Creation of libraries with long ORFs by polymerization of a microgene

We describe a novel method for constructing pools of DNA sequences that encode large proteins with molecular diversity. Sets of primer pairs that form 8 to 10 complementary base pairs in the 3' region and have double mismatch pairs at their 3'-OH ends were designed so that primer dimers recreated short stretches of DNA (microgenes) devoid of termination codons. Cycles of denaturation and elongation reactions with a pair of primers, four dNTPs, and 3'-5' exo+ thermostable DNA polymerase gave head-to-tail polymers of the primer dimer unit (microgene) whose sizes exceeded 12 kb. No template was required in this reaction, but mismatched nucleotides at 3'-OH ends of the primers were critical for efficient polymerization. At end-joining junctions of a microgene, nucleotide insertions and deletions randomly occurred, resulting in combinatorial libraries of three reading frames from a single microgene. Further molecular diversity could be incorporated by using a mixture of primers. The resultant polymers have long ORFs whose products have a repetitious nature that could facilitate the formation of higher structures of translated products. Thus, microgene polymers may be used as a source of libraries for in vitro protein evolution experiments. Ligation of a microgene is apparently related to the nonhomologous recombination of double-strand breaks in DNA that has been shown to be catalyzed by DNA polymerases. We named this polymerization reaction the "microgene polymerization reaction."     

DNA polymerase epsilon: aphidicolin inhibition and the relationship between polymerase and exonuclease activity

Calf thymus DNA polymerase epsilon readily uses short, synthetic oligonucleotides as substrates for both polymerase and exonuclease activity. These substrates were used to examine the mechanism of inhibition by aphidicolin. Aphidicolin competes with each of the four dNTPs for binding to a pol epsilon.DNA complex. Importantly, aphidicolin binds equally well regardless of the identity of the next template base to be replicated (Ki approximately 0.6 microM). Hydrolysis of synthetic templates of defined sequence by the 3'-->5' exonuclease was examined. pol epsilon preferred to hydrolyze single-stranded DNA 3-fold better than double-stranded DNA (Vmax/KM), while under Vmax conditions single-stranded DNA was hydrolyzed 100-fold faster than double-stranded DNA. Aphidicolin did not inhibit exonuclease activity on single-stranded DNA; however, activity on double-stranded DNA was partially inhibited. Formation of an E.[template.primer].aphidicolin ternary complex inhibits exonuclease activity. However, even under conditions where the polymerase site is completely blocked by a template-primer, the exonuclease retains significant activity.     

Interdependence between DNA template secondary structure and priming efficiencies of short primers

Here we analyze the effect of DNA folding on the performance of short primers and describe a simple technique for assessing hitherto uncertain values of thermodynamic parameters that determine the folding of single-stranded DNA into secondary structure. An 8mer with two degenerate positions is extended simultaneously at several complementary sites on a known template (M13mp18) using one, two or three (but never all four) of the possible dNTPs. The length of the extension is site specific because it is limited by the first occurrence in the downstream template sequence of a base whose complementary dNTP is not present. The relative priming efficiencies of different sites are then ranked by comparing their band brightnesses on a gel. The priming efficiency of a short primer (unlike conventional long primers) depends dramatically on the secondary structure of the template at and around the priming site. We calculated the secondary structure and its effect on priming using a simple model with relatively few parameters which were then optimized to achieve the best match between the predictions and the actual rankings of the sites in terms of priming efficiency. This work introduces an efficient and conceptually novel approach that in the future can make use of more data to optimize a larger set of DNA folding parameters in a more refined model. The model we used, however crude it may be, significantly improved the prediction of priming efficiencies of 8mer primers and appreciably raised the success rate of our DNA sequencing technique (from 67 to 91% with a significance of P < 7 x 10(-5)), which uses such primers.     

Formation of a DNA loop at the replication fork generated by bacteriophage T7 replication proteins

Intermediates in the replication of circular and linear M13 double-stranded DNA by bacteriophage T7 proteins have been examined by electron microscopy. Synthesis generated double-stranded DNA molecules containing a single replication fork with a linear duplex tail. A complex presumably consisting of T7 DNA polymerase and gene 4 helicase/primase molecules was present at the fork together with a variable amount of single-stranded DNA sequestered by gene 2.5 single-stranded DNA binding protein. Analysis of the length distribution of Okazaki fragments formed at different helicase/primase concentrations was consistent with coupling of leading and lagging strand replication. Fifteen to forty percent of the templates engaged in replication have a DNA loop at the replication fork. The loops are fully double-stranded with an average length of approximately 1 kilobase. Labeling with biotinylated dCTP showed that the loops consist of newly synthesized DNA, and synchronization experiments using a linear template with a G-less cassette demonstrated that the loops are formed by active displacement of the lagging strand. A long standing feature of models for coupled leading/lagging strand replication has been the presence of a DNA loop at the replication fork. This study provides the first direct demonstration of such loops.     

PCR-introduced loop structure as primer in DNA sequencing

The need for a primer hybridization step before sequencing has been eliminated using a stem-loop structure generated by PCR. The loop structure is obtained by careful design of the PCR primer or by cloning the target DNA into a dedicated vector (pRIT 28HP). After solid-phase capture of the PCR product, the loop is formed by elution of the non-bound strand. Here, we show that both the immobilized and the eluted strand can be analyzed using conventional Sanger DNA sequencing and the novel pyrosequencing method as described previously. By using a stem-loop structure as a primer for DNA sequencing, the risk for mispriming is minimized.     

Dissociation of bacteriophage T4 DNA polymerase and its processivity clamp after completion of Okazaki fragment synthesis

The mechanism of bacteriophage T4 DNA polymerase (gp43) and clamp (gp45) protein dissociation from the holoenzyme DNA complex was investigated under conditions simulating the environment encountered upon completion of an Okazaki fragment. Lagging strand DNA synthesis was approximated using a synthetic construct comprised of a doubly biotinylated, streptavidin-bound 62-mer DNA template, paired with complementary primers to generate an internal 12-base gap where the 5'-end primer contained either a 5'-OH (DNA primer) or a 5'-triphosphate (RNA primer) group. Rapid kinetic measurements revealed that upon encountering the blocking primer, the holoenzyme either dissociates from DNA (approximately 40%) or strand-displaces the blocking strand (approximately 60%). The two blocking oligonucleotides (DNA or RNA) induce a 30-50-fold increase in the rate of holoenzyme dissociation, with both polymerase and clamp proteins dissociating simultaneously. Inhibition of ATP hydrolysis by ATP-gamma-S did not have a measurable effect upon holoenzyme dissociation from DNA. The presence of gp32, the single-strand binding protein, caused a small (3-fold) increase in the rate constant for dissociation.     

Gene 4 helicase of bacteriophage T7 mediates strand transfer through pyrimidine dimers, mismatches, and nonhomologous regions

In bacteriophage T7 the gene 2.5 single-stranded DNA-binding protein and the gene 4 helicase together promote the annealing of homologous regions of two DNA partners to form a joint molecule and subsequent strand transfer. In this reaction T7 gene 2.5 protein is essential for joint molecule formation, but is not required for T7 gene 4 protein-mediated strand transfer. T7 gene 4 helicase alone is able to mediate strand transfer, provided that a joint molecule is available. The present paper shows that, in addition, strand transfer proceeds at a normal rate even when both DNA partners contain ultraviolet-induced pyrimidine dimers (0.6 dimer per 100 nt). An insert of a relatively long (842-nt) segment of nonhomologous DNA in the single-stranded DNA partner has no effect on strand transfer, whereas its presence in the double-stranded partner prevents strand transfer. A short insert (37 nt) can be tolerated in either partner. Thus, DNA helicase is able to participate in recombinational DNA repair through its role in strand exchange, providing a pathway distinct from nucleotide excision repair.     

On-the-fly fluorescence lifetime detection of dye-labeled DNA primers for multiplex analysis

Mixtures of dye-labeled, M13-forward DNA primers were separated by capillary gel electrophoresis and detected on-the-fly, using fluorescence lifetime measurements, to evaluate four-decay detection for multiplex DNA sequencing. Three different four-dye systems were used, two that were excited at 488 nm and one that was excited at 514 nm. Each dye-labeled primer was identified on the basis of the lifetime of the conjugated dye using nonlinear least squares or the maximum entropy method to analyze the lifetime data. Overlapping electrophoretic peaks were generated by making multiple injections of mixtures of the dye-labeled primers. The overlapping peaks were resolved by fitting the data to two-, three- or four-component lifetime models used in nonlinear least-squares analysis in which each lifetime component was fixed to the predetermined lifetime of the corresponding dye-labeled primer. In two of the dye systems, the lifetimes of the four dye-labeled primers were sufficiently different to allow peak resolution. In the other dye system, addition of 10% DMSO to the run buffer changed the lifetime of one dye-labeled primer, allowing it to be resolved from another dye-labeled primer with similar lifetime.     

Eucaryotic DNA primase does not prefer to synthesize primers at pyrimidine rich DNA sequences when nucleoside triphosphates are present at concentrations found in whole cells

The critical role of NTP concentration in determining where calf thymus DNA primase synthesizes a primer on a DNA template was examined. Varying the concentration of NTPs dramatically altered the template sequences at which primase synthesized primers. At the low NTP concentrations typically used for in vitro experiments (100 microM), primase greatly preferred to synthesize primers at pyrimidine rich DNA sequences. However, when the concentrations of NTPs were increased to levels typically found in whole cells, primers were now synthesized in all regions of the template. Importantly, synthesis of primers in all regions of the DNA template, not just the pyrimidine rich sequences, is the pattern of primer synthesis observed during DNA replication in whole cells. With low concentrations of NTPs (i.e., Vmax/K(M) conditions), primers are only synthesized at the most preferred synthesis sites, namely, those that are pyrimidine rich. In contrast, under conditions of high NTP concentrations, primer synthesis will occur at the first potential synthesis site to which primase binds. Now, the primase x DNA complex will be immediately converted to a primase x DNA x NTP x NTP complex that is poised for primer synthesis.     

Oligonucleotide dendrimers: synthesis and use as polylabelled DNA probes

Oligonucleotide dendrimers were synthesized using a novel phosphoramidite synthon, tris-2,2,2-[3-(4,4'-dimethoxytrityloxy) propyloxymethyl]ethyl- N , N -diisopropylaminocyanethoxy phosphoramidite. Label, incorporated using [gamma-32P]ATP and polynucleotide kinase, was increased in proportion to the number of 5'-ends. There was a similar increase in signal when these multiply labelled oligonucleotides were used as probes to oligonucleotide arrays. A dendrimeric oligonucleotide was used successfully as a primer in the PCR. The strand bearing the dendrimer was resistant to degradation by T7 Gene 6 exonuclease making it easy to convert the double-stranded product of the PCR to a multiply-labelled, single-stranded probe.     

Terminal transferase-dependent PCR: a versatile and sensitive method for in vivo footprinting and detection of DNA adducts

We report here a new, sensitive and versatile genomic sequencing method, which can be used for in vivo footprinting and studies of DNA adducts. Starting with mammalian genomic DNA, single-stranded products are made by repeated primer extension; these products are subjected to homopolymeric ribonucleotide tailing at the 3' termini with terminal deoxynucleotidyl transferase and then ligated to a double-stranded linker having a complementary 3' overhang, and used for PCR. This terminal transferase-dependent PCR (TDPCR) method can generate band signals many-fold stronger than conventional ligation-mediated PCR (LMPCR). A UV photofootprint in the mouse Xist gene promoter can be easily detected using TDPCR. No special enzymes or chemical reagents are needed to convert DNA adducts into strand breaks. Any lesion that blocks primer extension should be detectable.     

Monte Carlo simulation of the production of short DNA fragments by low-linear energy transfer radiation using higher-order DNA models

A realistic DNA target model has been developed and implemented in the biophysical simulation code PARTRAC. It describes five levels of the B-DNA structure (nucleotides, DNA helices, nucleosomes, chromatin fiber structure and chromatin fiber loops) on an atomic level for the whole genome inside a mammalian cell nucleus. The model is capable of describing regular solenoidal, crossed-linker or zigzag structures as well as repeating stochastic arrangements of nucleosomes in the chromatin fiber. Electron tracks resulting from monoenergetic electrons with energies up to 100 keV and from 220 kVp X rays, starting at random positions in the cell, were superimposed on four DNA target models with different chromatin fiber structures. The yields of SSBs, DSBs and short single- and double-stranded DNA fragments were determined from spatial coincidences with strand atoms. Two parameters of the model-the energy necessary to create an SSB and the distance between two breaks that would be scored as a DSB-were adapted to equate simulated and measured strand break yields after X irradiation of human fibroblast cells. The integral fractions of short single- and double-stranded fragments were rather similar for all condensed chromatin fiber structures; they agreed with experimental data for DNA fragments below 2 kbp. The simulated fragment size distributions in the range from 0.1 to 1.5 kbp reflected the fiber structure irrespective of strandedness or electron energy. The distributions using a stochastic arrangement of nucleosomes in the chromatin fiber were found to be in better accordance with experimental data than those obtained with regular fiber structures.