共查询到20条相似文献,搜索用时 15 毫秒
1.
通过对几种常用环氧树脂常温固化剂性能的比较和应用结果表明,以天然腰果壳油合成的长链的取代酚醛胺固化剂,具有优异的综合防护性能,是环氧树脂高性能化的一种途径。 相似文献
2.
3.
4.
D Skinner 《Surface Coatings International Part B: Coatings Transactions》1997,80(6):274-278
Conclusions The result from the study indicate:
相似文献
1. | UV curable coatings are responsive to changes in UV intensity as well as UV dose. |
2. | A general trend can be observed where moving to higher intensity UV energy can lead to faster speeds producing the same degree of ‘cure’. |
3. | The type of photoinitiator plays a crucial role in determining the relative efficiency of high intensity UV light. Habstraction photoinitiators such as benzophenone/amine systems, which respond predominantly to short wave-length UV, derive only limited benefit from increasing the intensity of the UV energy. |
4. | Increasing the UV intensity allows lower levels of photoinitiator to be used. |
5. | Use of the excimer lamp offers even greater potential for reducing photoinitiator levels. Typical results using 1907 and KIP 100F show that the photoinitiators level can be reduced from 4% to at least 1% and without any reduction in cure speed. |
5.
6.
环氧树脂涂料用脂肪族二胺加成物固化剂 总被引:6,自引:0,他引:6
杜邦中国集团有限公司 《粘接》2000,21(6):14-16
介绍了一类性能独特的脂肪族和脂环族二胺加成物环氧固化剂,其毒性低、气味小。用其制备的涂料具有良好的耐化学腐蚀性、高硬度和良好的光泽性。 相似文献
7.
聚异氰酸酯固化剂在热固性氟粉末涂料中的应用 总被引:1,自引:0,他引:1
探讨了聚异氰酸酯固化剂交联反应机理。介绍了热固性氟粉末涂料的制备,分析了选择不同类型的聚异氰酸酯固化剂对热固性氟粉末涂膜性能的影响,从而制得了综合性能优异的热固性氟粉末涂料。 相似文献
8.
9.
10.
A novel, waterborne epoxy system comprised of non-ionic stabilized dispersions of a solid epoxy resin and an amine curing
agent has been designed for ambient-cure coatings. The performance characteristics of coatings formulated from the new system
have been compared to a standard system. The new system produced formulated coatings with robust performance over a wide range
of amine-to-epoxy stoichiometries (65 to 130%). At 100% stoichiometry, the new system was found to have lower VOC, faster
hardness development, better gloss, and higher impact resistance than the standard system. The new formulations also exhibited
superior water and salt spray resistance, and a definitive viscosity rise at the end of potlife. Unlike the standard system,
coating morphology of the new waterborne system was found to be similar to a solvent-based coating. For the new system, good
coalescing solvents, as judged by gloss and gloss potlife, were found to have low solubility parameters and high boiling points.
Presented at the 76th Annual Meeting of the Federation of Societies for Coatings Technology, on October 15, 1998, in New Orleans,
LA.
P.O. Box 1380, Houston, TX 77251-1380. 相似文献
11.
交联剂在室温固化双组分水性涂料中的应用 总被引:1,自引:0,他引:1
用多异氰酸酯型、氮丙啶型和环氧基型三种室温固化交联剂分别固化丙烯酸聚氨酯分散体水性涂料,测定并比较了交联涂膜的性能。结果发现,环氧型交联剂固化的产物综合性能最好,主要表现在涂膜硬度、附着力、耐水性、耐溶剂性、耐污渍性和耐烫性上比未交联涂料和其他两种交联剂固化的涂料要好得多。此外,配漆后的适用期很长,施工方便程度类似于单组分涂料。 相似文献
12.
13.
14.
High performance coatings based on novel penetrative curing: Cationic electrodeposition coatings cured at ambient temperature 总被引:1,自引:0,他引:1
Yasuharu Nakayama 《Journal of Coatings Technology》1997,69(875):33-39
Cationic electrodeposition coatings were cured with a penetrative crosslinker at ambient temperature. This method is based
on a novel technology in which coating films are dipped in aqueous crosslinker solution which moves into the film, accompanied
by crosslinking. Pencil hardness, impact strength, solvent resistance and water resistance were improved with dipping time,
that is, with the penetration of crosslinking. On the contrary, corrosion resistance was controlled by two opposing factors
arising from the crosslinking—strengthening of the coating barrier property and weakening of the adhesion force. Excellent
protective coatings were obtained by selection of resins and control of crosslinking.
This system is well suited for the coatings on huge, complex structures in finished condition incorporated with glass, plastic,
etc.
17-1, Higashi Yawata 4-Chome, Hiratsuka-Shi, 254. 相似文献
15.
16.
17.
《涂料技术与文摘》2005,26(1):38-39
通过UV固化低聚物助剂网络体系控制清漆原位流变性:US2004—151 843[美国专利申请公开],美国:Ford Global.Technologies,Inc.(Weingartz,Timothy P).聚光灯中UV固化氨基甲酸酯丙烯酸酯[刊,英]/Fischer.Wolfgang等//European Coatings Journal .可辐射固化液态树脂组合物及其涂布的光纤:JP2004-182 860[日本专利公开],日本:Shin-Etsu Chemical Industry Co.,Ltd.(Ueno,Masaya等).UV固化涂料组合物:JP2004-224 961[日本专利公开],日本:Dainippon Ink and Chemicals,Inc.(Takayanagi.Yasuo). 相似文献
18.
19.
《涂料技术与文摘》2005,26(2):39-40
0502081 含有羟基胺酯引发剂的涂料组合物及IR/UV固化涂层:WO2004-81 100[国际专利申请,英]/瑞士:Ciba Specialty Chemicals Holding Inc.(Wolf,Jean-Piece等);0502082 用于可固化作为耐污改性剂的热稳定型光固化组合物:JP2004-168 896[日本专利公开]/日本:Asahi Glass Co.,Ltd.(Futami,Tatsuhiro等);0502083 UV固化聚合物组合物及其涂装的光盘:JP2004-256 681[日本专利公开]/日本:Dainippon Ink and Chemicals,Inc.(Saito,Koichi等);0502084 UV固化热熔融胶粘剂:WO2004-83 302[国际专利申请,德]/瑞士:Collano Ag(Christelle等);0502085 贮存稳定性和附着力优异的热固性可辐射固化的树脂组合物及其固化工艺:JP2004-285 119[日本专利公开]/日本:Arakawa Chemical Industries,Ltd.(Konda,Masaaki等)。 相似文献