共查询到19条相似文献,搜索用时 140 毫秒
1.
提出了一种新的无霜空气源热泵驱动的溶液除湿温湿度分控空调系统,通过MATLAB建立了系统数学模型,对系统冬夏季工况系统性能进行了研究.夏季工况下,除湿器进口溶液浓度、 再生流量比例、 冷凝热比分别为0.25、0.2、0.5时,系统COP可达最佳,COP值为2.34~5.23.与同类系统相比,其COPR值均大于1,系统性... 相似文献
2.
3.
提出了一种由溶液除湿新风机组和空气源热泵装置组合的新系统,利用MATLAB语言对该系统进行数值模拟计算和分析,结果表明:在西安地区冬季空调室外计算参数下,新风机组性能系数COP,TCOP和COPh分别为0.5,0.65和5.1。 相似文献
4.
5.
6.
7.
8.
《建筑科学》2017,(8)
本文建立了基于PV/T和GHP再生的转轮除湿空调系统,构建了除湿转轮子系统仿真模块、燃气热泵子系统仿真模块和PV/T子系统仿真模块,并在此基础之上构建整机系统仿真模块。对不同处理空气流量、处理空气温度、处理空气湿度、转轮转速、太阳光照、发动机转速及有无预冷器的空调系统性能进行了仿真模拟。主要结论有:处理空气风量越大、入口温度越高、入口湿度越小、转轮转速越低则空调系统的除湿量越小;处理空气风量越大、入口温度越高、入口湿度越大、转轮转速越高,则蒸发温度越高,制冷COP越大;发动机转速越大,系统的再生温度越高、送风温度越低、冷凝温度越高、蒸发温度越高、除湿量越大;太阳光照强度越强,系统的除湿量就越大;有预冷器的空调系统除湿量更大。 相似文献
9.
建立溶液除湿独立新风空调系统的实验装置,实现温湿度独立控制的空调系统,对实验装置所采用的集热泵、溶液全热回收和溶液除湿技术于一体的新风处理机的工作原理进行分析,由此建立了溶液除湿独立新风空调系统的实际工程模拟实验系统。对受控对象的空调房间进行溶液除湿新风空调系统的工作特性测试。通过对测试工况数据的分析,得知室外新风温度与所要求的除湿溶液的入口温度、密度存在一定的线形关系。通过测试广州地区某典型工况下除湿新风机组温度、含湿量的运行参数变化,表明夏季完全能满足设计工况下的室内设计参数温湿度的要求。同时此溶液除湿独立新风空调机组的节能效果明显,EER值在5.0-60之间。 相似文献
10.
11.
本文介绍溶液调湿空调技术在博物馆建筑中的应用。通过比较分析得出,溶液调湿空调技术用于博物馆建筑,在空气质量及能耗方面均具有优势。 相似文献
12.
13.
In conventional air-conditioning system, fresh air volume is always restricted to save energy, which sacrifices indoor air quality (IAQ) to some extent. However, removing the latent load of air by liquid desiccant rather than by cooling is an alternative way of reducing energy consumption. Therefore, IAQ can be improved by increasing the volume of fresh air introduced into an air-conditioning system. In this paper, a liquid desiccant based air-conditioning system is studied, with the system performance under various fresh air ratios analyzed using simulation tests. In addition, the proposed system and a conventional system are compared. In the proposed system, with the increase in fresh air ratio, the heating load for solution regeneration rises, the dehumidification efficiency increases and the regeneration efficiency drops. The coefficient of performance (COP) of the liquid desiccant based system decreases sharply when the fresh air ratio exceeds 60%. The results also show that the proposed system can save power notably. The maximum power saving ratio is 58.9% when the fresh air ratio is 20%; however, the ratio drops when the fresh air ratio increases. These findings will be beneficial in the selection of fresh air ventilation strategies for liquid desiccant based air-conditioning systems. 相似文献
14.
热泵驱动的双级溶液调湿新风机组原理及性能测试 总被引:3,自引:1,他引:2
介绍了一种新型热泵驱动的双级溶液调湿新风机组的工作原理和全年运行方式,重点介绍和分析了该机组主要部件的实测性能数据.测试结果表明,双级溶液全热回收单元的全热回收效率和潜热回收效率分别为55%左右,而新风机组在满负荷工况下整机COP为5.0,部分负荷下可超过5.9,其中的热泵制冷系统在满负荷工况下COP为4.01,部分负荷下可超过5.72,溶液热回收板式换热器的显热回收效率在80%以上.测试分析了机组进行新风处理的整体性能,指出了在再生单元补水的重要性. 相似文献
15.
16.
Liquid desiccant regeneration has important effect on performance of a liquid desiccant air conditioning system. Compared with conventional packed regenerator, internally heated regenerator is proposed to achieve better regeneration performance. This study emphasized on both regeneration rate and regeneration thermal efficiency to evaluate the performance of both regenerators. A validated heat and mass transfer model was used to analyse and compare the performance of internally heated and adiabatic regenerators. The results indicated that internally heated regenerator not only could increase the regenerate rate, but also could exhibit higher energy utilization efficiency. Different from adiabatic regenerator, internally heated regenerator can provide comparable regeneration efficiency and regeneration rate at low desiccant flow rate, so it should be a good alternative to avoid carryover of desiccant droplets. Higher air flow rate would result in a deduction of regeneration thermal efficiency although achieving higher regeneration rate. Suitable flow rate of the air should be considered carefully in liquid desiccant regeneration. The internally regenerator could have considerable prospect in liquid desiccant air conditioning application. 相似文献
17.
Existing desiccant cooling systems reduce the temperature of process air either by adopting evaporative coolers or incorporating vapor compression systems. While the former is restricted by inaccurate control, the latter still consumes certain quantity of electric power. To solve this problem, a thermally driven air conditioning system, which combines the technologies of rotary desiccant dehumidification and regenerative evaporative cooling, has been proposed and investigated. In addition to dehumidification, the system is capable of producing chilled water, thereby realizing separate temperature and humidity control without increasing electrical load. To find out the characteristics of produced chilled water and evaluate the feasibility and energy saving potential of this novel system, a mathematical model has been developed. Case studies have been conducted under Air conditioning and Refrigeration Institute (ARI) summer, ARI humid and Shanghai summer conditions. It is found that the system can achieve a thermal COP higher than 1.0 and an electric COP about 8.0. The temperature of chilled water produced by the system is around 14–20 °C. This chilled water can be used with capillary tube mats for radiant cooling. It is suggested that the system can also be designed as a standalone chilled water plant. As a desiccant dehumidification-based chilled water producing technology, this would expand desiccant cooling to a boarder niche application. The effects of chilled water flow rate, air distribution ratio, inlet air conditions and regeneration temperature have been analyzed in detail. Reachable handling regions, which will be helpful to system design and optimization, have been obtained. 相似文献
18.
常规跨临界二氧化碳空调循环的性能系数对气体冷却器出口工质温度十分敏感,该温度越低,同等条件下性能越好。为了提高制冷量和性能系数,在常规循环基础上引入了融冰过冷器以大幅度降低气体冷却器出口工质温度。基于压缩机等熵效率实验数据对融冰过冷二氧化碳空调循环进行了计算,重点分析了循环高压对系统性能的影响。计算结果表明:引入融冰过冷能大幅度提高系统性能系数,并且在循环高压较低时更为明显。在典型的应用范围内,融冰过冷循环不存在使性能系数最大的优化高压。当其他参数一定时,高压越高,性能系数越低。与常规无融冰过冷循环不同,中间换热器的引入不利于性能系数的提高,因此在进行多运行模式的实际系统设计时应予折中考虑。本文的分析结果可为实际系统设计和运行提供指导。 相似文献