Computed microtomography evaluation of calcium hydroxide‐based root canal dressing removal from oval root canals by different methods of irrigation

The aim of this study was to evaluate the capacity of conventional irrigation, passive ultrasonic irrigation (PUI), and Easy Clean for removing calcium hydroxide‐based root canal dressing from oval root canals. Thirty mandibular uniradicular incisors with oval canals were used, and subjected to chemical–mechanical preparation with Reciproc R40 instruments. The main canal was filled with a paste based on Ca(OH)₂ P.A., iodoform and propylene glycol in the ratio of 3:1:1. The teeth were stored in 100% humidity at a temperature of 37°C for 14 days. Afterwards, the teeth were divided into three groups (n = 10) according to the method of irrigation used (conventional irrigation, PUI, and Easy Clean). The specimens were analyzed by computed microtomography at three time intervals: before placing the root canal dressing, with the root canal dressing in place, and after application of the irrigation methods for removing it. The data were submitted to Kruskal–Wallis and Dunn tests for analyzing the canal as a whole, and Friedman and Dunn for analyzing the root thirds. The results showed that conventional irrigation was less efficient for removing the root canal dressing in comparison with the methods that agitated the irrigant solution (p < .05). When the root canal was analyzed as a whole, Easy Clean, and PUI were similar (p > .05). In analysis of the thirds, Easy Clean was more efficient than conventional irrigation in all the thirds, while PUI showed this behavior only in the cervical third (p < .05). The authors concluded that in oval canals, none of the irrigation methods were capable of removing all the root canal dressing, however, the methods that agitated the irrigant solution were more efficient than conventional irrigation.     

Comparison of three‐dimensional analysis and stereological techniques for quantifying lithium‐ion battery electrode microstructures

Lithium‐ion battery performance is intrinsically linked to electrode microstructure. Quantitative measurement of key structural parameters of lithium‐ion battery electrode microstructures will enable optimization as well as motivate systematic numerical studies for the improvement of battery performance. With the rapid development of 3‐D imaging techniques, quantitative assessment of 3‐D microstructures from 2‐D image sections by stereological methods appears outmoded; however, in spite of the proliferation of tomographic imaging techniques, it remains significantly easier to obtain two‐dimensional (2‐D) data sets. In this study, stereological prediction and three‐dimensional (3‐D) analysis techniques for quantitative assessment of key geometric parameters for characterizing battery electrode microstructures are examined and compared. Lithium‐ion battery electrodes were imaged using synchrotron‐based X‐ray tomographic microscopy. For each electrode sample investigated, stereological analysis was performed on reconstructed 2‐D image sections generated from tomographic imaging, whereas direct 3‐D analysis was performed on reconstructed image volumes. The analysis showed that geometric parameter estimation using 2‐D image sections is bound to be associated with ambiguity and that volume‐based 3‐D characterization of nonconvex, irregular and interconnected particles can be used to more accurately quantify spatially‐dependent parameters, such as tortuosity and pore‐phase connectivity.     

Adaptive striping watershed segmentation method for processing microscopic images of overlapping irregular‐shaped and multicentre particles

Oversegmentation is a major drawback of the morphological watershed algorithm. Here, we study and reveal that the oversegmentation is not only because of the irregular shapes of the particle images, which people are familiar with, but also because of some particles, such as ellipses, with more than one centre. A new parameter, the striping level, is introduced and the criterion for striping parameter is built to help find the right markers prior to segmentation. An adaptive striping watershed algorithm is established by applying a procedure, called the marker searching algorithm, to find the markers, which can effectively suppress the oversegmentation. The effectiveness of the proposed method is validated by analysing some typical particle images including the images of gold nanorod ensembles.     

Efficacy of the photon‐initiated photoacoustic streaming combined with different solutions on Enterococcus faecalis in the root canals

This study aimed to evaluate the efficacy of different irrigation solutions used in photon‐initiated photoacoustic streaming (PIPS) or conventional needle irrigation (CNI) for eradication of Enterococcus faecalis from artificial root canals. Altogether, 240 artificial root canal samples were included. The models were split and incubated for 2 days to allow formation of E. faecalis biofilm. The models were randomly divided into two groups (n = 120): CNI and laser‐activated irrigation (LAI). Each group was divided into six subgroups according to different irrigation solutions: distilled water, 1% sodium hypochlorite (NaOCl), 2% NaOCl, 5.25% NaOCl, MTAD, and chlorhexidine, respectively. After irrigation, half of the samples (n = 10) were assessed immediately, and the other half of the samples (n = 10) were incubated for 6 hr. Bacterial suspensions were obtained from all samples before and after irrigation, and after incubation, and were quantified adenosine 5′‐triphosphate (ATP) assay kit. The biofilms were examined using fluorescent microscopy and analyzed by Image Pro Plus software. Significant reduction of ATP, average fluorescence density after irrigation, and growth after incubation was obtained in LAI group than in CNI group (p < .05). LAI can improve bacteriostasis effect of 2% NaOCl (p < .05). PIPS improved the antibacterial effect of the 2% NaOCl used in root canal therapy.     

A cone‐beam computed tomography study of the anatomical relationships between mandibular teeth and the mandibular canal,with a review of the current literature

The purpose of this study was to evaluate age‐ and sex‐related changes in the anatomical relationships between the roots of the molars and premolars and the mandibular canal using cone‐beam computed tomography (CBCT) images. A total of 243 patients (116 males, 127 females) aged 16–83 years for whom previous CBCT scans were available were enrolled in this study. The patients were subcategorized by sex and age (Group I, <21 years; Group II, 21–40 years; and Group III, >40 years). The distances between the mandibular canal and the molars and premolars were measured. The mandibular canal was significantly closer to the root apices of the second and third molars than to the apices of other evaluated teeth (p < 0.05). All measurements were significantly higher in male than in female subjects (p < 0.05). Group I subjects exhibited significantly shorter distances between the mandibular canal and root apices of the first and second premolars, and the molars, than those of Group II and III subjects (p < 0.05). Direct contact relationships were found in 1.6%, 3.3%, 3.3%, 16%, and 32.2% of teeth (running from the first premolar to the third molar, respectively). Age and sex influenced the anatomical relationships between mandibular teeth and the mandibular canal, and these should be considered when planning endodontic and surgical procedures to avoid potential nerve injury.     

On the influence of lipid‐induced optical anisotropy for the bioimaging of exo‐ or endocytosis with interference microscopic imaging

Some implementations of interference microscopy imaging use digital holographic measurements of complex scattered fields to reconstruct three‐dimensional refractive index maps of weakly scattering, semi‐transparent objects, frequently encountered in biological investigations. Reconstruction occurs through application of the object scattering potential which assumes an isotropic refractive index throughout the object. Here, we demonstrate that this assumption can in some circumstances be invalid for biological imaging due to the presence of lipid‐induced optical anisotropy. We show that the nanoscale organization of lipids in the observation of cellular endocytosis with polarized light induces a significant change in far‐field scattering. We obtain this result by presenting a general solution to Maxwell's equations describing light scattering of core–shell particles near an isotropic substrate covered with an anisotropic thin film. This solution is based on an extension of the Bobbert–Vlieger solution for particle scattering near a substrate delivering an exact solution to the scattering problem in the near field as well as far field. By applying this solution to study light scattering by a lipid vesicle near a lipid bilayer, whereby the lipids are represented through a biaxial optical model, we conclude through ellipsometry concepts that effective amounts of lipid‐induced optical anisotropy significantly alter far‐field optical scattering in respect to an equivalent optical model that neglects the presence of optical anisotropy.     

Electron microscopic observations of stomata,epicuticular waxes,and papillae in Chamaecyparis obtusa: Reconsidering the traditional concept of Y‐shaped white stomatal bands

The foliar morphological characters of hinoki (Chamaecyparis obtusa) were revisited using optical and scanning electron microscopy. In C. obtusa, typical Y‐shaped white stomatal bands were evident on the abaxial leaf surfaces. Two facial leaves and two lateral leaves were observed at the same node. Waxy papillae and oval stomata were arranged in two or three rows with protuberant rims on the abaxial leaf surfaces. Higher magnifications revealed the deposition of epicuticular waxes (tubules) on the Y‐shaped white stomatal bands. Given the absence of stomatal bands after dewaxing with organic solvents, the white stomatal bands in C. obtusa were related to the epicuticular waxes rather than the presence of aggregated stomata alone. In contrast to C. obtusa, a single median leaf and two lateral leaves were observed at the same node of oriental arborvitae (Platycladus koraiensis). Neither stomatal bands nor papillae were observed on P. koraiensis leaves. The stomatal density and epicuticular waxes in the stomatal regions of C. obtusa were higher than those of P. koraiensis. This study suggests that the traditional concept of Y‐shaped white stomatal bands in C. obtusa should be revised to describe the arrangement of the aggregated waxy stomata that occur in rows.     

A rabbit maxillary sinus model with simultaneous customized‐implant placement: Comparative microscopic analysis for the evaluation of surface‐treated implants

We describe the use of a rabbit maxillary sinus model, characterized by thin osseous tissue and low bone density, for the evaluation of surface‐treated implants by histologically and histomorphometrically comparing the osseointegration patterns depending on the surface treatment methods. Twenty rabbits were randomly assigned to two groups of 10 animals, one receiving 5 × 3 mm customized implants (machined, MA or sandblasted and acid etched, SLA) placed in sinus and the other receiving implants placed in a tibia. Histological observation of the implant placed in sinus shows relatively more active new bone formation, characterized by trabecular bone pattern underneath the cortical bone in sinus as compared with that in tibia. Histomorphometric analysis in the rabbits receiving implants in a tibia, the NBIC (%) associated with the SLA surface implant was greater than that associated with the MA implant at 2 weeks (55.63 ± 8.65% vs. 47.87 ± 10.01%; P > 0.05) and at 4 weeks (61.76 ± 9.49% vs. 42.69 ± 10.97%; P < 0.05). Among rabbits receiving implants in a sinus, the NBIC (%) associated with the SLA surface implant was significantly greater than that associated with the MA surface implant both at 2 weeks (37.25 ± 7.27% vs. 20.98 ± 6.42%; P < 0.05) and at 4 weeks (48.82 ± 6.77% vs. 31.51 ± 9.14%; P < 0.05). As a result, we suggest that the maxillary sinus model is an appropriate animal model for assessing surface‐treated implants and may be utilized for the evaluation of surface‐treated implants in poor bone quality environment. Microsc. Res. Tech. 78:697–706, 2015. © 2015 Wiley Periodicals, Inc.     

Adhesive interface and bond strength of endodontic sealers to root canal dentine after immersion in phosphate‐buffered saline

This study evaluated the bond strength (BS) and the adhesive interface of four endodontic sealers to root canal dentine, before, and after immersion in phosphate buffered saline (PBS) to simulate an in vivo environment. Eighty roots were instrumented using ProTaper rotatory files, under irrigation with 17% EDTA and 1% NaOCl. Posteriorly were divided into four groups (n = 20) according to the sealer used: Endofill, AH Plus, Sealapex, and MTA Fillapex. Each group was divided into two subgroups (n = 10) and stored at 37°C immersed in water for 7 days and in PBS for 60 days. From each subgroup, 1 mm thick sections were obtained. One section of each region (coronal, middle, and apical) was submitted to the push‐out test and failures were observed. Twelve sections of each subgroup (four from each region) were evaluated under SEM. Three‐way ANOVA evaluation for BS showed significant differences between groups and regions (P < 0.0001), but not between subgroups (P > 0.05). AH Plus had significantly higher BS than the others sealers, regardless of the analyzed subgroup (Tukey's test, P < 0.5). The most common failures were adhesive to dentine and cohesive of the sealer. The SEM evaluation (Kruskal–Wallis, Mann–Whitney) showed homogeneous adhesive interface formed and sealer tags in all groups with significant statistical differences with AH Plus, regardless of PBS immersion. AH Plus was superior to the other sealers for both BS and quality of interface formation. Immersion in PBS did not interfere on BS or adhesive interface of the sealers tested. Microsc. Res. Tech. 77:1015–1022, 2014. © 2014 Wiley Periodicals, Inc.