新型激光晶体材料研究进展

对新型激光晶体近年比较活跃的两个研究方向,掺镱的激光晶体和拉曼激光晶体的研究状况进行了总结.掺镱晶体可以产生高功率的激光输出,是重要的研究方向;同时掺镱激光晶体还可以实现用激光二极管泵浦的超快激光输出.拉曼晶体可以方便地产生人们所需要的激光波长,具有潜在的应用.本文对于这两类晶体的优点、可能应用的方向及最新的发展方向进行了阐述.     

Laser-diode-pumped Nd:YAG active-mirror laser

We describe a simple design, laser-diode-pumped cw Nd:YAG active-mirror laser and present a thermal analysis of the crystal. A cw output power of 2.4 W and an M(2) beam quality value of less than 1.9 at an incident pumping power of 8.9 W were obtained. From the thermal analysis we predict that the output power can be increased by increasing the pump beam diameter and the pump power at a constant excitation density.     

Continuous-wave laser performance of Nd:LuVO4 crystal operating at 1.34 microm

A laser-diode-array end-pumped Nd:LuVO4 crystal continuous-wave (cw) laser operating at 1.34 microm has been demonstrated. The maximum cw output power of 1.85 W was obtained at the incident pump power of 17 W for a c-cut 0.5 at. % Nd-doped LuVO4 crystal sample, giving the corresponding optical conversion efficiency of 10.88% and a slope efficiency of 13.5%. Laser experiments of Nd3+ concentration of 0.5 and 0.9 at. % a-cut crystal LuVO4 samples were also investigated; due to the strong excited-state absorption of Nd:LuVO4 at 1.34 microm, the output power was limited.     

Intracavity frequency doubling and Q switching in diode-laser-pumped Nd:YVO(4) lasers

A highly efficient and compact Nd:YVO(4) laser is proposed. In cw operation, a single-longitudinal-mode output of 95 mW and a multilongitudinal-mode output of 435 mW have been observed at 1.06 μm with a 1-W diode laser. Using a KTP crystal in the short laser cavity, a green output of 105 mW was generated. A Q-switched pulse with a peak power of 230 W and a pulse width of 8 ns was obtained with the intracavity KTP crystal, which was used as both an electro-optic Q switch and a frequency doubler.     

Efficient continuous-wave radiatively cooled cr(4+):forsterite lasers at room temperature

Results of a detailed experimental investigation aimed at reducing the thermal loading problem in a cw Cr(4+):forsterite laser at elevated temperatures are presented. From a Cr(4+):forsterite crystal with a differential absorption coefficient of 0.57 cm(-1), as much as 900 mW of cw output power has been obtained at 1.26 mum and at a crystal boundary temperature of 15 degrees C with an absorbed pump power of only 4.5 W at 1.06 mum. No chopping of the pump beam was necessary. An efficient radiative cooling technique was further employed to cool the laser and no subsequent power fading was observed. To the author's knowledge, the measured absorbed power slope efficiency of 29.5% represents the highest cw power performance reported to date from a Cr(4+):forsterite laser pumped by a Nd:YAG laser around room temperature. The role of the low differential absorption coefficient in the reduction of thermal loading is further elucidated by presenting comparative cw power performance data with a second Cr(4+):forsterite crystal having a differential absorption coefficient of 1.78 cm(-1) in the temperature range between 12 and 35 degrees C. Finally, some interesting multipulse effects of the laser observed in the millisecond regime during quasi-cw operation at 50% duty cycle are described.     

Improvement in continuous-wave laser performance of disordered Yb:CNGG crystal

We report on a significant improvement in cw laser performance of the disordered Yb:CNGG crystal. Very efficient cw laser operation is demonstrated at room temperature with a 3.5 mm thick crystal end pumped by a diode laser, generating an output power of 5.15 W with an optical-to-optical efficiency of 46%, whereas the slope efficiency amounts to 80%.     

Anisotropy in laser performance of Yb:GdCa4O(BO3)3 crystal

We report distinct laser performance of Yb:GdCa(4)O(BO(3))(3) crystals cut along different principal optical axes using an unpolarized diode pump. The continuous-wave (cw) laser oscillation generated with y-cut crystal is polarized either with E parallel x or with E parallel z depending on the output coupling (T) utilized; a specific T=3% leads to a special situation in which the two orthogonal polarization states coexist oscillating at different wavelengths. The laser oscillation achieved with x- and z-cut crystals is also polarized, but with a fixed polarization of E parallel z and E parallel x, respectively. The most efficient laser operation is obtained with the y-cut crystal, generating a cw output power of 7.35 W at 1083-1085 nm with an optical-to-optical efficiency of 63%, the slope efficiency being as high as 84%.     

Tunable diode-pumped and frequency-doubled Cr:LiSAF lasers

The performance of a diode-pumped Cr:LiSAF laser and its intracavity frequency-doubled operation is reported. Close to 1 W of quasi-cw power at 870 nm was obtained in multimode operation. Power in excess of 20-mW cw of TEM(00) second-harmonic power at 435 nm has also been obtained by using a lithium triborate crystal with an infrared-to-visible conversion efficiency of 33%. This result is believed to be the highest yet reported for a true cw blue output from a diode-pumped Cr:LiSAF system. However, the maximum attainable output power was limited by thermal fluorescence quenching. The effect of the pump size on the temperature rise and on the small-signal gain is investigated.     

High-power cw 671 nm output by intracavity frequency doubling of a double-end-pumped Nd:YVO4 laser

We report on a high-power (cw) red laser at 671 nm by intracavity frequency doubling of a double-end-pumped 1342 nm Nd:YVO4 laser based on the nonlinear crystal LiB3O5. A red output power of 3.38 W is obtained for a pump power of 27 W, with corresponding optical-to-optical efficiency of 12.5%. The 671 nm beam is nearly diffraction limited.     

Efficient continuous-wave frequency doubling of a tunable CO(2) laser in AgGaSe(2)

Second-harmonic output at 4.6-5.5 mum of the order of 6 mW with a 0.12% external conversion efficiency has been obtained by pumping a AgGaSe(2) crystal with a low-power cw CO(2) laser. The surface damage threshold of AgGaSe(2) for cw radiation was found to be inside the limit of 33-45 kW/cm(2) in the 9.2-10.8-mum wavelength region. Another important limitation of the pump power connected with a thermal lensing effect in crystal was determined experimentally. A comparison was made of AgGaSe(2) and ZnGeP(2) crystals as materials suitable for the efficient generation of the second harmonic of cw CO(2) laser radiation.     

1053-nm-wavelength selection in a diode-laser-pumped Nd:YLF laser

We report on a Nd:YLF laser that operates at 1053 nm without optical intracavity elements for the suppression of the stronger 1047-nm transition. The Nd:YLF crystal is end pumped by a fiber optically coupled 10-W diode-laser bar. The different thermal-lensing focal lengths of the two main lasing wavelengths in a plane-parallel resonator were used to achieve the selection by tilting the end mirror slightly from its optimum position for maximum output power. With 9.8-W cw diode-laser-pumping power the 1053-nm Nd:YLF laser produces a maximum output power of 1.9 W in cw operation and nearly 1 W of average power at a Q-switch repetition rate of 15 kHz. The highest slope efficiency of 47% achieved in cw operation.     

Diode-side-pumped 131 W, 1319 nm single-wavelength cw Nd:YAG laser

A diode-side-pumped high-power 1319 nm single-wavelength Nd:YAG continuous wave (cw) laser is described. Through reasonable coating design of the cavity mirrors, the 1064 nm strongest line as well as the 1338 nm one have been successfully suppressed. The laser output powers corresponding to four groups of different output couplers operating at 1319 nm single wavelength have been compared. The output coupler with the transmission T=5.3% has the highest output power, and a 131 W cw output power was achieved at the pumping power of 555 W. The optical-optical conversion efficiency is 23.6%, and the slope efficiency is 46%. The output power is higher than the total output power of the dual-wavelength laser operating at 1319 nm and 1338 nm in the experiment.     

Passively Q-Switched Diode-Pumped Continuous-Wave Nd:YAG-Cr(4+):YAG Laser with High Peak Power and High Pulse Energy

A high peak power and high pulse energy passively Q-switched diode-pumped cw Nd:YAG laser at 1.064-mum wavelength has been demonstrated with Cr(4+):YAG crystal as the saturable absorber. The average output power of 7-12 W and pulse duration of 100-250 ns was obtained with kilohertz repetition rates. The highest peak power and pulse energy obtained were 30 kW and 3.4 mJ, respectively. All the output resulted from the TEM(00) mode with M(2) < 1.1. The thermal lensing effect of the saturable absorber was investigated, demonstrating that it played an important role in optimization of the output.     

High-power efficient continuous-wave TEM00 intracavity frequency-doubled diode-pumped Nd:YLF laser

We describe experimental results with a diode-pumped, intracavity-doubled cw Nd:YLF laser in multilongitudinal mode and TEM00 spatial transverse mode with a critical phase-matched lithium triborate crystal. Taking into account the thermal effects of Nd:YLF, energy-transfer upconversion, and the thermal fracture limit, we set up a power-scaling model to optimize and design a fundamental diode-pumped Nd:YLF laser. A highly efficient second-harmonic laser was achieved, based on the optimized cavity design. A second-harmonic-generation output power of 20.5 W at a wavelength of 527 nm was obtained at an incident pump power of 60 W, corresponding to an optical-to-optical efficiency of 34.2%. The TEM00 mode green laser operates at a measured M2 parameter of 1.2. The instability of the green laser power is less than +/- 1% RMS.     

Laser-diode-pumped cw Nd:MgO:LiNbO(3) self-frequency-doubling laser around room temperature

A laser-diode-pumped cw self-frequency-doubling laser has been achieved in Nd:MgO:LiNbO3 crystal around room temperature. The second-harmonic output at λ = 547 nm to 8 mW was obtained with a miniature resonator in which only a crystal was included, without any extra intracavity component.     

Two-wavelength, passive self-injection-controlled operation of diode-pumped cw Yb-doped crystal lasers

We demonstrate and investigate a peculiar mode of cw Yb3+-doped crystal laser operation when two emissions, at two independently tunable wavelengths, are simultaneously produced. Both emissions are generated from a single pumped volume and take place in either a single beam or spatially separated beams. The laser employs original two-channel cavities that use a passive self-injection-locking (PSIL) control to reduce intracavity loss. The advantages of the application of the PSIL technique and some limitations are shown. The conditions for two-wavelength multimode operation of the cw quasi-three-level diode-pumped Yb3+ lasers and the peculiarity of such an operation are carried out both theoretically and experimentally. The results reported are based on the example of a Yb3+:GGG laser but similar results are also obtained with a Yb3+:YAG laser. The laser operates in the 1023-1033-nm (1030-1040-nm) range with a total output power of 0.4 W. A two-wavelength, single longitudinal mode generation is also obtained.     

Diode-laser-pumped tunable 896-939.5-nm neodymium-doped fiber laser with 43-mW output power

A diode-laser-pumped neodymium-doped fiber laser is presented. For a launched pump power of 85 mW, the fiber laser had a cw output power of 43 mW, which is approximately an order of magnitude greater output power than any previously reported diode-pumped neodymium fiber laser operating on the(4)F(3/2)-(4)I(9/2) transition, which covers the 900-950-nm region. The fiber laser had a threshold power of 10 mW and a slope efficiency of 58% with respect to launched pump power. Tuning with a diffraction grating was obtained from 896 to 937 nm with narrow-band output powers as high as 32 mW. Emission was also obtained at 939.5 nm with use of a fiber Bragg grating as the output reflector.     

Chromium-doped forsterite laser with 1.1 W of continuous-wave output power at room temperature

We demonstrate stable continuous-wave operation of a Cr:forsterite laser pumped by a cw Nd:YAG laser at 288 K. We use no choppers to limit the duty cycle of the cw system. The proper adjustment of the pump- and cavity-mode overlap based on the ABCD concept simulation eliminates the output power decrease at the high-level pump power. An output power of 1.1 W and slope efficiency of 26% are derived.     

Neodymium:YAG 30-W cw Laser Side Pumped by Three Diode Laser Bars

A theoretical calculation of pump power deposition in a direct water-cooled Nd:YAG laser rod, side pumped by three diode laser bars is presented. The pumping cavity design provides a nearly uniform pump profile. More than 30-W cw output power with optical-to-optical efficiencies of more than 30% are obtained.     

Continuous-wave laser characteristics of a Nd3+:LaB3O6 cleavage microchip and the influence of thermal effects

With pumping by a Ti:sapphire laser, the cw laser characteristic of a 5.6 at. %, 0.5 mm thick Nd3+:LaB3O6 cleavage microchip in an end-pumped plano-plano resonator is researched. A slope efficiency of up to 49% and a maximum output power of 530 mW are obtained at an absorbed pump power of 1.16 W and an optimal output coupler transmission of 3.2%. Choppers with different duty cycles are used to change the thermal effects in the microchip, and the influences of thermal effects on the laser characteristics of the Nd3+:LaB3O6 cleavage microchip are investigated.