共查询到20条相似文献,搜索用时 234 毫秒
1.
高尾矿坝——地基相互作用的地震反应分析研究 总被引:1,自引:0,他引:1
柳厚祥 《冶金矿山设计与建设》1998,30(6):7-12,61
在研究高尾矿坝的抗震性能基础上,提出了考虑高尾矿坝-地基相互作用的地震反应分析计算模型,并建立了尾矿单元的物理模型。介绍了其动力平衡方程的建立和求解方法,通过对武钢大冶炼矿白雉山尾矿坝的地震反应分析,考虑高尾矿坝-地基相互作用,坝体动位移增大15% ̄20%,坝体的动应力增加10%左右。 相似文献
2.
在研究高尾矿坝的抗震性能基础上,提出了考虑高尾矿坝—地基相互作用的地震反应分析计算模型,并建立了尾矿单元的物理模型。介绍了其动力平衡方程的建立和求解方法,通过对武钢大冶铁矿白雉山尾矿坝的地震反应分析,考虑高尾矿坝—地基相互作用,坝体动位移增大15%~20%,坝体的动应力增加10%左右。 相似文献
3.
玲珑金矿尾矿坝Duncan-Chang非线性静力计算分析 总被引:1,自引:0,他引:1
介绍了利用Duncan-Chang双曲线E-模型,对尾矿坝初始静力状态进行非线性计算分析的基本原理和计算过程.根据工程地质环境、土体物理力学特性,以主坝中心为剖面建立几何模型.采用GeoStudio软件Duncan-Chang双曲线E-模型,对玲珑金矿尾矿坝进行了非线性静力计算,得到了静力状态下坝内最大主应力、最小主应力、水平和垂直位移、应力水平、最大剪应力和剪应变、最大XY方向剪应力和剪应变,并结合计算结果,对玲珑金矿尾矿坝静力状态稳定性进行了细致分析. 相似文献
4.
降雨量的多少会影响尾矿坝的浸润线,尾矿坝浸润线的高低也是影响其稳定性的主要指标之一,因此研究尾矿坝稳定性就应该在研究浸润线影响的同时研究降雨量对尾矿坝稳定性的影响。在考虑尾矿坝原有浸润线的基础上,分别对2个尾矿坝剖面在正常水位、20 a一遇24 h最大降雨量、50 a一遇24 h最大降雨量和100 a一遇24 h最大降雨量的4种不同降雨工况下,采用极限平衡法中的瑞典圆弧法、毕肖普法和简布法3种不同的计算方法与渗流同步计算尾矿坝的稳定性,得出尾矿坝的最小安全系数与降雨量呈线性相关的关系,降雨量越大,尾矿坝最小安全系数就越小,尾矿坝越不稳定;尾矿坝面积越大,受降雨影响越大。 相似文献
5.
刘瀚和 《有色金属(矿山部分)》2017,69(1):75-76
尾矿坝稳定计算方法常用简化毕肖普法及瑞典圆弧法,当两者计算结果存在冲突时,应分析其合理性。通过对某尾矿坝稳定计算结果的分析,当坝基有深厚较软地层时,瑞典圆弧法不适用,故推荐采用简化毕肖普法作为尾矿坝稳定计算的主要方法。 相似文献
6.
7.
利用有限差分法计算程序FLAC^2D 对尾矿坝在地震荷载作用下进行了数值模拟,采用Finn动本构模型分析了尾矿坝在地震荷载作用结束时的位移及应力,为尾矿坝在高烈度地震区的安全稳定性提供了数值模拟的方法及设计参考依据。 相似文献
8.
通过运用数学手段对磁性物回收率公式进行分析,得出了磁选机入料、精矿、尾矿固体中磁性物含量大小与磁性物回收率高低间的变化规律,并依据此规律阐述了采用传统的以磁性物回收率指标为依据进行介质回收流程计算尾矿介质损耗的设计方法存在的弊端及引起的后果。提出了以尾矿带介量指标作为尾矿介质损失计算的依据。 相似文献
9.
10.
11.
12.
13.
为实现尾矿坝地下水位预测及预报预警,以尾矿坝地下水位为研究对象,将库水位、最小干滩长度等5个变量作为影响参数,尾矿坝地下水位为输出变量,建立支持向量机(SVM)预测模型.引入多策略改进的灰狼优化算法(MGWO)确定SVM模型参数,并以工程实例进行仿真预测.结果表明,MGWO?SVM模型平均相对误差0.24%,平均绝对误... 相似文献
14.
本文提供了尾矿坝材料(尾矿砂、尾矿泥)的地下剪切波速度的原位孔内测定结果,研究了这些筑坝材料的剪切波速度随深度和沉积距离的变化规律.这一规律,可为中国通常使用的上游筑坝的尾矿坝进行地震反应分析及坝体稳定性计算提供有用的数据.文中列举了我国最高尾矿坝动力稳定分析的计算结果. 相似文献
15.
16.
针对某尾矿库具体条件,采用三维有限元模拟和渗流场分布计算,判明在概化模型理想条件下尾矿坝三维渗流浸润线埋深的特点;通过对各排渗结构参数的敏感性进行分析,确定影响坝体浸润线埋深主要因素。模拟结果表明:在各排渗结构功能正常的工况下,尾矿库浸润线在尾砂子坝段的埋深均在15 m以下,大于规范要求值。 相似文献
17.
Stability analysis of a copper tailings dam via laboratory model tests: A Chinese case study 总被引:1,自引:0,他引:1
Guangzhi Yin Guangzhi Li Zuoan Wei Ling Wan Guohong Shui Xiaofei Jing 《Minerals Engineering》2011,24(2):122-130
The upstream method is a popular method for raising tailings dams. Currently in China there are more than 12,000 tailings impoundments and almost 95% of them use the upstream method for the construction of the dam. Statistical data has shown that the tailings impoundment is one of the main sources of risk in the mining industry. Failures of tailings impoundments have resulted in the loss of many lives, considerable property damage, and irreversible pollution in downstream areas. Therefore, the safety of tailings management facilities has been of increasing concern to governments and local communities. The management of a conventional tailings storage facility requires the maintenance of a high level of structural stability. Therefore, according to the relevant mine Acts, the mine operators are required to conduct stability analyses for all types of tailings facilities, whether they are new, active, or decommissioned. For the stability analysis of tailings dams, the accurate profile of the tailings dam is very important. The profiles are easily obtained for both active and decommissioned tailings facilities because their data can be collected through field investigations. However, collecting basic data from newly constructed tailings facilities is difficult. In this paper, a laboratory physical model test has been performed. The construction process for new tailings impoundment has been physically simulated in the laboratory, where the tailings particle composition and distribution below a beach, the change of phreatic surface of the dam, and the engineering properties of the tailings of the dam profiles have been measured. A new tailings facility, Yangtianqin tailings impoundment, owned by Tongchang copper mine of Yuxi Mine Co., was used as a case study to illustrate the physical modeling of the tailings dam. In the model test, the geometrical model of pond area was constructed according to the scale factor, λL, of 1:200 (model:prototype), and the tailings discharge system was also established, the tailings slurry then being discharged based on the design data. Finally, on the basis of the model test results on profiles, the stability analysis of the tailings dam at different heights was conducted under different conditions. The model test results and stability analysis show that the height of the tailings dam should be less than that originally planned. The original design of Yangtianqing tailings impoundment should therefore be revised for the safety of the tailings impoundment. 相似文献
18.
杨家湾尾矿库采用上游式筑坝,上游式筑坝由于矿泥夹层严重阻碍了水的垂直下渗,而随着尾矿库堆筑子坝上升,堆积坝长度增加,超出原有辐射式排渗井水平滤管排渗范围,加之两测山体基岩阻挡,渗流路径变长,导致杨家湾尾矿库局部浸润线偏高,子坝外坡出现局部沼泽化,两侧坝肩截水沟出现渗水现象。因此,对杨家湾尾矿库进行排渗加固,采用辐射式排渗井多层敷设水平滤管和坝体表面水平滤管联合排渗工艺,提高了尾矿库排渗能力,降低坝体浸润线,浸润线埋深平均增加0.67 m,实现实际浸润线不高于设计的控制浸润线要求,确保了尾矿库安全运行。 相似文献
19.
为提高尾矿库稳定性评估工作精准度,将可变模糊集理论引入尾矿库稳定性评估中,建立了基于博弈论-可变模糊集的综合评估模型。在综合考虑了尾矿库失稳原因及自然、管理等6个方面因素的基础上,选取了17个指标构建了综合评价指标体系;采用G1-CV法分别确定指标主观权重和客观权重,并基于博弈论计算指标综合权重,通过计算单指标相对隶属度和综合特征值,对河南省栾川县3个尾矿库进行稳定性等级评估,并与云模型和云物元理论评估结果相比较。结果表明:建立的综合评价模型评估结果合理可靠,与实际情况相符合,为尾矿库稳定性评估工作提供了一种新方法。 相似文献
20.
该文对尾矿坝在排渗方法处理上 ,根据地震波在介质中的传播特性 ,提出了一种确定尾矿坝水平顶管空间位置的方法。在进行理论分析计算的基础上 ,给出该问题的定量求解方法 ,并在工程应用中取得了良好效果。 相似文献