Fe-2Ni注射成形的溶剂脱脂

对石蜡-油-聚烯烃粘结剂溶剂脱脂相关问题进行了研究,包括溶剂和聚合物种类对脱脂过程的影响,以及脱脂坯强度、脱脂后干燥、溶剂回收等,结果表明:用二氯甲烷作溶剂,脱脂速率高于三氯甲烷;温度升高,溶剂脱脂速率增加,脱脂速率可达到2mm/h;乙烯-醋酸乙烯共聚物(EVA)作聚合物组分,溶剂脱脂后开裂,这与EVA在溶剂中溶胀率较大有关;坯块强度随脱脂进行而降低;石蜡-油在溶剂中累积使脱速率有所降低,可通过蒸馏方法使溶剂回收,回收率可超过95％(质量分数)。     

Making a little affinity go a long way: a topological view of LFA-1 regulation

Lymphocytes utilize adhesion to navigate in the body and to transiently interact with a variety of potential antigen presenting cells. Interactions of adhesion molecules are governed by the law of mass action and the less understood rules of apposed biological membranes. Biochemical parameters such as adhesion molecule affinity only tell part of the story. Factors such as lateral mobility, membrane alignment and cytoskeletal interactions are equally important in determining the final outcome. Therefore it is important to determine mechanisms by which the properties of cell membranes and the cytoskeleton reinforce or hinder adhesion molecule interactions. Work from my lab has shown that one mechanism by which lymphocyte adhesion molecules cooperate is to align adhering membranes with nanometer precision. Here, I discuss a model for LFA-1 regulation that is dependent on three independent processes: LFA-1 lateral mobility, ligand induced generation of a small amount of high affinity LFA-1 and local membrane alignment. I propose that coordination of these processes allows rapid interconversion between stable adhesion and detachment.     

Building the potential to bake the MIM cake

The number of MIM furnace manufacturers is on the increase. For the customer faced with an expanding array of products, there is an even greater need to work with the furnace builders to get the right solution, says William J Powers…     

Status of MIM

Abstract

Several presentations at Florence dealt with the state of the MIM industry, both worldwide and in Europe, reports John Dunkley. While the impact of the crisis had been felt quite severely, the statistics for MIM were, overall, much better than for the classical sintered parts industry, with the fall from the peak being signi??cantly less. This probably re?ects that extreme dependence of the sintered parts business on the automotive market, whereas MIM serves a much wider range of markets, some of which, like biomedical in the USA, were only slightly affected by the crisis.