrication of complementary metal–oxide‐semiconductor (CMOS) inverters or p–n junction by controlling the charge‐carrier polarity of TMDs, the fabrication process is complicated. Here, a straightforward selective doping technique is demonstrated to fabricate a 2D p–n junction diode and CMOS inverter on a single α‐MoTe₂ nanoflake. The n‐doped channel of a single α‐MoTe₂ nanoflake is selectively converted to a p‐doped region via laser‐irradiation‐induced MoO_x doping. The homogeneous 2D MoTe₂ CMOS inverter has a high DC voltage gain of 28, desirable noise margin (NM_H = 0.52 V_DD, NM_L = 0.40 V_DD), and an AC gain of 4 at 10 kHz. The results show that the doping technique by laser scan can be potentially used for future larger‐scale MoTe₂ CMOS circuits.     

Thickness‐Dependent In‐Plane Polarization and Structural Phase Transition in van der Waals Ferroelectric CuInP2S6

van der Waals (vdW) layered materials have rather weaker interlayer bonding than the intralayer bonding, therefore the exfoliation along the stacking direction enables the achievement of monolayer or few layers vdW materials with emerging novel physical properties and functionalities. The ferroelectricity in vdW materials recently attracts renewed interest for the potential use in high‐density storage devices. With the thickness becoming thinner, the competition between the surface energy, depolarization field, and interfacial chemical bonds may give rise to the modification of ferroelectricity and crystalline structure, which has limited investigations. In this work, combining the piezoresponse force microscope scanning, contact resonance imaging, the existence of the intrinsic in‐plane polarization in vdW ferroelectrics CuInP₂S₆ single crystals is reported, whereas below a critical thickness between 90 and 100 nm, the in‐plane polarization disappears. The Young's modulus also shows an abrupt stiffness at the critical thickness. Based on the density functional theory calculations, these behaviors are ascribed to a structural phase transition from monoclinic to trigonal structure, which is further verified by transmission electron microscope technique. These findings demonstrate the foundational importance of structural phase transition for enhancing the rich functionality and broad utility of vdW ferroelectrics.     

Homogeneous 2D MoTe2 p–n Junctions and CMOS Inverters formed by Atomic‐Layer‐Deposition‐Induced Doping

Recently, α‐MoTe₂, a 2D transition‐metal dichalcogenide (TMD), has shown outstanding properties, aiming at future electronic devices. Such TMD structures without surface dangling bonds make the 2D α‐MoTe₂ a more favorable candidate than conventional 3D Si on the scale of a few nanometers. The bandgap of thin α‐MoTe₂ appears close to that of Si and is quite smaller than those of other typical TMD semiconductors. Even though there have been a few attempts to control the charge‐carrier polarity of MoTe₂, functional devices such as p–n junction or complementary metal–oxide–semiconductor (CMOS) inverters have not been reported. Here, we demonstrate a 2D CMOS inverter and p–n junction diode in a single α‐MoTe₂ nanosheet by a straightforward selective doping technique. In a single α‐MoTe₂ flake, an initially p‐doped channel is selectively converted to an n‐doped region with high electron mobility of 18 cm² V^?1 s^?1 by atomic‐layer‐deposition‐induced H‐doping. The ultrathin CMOS inverter exhibits a high DC voltage gain of 29, an AC gain of 18 at 1 kHz, and a low static power consumption of a few nanowatts. The results show a great potential of α‐MoTe₂ for future electronic devices based on 2D semiconducting materials.     

Direct Synthesis of a Self‐Assembled WSe2/MoS2 Heterostructure Array and its Optoelectrical Properties

Functional van der Waals heterojunctions of transition metal dichalcogenides are emerging as a potential candidate for the basis of next‐generation logic devices and optoelectronics. However, the complexity of synthesis processes so far has delayed the successful integration of the heterostructure device array within a large scale, which is necessary for practical applications. Here, a direct synthesis method is introduced to fabricate an array of self‐assembled WSe₂/MoS₂ heterostructures through facile solution‐based directional precipitation. By manipulating the internal convection flow (i.e., Marangoni flow) of the solution, the WSe₂ wires are selectively stacked over the MoS₂ wires at a specific angle, which enables the formation of parallel‐ and cross‐aligned heterostructures. The realized WSe₂/MoS₂‐based p–n heterojunction shows not only high rectification (ideality factor: 1.18) but also promising optoelectrical properties with a high responsivity of 5.39 A W^?1 and response speed of 16 µs. As a feasible application, a WSe₂/MoS₂‐based photodiode array (10 × 10) is demonstrated, which proves that the photosensing system can detect the position and intensity of an external light source. The solution‐based growth of hierarchical structures with various alignments could offer a method for the further development of large‐area electronic and optoelectronic applications.     

Supramolecular Crystal Engineering at the Solid–Liquid Interface from First Principles: Toward Unraveling the Thermodynamics of 2D Self‐Assembly

The formation of highly ordered 2D supramolecular architectures self‐assembled at the solid–solution interfaces is subject to complex interactions between the analytes, the solvent, and the substrate. These forces have to be mastered in order to regard self‐assembly as an effective bottom‐up approach for functional‐device engineering. At such interfaces, prediction of the thermodynamics governing the formation of spatially ordered 2D arrangements is far from being fully understood, even for the physisorption of a single molecular component on the basal plane of a flat surface. Two recent contributions on controlled polymorphism and nanopattern formation render it possible to gain semi‐quantitative insight into the thermodynamics of physisorption at interfaces, paving the way towards 2D supramolecular crystal engineering. Although in these two works different systems have been chosen to tackle such a complex task, authors showed that the chemical design of molecular building blocks is not the only requirement to fulfill when trying to preprogram self‐assembled patterns at the solid–liquid interface.