Temperature-dependence of barrier height of swift heavy ion irradiated Au/n-Si Schottky structure

The electrical characteristics of swift heavy ion (SHI) irradiated Au/n-Si (1 0 0) structure has been investigated in a wide temperature range (50–300 K). The forward bias current–voltage (I–V) measurements have been used to extract the diode parameters as a function of temperature. The Zero-bias Schottky barrier height decreases with decreasing temperature. However, the flat-band barrier height is almost independent of the temperature. These results are interpreted using the models of Fermi level pinning. The behavior of Schottky diode parameters is explained by taking into account the role of the irradiation induced defects at Au/n-Si (1 0 0) interface.     

Analysis of interface states and series resistance of MIS Schottky diodes using the current-voltage (I-V) characteristics

The purpose of this paper is to analyze interface states in Al/SiO₂/p-Si (MIS) Schottky diodes and determine the effect of SiO₂ surface preparation on the interface state energy distribution. The current-voltage (I-V) characteristics of MIS Schottky diodes were measured at room temperature. From the I-V characteristics of the MIS Schottky diode, ideality factor (n) and barrier height (Φ_B) values of 1.537 and 0.763 eV, respectively, were obtained from a forward bias I-V plot. In addition, the density of interface states (N_ss) as a function of (E_ss-E_v) was extracted from the forward bias I-V measurements by taking into account both the bias dependence of the effective barrier height (Φ_e), n and R_s for the MIS Schottky diode. The diode shows non-ideal I-V behaviour with ideality factor greater than unity. In addition, the values of series resistance (R_s) were determined using Cheung’s method. The I-V characteristics confirmed that the distribution of N_ss, R_s and interfacial insulator layer are important parameters that influence the electrical characteristics of MIS Schottky diodes.     

Ballistic electron emission microscopy studies of the temperature dependence of Schottky barrier height distribution in CoSi2/n-Si(1 0 0) diodes formed by solid phase reaction

Ballistic electron emission microscopy (BEEM) and ballistic electron emission spectroscopy have been performed on polycrystalline and epitaxial CoSi₂/n-Si(1 0 0) contacts at temperatures ranging from −144°C to −20°C. The ultra-thin CoSi₂ films (10 nm) were fabricated by solid state reaction of a single layer of Co (3 nm) or a multilayer of Ti (1 nm)/Co (3 nm)/amorphous-Si(1 nm)/Ti (1 nm) with a Si substrate, respectively. The spatial distribution of barrier height over the contact area obeys a Gaussian function at each temperature. The mean barrier height increases almost linearly with decreasing temperature with a coefficient of −0.23±0.02 meV/K for polycrystalline CoSi₂/Si diodes and −0.13±0.03 meV/K for epitaxial diodes. This is approximately equal to one or one-half of the temperature coefficient of the indirect energy gap in Si, respectively. It suggests that the Fermi level is pinned to different band positions of Si. The width of the Gaussian distribution is about 30–40 meV, without clear dependence on the temperature. The results obtained from conventional current–voltage and capacitance–voltage (I–V/C–V) measurements are compared to BEEM results.