共查询到19条相似文献,搜索用时 78 毫秒
1.
基于分形技术的阶跃阻抗微带低通滤波器设计 总被引:2,自引:0,他引:2
设计阶跃阻抗微带低通滤波器时,由于阶跃阻抗微带线结构的不连续性,会导致版图仿真与电路原理图仿真结果相差很远。为了解决这一问题,提出先对阶跃阻抗微带线的结构参数进行预处理,然后引入分形技术对低阻抗微带线的版图结构作进一步优化的设计方法,利用分形结构成阶梯锯齿状分布的线宽来改善滤波器的通带特性,而又几乎不影响滤波器的阻带特性,获得了满意的滤波性能;以一个5阶契比雪夫型阶跃阻抗微带低通滤波器设计为例,仿真结果表明:滤波器通带内的最大反射损耗从-0.87 dB降低到-15.22 dB。与直接采用分形结构的设计方法相比,该方法有利于减少分形结构的迭代次数,降低加工精度要求,从而降低制作成本。 相似文献
2.
3.
提出一种新型的多口三环CSRR结构,利用CSRR谐振器的单极点低通特性和环与微带线之间的耦合,构成低通滤波器.分析该结构的等效电路模式,指出谐振频率的计算公式.使用HFSS适当优化参数,可以得到性能良好的低通滤波器.其-3 dB截止频率8.76 GHz,通带内插入损耗小于0.3306 dB,通带内回波损耗小于-13.810 2 dB,衰减15 dB以上阻带带宽达到10.31 GHz.为了改善通带内的回波损耗,在微带线两侧加载并联开路枝节.其-3 dB截止频率8.385 GHz,通带内插入损耗小于0.174 7 dB,通带内回波损耗小于-19.707 7 dB,衰减15 dB以上阻带带宽达到10.7 GHz. 相似文献
4.
5.
6.
提出了一种新型一维周期缺陷地面结构(DGS)单元。文中给出了3个不同尺寸单元的5参数变化曲线,并使用DGS单元进行级联,形成一种补偿微带线。设计了一个低通滤波器,计算和测试结果显示该结构单元的截止频率由结构单元的物理尺寸决定,单元级联形成的多级低通滤波器具有良好的带通、带阻和谐波抑制特性。 相似文献
7.
文中提出一种基于缺陷地结构的新型低通滤波器。其由位于微带结构顶部的加宽微带线、位于接地层中的经典哑铃型缺陷地结构(DGS)和蛇形缝隙缺陷地结构(DGS)组成,结构设计紧凑,容易调整。文中选用0.01 dB等波纹的切比雪夫型低通滤波器,分别采用哑铃型DGS、蛇形缝隙DGS替换LPF原型电路中的电感,加宽微带线替换并联电容,同时将加宽微带线产生的寄生电感考虑进去。哑铃型DGS产生的高频衰减点加宽阻带,蛇形缝隙DGS提供的低频衰减点使得通带到阻带陡峭过渡。实验结果表明,所设计的截止频率为2.54 GHz的低通滤波器具有明显的截止频率响应,通带内插损均在0.9dB以下,阻带抑制均在21dB以下。经实物加工测试验证,所设计的低通滤波器实际结果与仿真结果基本一致,具有可行性。 相似文献
8.
9.
一种新型微带光子带隙结构的优化设计 总被引:2,自引:0,他引:2
本文对一种渐变尺寸的新型光子带隙结构进行了优化设计。根据优化后得出的最优结构参数 ,设计出PBG结构。实验结果证明 ,这种优化后的新型结构可以在保持阻带抑制幅度的同时减小通带内的波纹 相似文献
10.
11.
Mohsen Hayati Akram Sheikhi Auob Adineh Vand 《International Journal of Electronics》2013,100(11):1575-1580
In this article, a compact microstrip low-pass filter with elliptic-function response is proposed. To achieve wide stopband, modified semi-circle patch resonator in series with semi-circle stepped impedance resonator is used. The proposed structure achieves a wide stopband and a high selectivity within a small circuit area. The proposed filter has 3-dB cutoff frequency at 1.71?GHz and 20?dB rejection at 2.1?GHz. The stopband with the attenuation level better than ?18.7?dB is from 2.08 up to 16?GHz, and consequently we have reached the high and wide rejection in stopband as well as compact size. The structure is simulated, fabricated and measured. The measured results are in good agreement with the simulated results. 相似文献
12.
13.
A synthesis method to design a defected ground structures (DGS)-based Bessel low-pass filter (LPF) using a triangular and an open-square (OS)-type DGS is reported. For the five-pole Bessel LPF at fc = 2.5 GHz, we get 10.6 dB/GHz selectivity using the triangular DGS; while the OS-type DGS provides 39 dB/GHz selectivity. For these two filters, the 10 dB impedance matching BW is 76% and 84%, respectively. It is a much wider BW that is obtained for a lumped element Bessel LPF. The maximum group delay (GD) variation within the pass band is 25pS and 28pS, respectively. The 20 dB rejection BW can be increased from 5.8 GHz to 18.8 GHz with increase in the order of filter from 5 to 11. We have also presented the design of a compact five-pole DGS-based elliptic filter with selectivity 38.2 dB/GHz and 17.8 dB return loss. Results on the DGS-based elliptic filter, Butterworth and Chebyshev filters are also presented. The experimental results are compared against the recently reported LPFs. Our reported filters perform better with respect to selectivity and group delay variation. The flatter GD and high selectivity, along with a wide 10 dB impedance matching BW, make the DGS Bessel filter a candidate for high-speed data communication, front end of a wideband communication system and efficiency improvement of a power amplifier. 相似文献
14.
15.
16.
为了解决传统CPW低通滤波器尺寸偏大、阻带较窄和插入损耗偏大的问题,采用 /4阶梯阻抗谐振单元(SIR)加载半圆形并联枝节(SISS)和缺陷地结构(DGS)单元的紧凑型结构设计了一个5阶CPW低通滤波器,分析了各单元结构参数对阻带性能的影响,引入微带线补偿方法对共面波导中心导体线特性阻抗进行局部补偿,改善了阻抗匹配性能,进一步降低了通带内的回波损耗和插入损耗。测试结果表明:该滤波器结构尺寸25mm×18mm,3dB截止频率3.5GHz,阻带范围3.8~17GHz。实现了CPW低通滤波器的低插入损耗、超宽阻带和小型化。 相似文献
17.
18.
一种具有传输零点的Hairpin带通滤波器设计 总被引:3,自引:0,他引:3
本文通过在微带(hairpin)滤波器的谐振器上并联微带开路线,构成了一种新的hairpin带通滤波器。该滤波器在通带附近有一对传输零点,具有良好的频率响应以及频率选择特性。由于这种类型的微带滤波器实现传输零点不需要通过滤波器非相邻谐振器间的交叉耦合来获得,因此,设计过程非常简单。 相似文献
19.
A novel low-pass filter that consists of a switched capacitor filter(SCF) and its antialiasing prefilter and smoothing postfilter is proposed for a microsensor signal processing system,which is used in separation point detection on the surface of micro air vehicles.In the system,the filter is not only applied to finish the function of filtering but also used as the front end antialiasing filter of the over sampling analog-to-digital converter.This proposed implementation mostly relies on the design of a ... 相似文献