Efficient cw end-pumped, end-cooled Nd:YVO(4) diode-pumped laser

Using a novel end-pumped, end-cooled geometry, we demonstrated a Nd:YVO(4) cw laser that produces close to 2 W of single-mode output when pumped by a high-brightness 100-mum-core diode fiber source. An optical-optical conversion efficiency of 49% was obtained. Beam quality was found to be nearly diffraction-limited (M(2) = 1.08) and independent of pumping power.     

Transverse-mode astigmatism in a diode-pumped unstable resonator Nd:YVO(4) laser

We have observed a sizable astigmatism in the output beam from a diode-pumped unstable resonator Nd:YVO(4) laser operating in a single polarization and a single-longitudinal and transverse mode. The anisotropic index of refraction of the vanadate crystal has been identified as the source of this astigmatism. A theoretical prediction of the eigenmode astigmatism based on this index anisotropy is consistent with our experimental measurements.     

Passively Q-switched multi-wavelength Nd:YVO4 self-Raman laser

Abstract

Multi-wavelength self-Raman laser from a passively Q-switched c-cut Nd: YVO₄ laser at 1066.8 nm to four discrete Stokes lines at 1097.2, 1129.2, 1168.3 and 1178.8 nm is demonstrated simultaneously for the first time. With a 0.27 at% c-cut Nd:YVO₄ crystal, the total output power of Stokes lines is 267 mW at a pump power of 5.0 W.     

Fluorescence feedback control of an active Q-switched diode-pumped Nd:YVO4 laser

We have implemented active feedback control in a Q-switched diode-pumped Nd:YVO(4) laser by monitoring the fluorescence intensity from the laser crystal. When the initial inversion level indicated by the detected fluorescence has reached a predetermined value, Q switching is initiated. This scheme allowed us to vary the reproducibility of the output pulse peak power and pulse width. The novel active Q-switching approach can reduce the shot-to-shot variations of the output pulse peak power and the pulse width.     

Single-frequency, thin-film-tuned, 0.6-W, diode-pumped Nd:YVO(4) laser

Application of a metallic thin-film selector to the single-frequency oscillation of a diode-pumped Nd:YVO(4) laser has been investigated theoretically and experimentally. We show that a chromium thin-film selector with a thickness between 8 and 9 nm provides single-frequency output within a power range of 0.6 W. Single-frequency operation, slow smooth tuning, or chirping was realized by the output coupler movement with a piezoceramic transducer. Chirping at a repetition rate of 0.5 kHz in the 0.5-10-GHz range was achieved. Physical and technical limitations caused by the wide-gain bandwidth, thermal effects, and mechanical vibrations of cavity elements are discussed.     

Double-end-pumped Nd:YVO4 slab laser at 1064 nm

We demonstrate a high-power laser diode stacks double-end-pumped Nd:YVO4 1064 nm slab laser with a folded stable-unstable hybrid resonator. An output power of 220 W was obtained at the pump power of 490 W with optical conversion efficiency of 44.9%. At the output power of 202 W, the M2 factors in the unstable direction and in the stable direction were 1.7 and 2.3, respectively.     

Near shot-noise-level relative frequency stabilization of a laser-diode-pumped Nd:YVO(4) microchip laser

A laser-diode-pumped Nd:YVO(4) microchip laser was built and actively frequency stabilized relative to a Fabry-Perot cavity with the frequency-modulated sideband technique. The error signal reaches the shot-noise level of 7.4 mHz/√Hz around 1 kHz. Excess intensity noise sets a lower limit of16.5 mHz/√Hz for the relative frequency noise, corresponding to a spectral linewidth of 860 μHz. We discuss the method for reconstructing the actual frequency deviation from the observed error signal.     

Passively Q-switched Nd:YVO(4) laser with a Cr(4+):YAG crystal saturable absorber

We demonstrate, for the first time as far as we know, a passively Q-switched operation of a Nd:YVO(4) laser in which a Cr(4+):YAG crystal and a laser-diode bar are used as the saturable absorber and the pump source, respectively. Stable laser pulses as short as 28 ns with 20-muJ energy can be generated with this laser, which has the advantages of simplicity, high efficiency, and good long-term stability.     

Noise characteristics of a Nd:YVO(4) laser pumped by laser diode modulated at high frequency

We report, for the first time to our knowledge, on the noise characteristics of a Nd:YVO(4) laser pumped by a laser diode modulated at high frequency. We have investigated noise characteristics of a Nd:YVO(4) laser pumped by a laser diode that is oscillating in a stable multilongitudinal mode because of modulation by a high-frequency (several hundred megahertz) current. As a result, low-noise operations of -130 dB/Hz above frequencies of 1 MHz have been achieved. This noise level is comparable to the level obtained when pumping a Nd:YVO(4) laser with a laser diode that is oscillating in a single longitudinal mode. However, a noise peak corresponding to relaxation oscillations of the Nd:YVO(4) laser has appeared around a frequency of several hundred kilohertz.     

Semianalytical thermal analysis on a Nd:YVO(4) crystal

Based on analytical theory of anisotropy, distributions of thermal distortion and temperature field within a diode-end-pumped rectangular Nd:YVO(4) laser crystal are investigated. A thermal model that matches the actual working state of the laser crystal is established by analyzing the working characteristics of the Nd:YVO(4) laser crystal. A novel method, to the best of our knowledge, is adopted to solve the heat conduction equation of the anisotropic medium. General solutions of the temperature field, thermal strain field, and thermal distortion field of the Nd:YVO(4) crystal are obtained. The effect of anisotropic thermal parameters on the thermal strain field of the Nd:YVO(4) laser crystal is also analyzed quantitatively. Research results show that a maximum temperature rise of 244.9 degrees C and a maximum thermal distortion of 1.99 mum can be obtained in the center of the pump face when the Nd:YVO(4) laser crystal doped with 0.5 at. % Nd(3+) is diode end pumped in the center of the front end face with 15 W output power. This method can be applied to other thermal analyses of laser crystals and offers a theoretical basis to solve thermal problems effectively in the laser system.     

Polarization-Dependent Periodic Pulse Oscillation in a Diode-Laser-Pumped and Intracavity Frequency-Doubled Nd:YVO 4 Laser

We demonstrate that two cross-polarized longitudinal modes can have 50% higher conversion efficiency than two parallel-polarized longitudinal modes in a diode-laser-pumped and intracavity frequency-doubled Nd:YVO(4) laser when operated under periodic pulse oscillation. Through simulations of the rate equations for primary frequency intensities and gains, we also verify that this effect can be attributed to gain competition and complementary conversion coefficient between second-harmonic and sum-frequency generations.     

Diode-laser-array end-pumped 1W CW Nd:YVO4/BIBO green laser

Abstract

This paper discusses a diode-laser-array end-pumped Nd:YVO₄/BIBO green laser. Using a three-mirror folded cavity (V-shaped), a 1.06 W CW green output was obtained at an incident pump power of 8.5 W; the corresponding optical conversion efficiency was 12.5%. The relationship between the green output and the temperature of the BIBO crystal was investigated. The laser damage threshold of BIBO crystal was measured to be 600 MW cm^?2 and 400 MW cm^?2 at 1064 nm and 532 nm, respectively.     

High-repetition rate Q-switched Nd:YVO4 laser with a composite semiconductor absorber

A diode-pumped Nd:YVO4 laser passively Q switched by a semiconductor absorber is demonstrated. The Q-switched operation of the laser has an average output power of 135 mW with a 1.6 W incident pump power. The minimum pulse width is measured to be about 8.3 ns with a repetition rate of 2 MHz. To our knowledge, this is the first demonstration of a solid-state laser passively Q-switched by such a composite semiconductor absorber.     

Four watt long-term stable intracavity frequency-doubling Nd:YVO(4) laser of single-frequency operation pumped by a fiber-coupled laser diode

The longitudinal-mode stability of a single-frequency intracavity frequency-doubling laser can be enhanced by increasing the ratio between the nonlinear spectral bandwidth and the gain bandwidth of the laser. A 4 W long-term stable cw single-frequency green laser is obtained using an etalon inside the laser cavity as a spectral filter. No mode hopping is observed when the laser operates for 6 h and the power fluctuation is less than +/-1.2%. In contrast, in the situation of no etalon inside the laser cavity, mode hopping can be observed at irregular intervals and the power fluctuation is +/-3.8% when the laser operates for 4 h.     

Comparison on performance of passively Q-switched laser properties of continuous-grown composite GdVO4/Nd:GdVO4 and YVO4/Nd:YVO4 crystals under direct pumping

The comparison on performance of passively Q-switched laser properties of continuous-grown composite GdVO(4)/Nd:GdVO(4) and YVO(4)/Nd:YVO(4) crystals under direct pumping to the emitting level was demonstrated. A Cr(4+):YAG crystal was used as saturable absorber. At an incident pump power of 10 W, the average output power, the pulse width, the repetition rate, the pulse energy, and the peak power for a GdVO(4)/Nd:GdVO(4) laser were 1.22 W, 48.1 ns, 121 kHz, 10.1 μJ, and 209.6 W, respectively. And for a YVO(4)/Nd:YVO(4) laser under the same conditions, these output characteristics were 1.26 W, 44.9 ns, 218 kHz, 5.8 μJ, and 128.7 W, respectively.     

Intracavity frequency doubling and Q switching in diode-laser-pumped Nd:YVO(4) lasers

A highly efficient and compact Nd:YVO(4) laser is proposed. In cw operation, a single-longitudinal-mode output of 95 mW and a multilongitudinal-mode output of 435 mW have been observed at 1.06 μm with a 1-W diode laser. Using a KTP crystal in the short laser cavity, a green output of 105 mW was generated. A Q-switched pulse with a peak power of 230 W and a pulse width of 8 ns was obtained with the intracavity KTP crystal, which was used as both an electro-optic Q switch and a frequency doubler.     

Diode-end-pumped,electro-optically Q-switched Nd:YVO4 slab laser and its second-harmonic generation

We describe the operation of a near-diffraction-limited, 1,064-nm electro-optically Q-switched Nd:YVO4 slab laser that is end pumped by laser-diode stacks and its efficient second-harmonic generation by using a lithium triborate (LBO) crystal. The energy per pulse of 3.6 and 0.8 mJ and pulse widths of 5 and 13.5 ns were obtained at repetition of 5 and 40 kHz, respectively. With a LBO crystal, a maximum output power of 15.6 W at 532 nm was obtained at the repetition rate of 40 kHz, the corresponding conversion efficiency was 60%, and the pulse width was 11.3 ns. At 10 kHz, the pulse energy of 532 nm was 1.2 mJ, and the pulse width was 5 ns.     

Passively Q-switched Nd:YVO4 waveguide laser using graphene as a saturable absorber

We report on passively Q-switched lasers in femtosecond laser written waveguide in Nd:YVO₄ crystal. Using graphene as a saturable absorber, passively Q-switched waveguide laser operations are achieved along both TE and TM polarizations with single modal profiles. Furthermore, all-angle linear light pump was utilized to investigate the thorough information of the polarization effects of the laser, showing that the optimum polarization for laser generation is TE. The maximum average output power is estimated to be 129 mW with 12.2% slope efficiency, corresponding to single-pulse energy of 8.1 nJ, pulse duration of 25.0 ns and repetition rate of 16.3 MHz.     

Compact and efficient Nd:YVO 4 laser that generates a tunable single-frequency green output

We demonstrate 250 mW of single-frequency 532-nm output from a simple intracavity-doubled Nd:YVO(4) laser, pumped with 1.2 W from a fiber-coupled diode laser. The laser can be frequency chirped smoothly over ~17 GHz while maintaining a single-frequency green output of greater than 200 mW. A short Fabry-Perot cavity is used, and single-frequency operation is enforced by means of a birefringent filter that utilizes the birefringence of both the KTP doubling crystal and the Nd:YVO(4) laser crystal with polarization-dependent loss from a glass Brewster plate combined with polarization-dependent gain from the laser crystal.     

抽运条件对Nd:YVO4增益开关激光器输出特性的影响

通过数值求解增益开关速率方程,模拟得到Nd:YVO4增益开关激光器输出脉宽和峰值功率随抽运条件的理论变化曲线,在此基础上提出了减小增益开关固体激光器输出脉宽的方法,即:令抽运源LD的直流驱动电流接近阈值,叠加脉冲电流高于2倍阈值,并调节抽运脉宽保证单脉冲激光输出。实验结果与理论曲线符合较好,证实了这一方法的有效性。利用此方法最终获得了脉宽20ns、重复频率在1Hz-4kHz精确可控的1.064μm脉冲激光输出。