共查询到20条相似文献,搜索用时 166 毫秒
1.
2.
3.
4.
利用响应面法对超声提取杜鹃花黄酮类成分的工艺条件进行优化。在对乙醇体积分数、料液比、提取时间单因子实验的基础上,根据中心组合设计原理,采用三因子三水平的响应面分析法,在分析各个因素的显著性和交互作用后,得出超声辅助提取杜鹃花黄酮的最优工艺条件:乙醇的体积分数为74.08%,料液比为20.58∶1,提取时间为32.48 min,此时黄酮平均提取率为8.758%。 相似文献
5.
响应面法优化超声辅助提取金银花中绿原酸 总被引:1,自引:0,他引:1
《化学与生物工程》2017,(3)
采用超声辅助乙醇从金银花中提取绿原酸,通过单因素实验考察pH值、料液比、乙醇体积分数和提取时间对绿原酸提取率的影响,采用响应面法优化提取工艺条件。确定最佳工艺条件为:pH值5.2、提取时间21min、乙醇体积分数63%、料液比1∶13.5(g∶mL)。在该优化条件下,绿原酸的提取率达到10.862%。 相似文献
6.
7.
《化学与生物工程》2016,(6)
采用乙醇回流法提取猪毛菜总黄酮,通过单因素实验和星点设计-响应面法实验优化猪毛菜总黄酮提取工艺。以浸泡时间、液料比、乙醇浓度、回流温度、回流时间为考察因素,以总黄酮得率为评价指标,采用分光光度法测定吸光度,通过单因素实验筛选乙醇回流法的主要影响因素;再通过星点设计-响应面法实验进一步优化提取工艺条件。结果表明,乙醇回流法提取猪毛菜总黄酮的最优条件为:浸泡时间30min、液料比21∶1(mL∶g)、乙醇浓度62%、回流温度100℃、回流时间109min,该条件下猪毛菜总黄酮得率预测值为0.8405%,实测平均值为0.8387%,平均偏差为0.65%,RSD为0.47%。该方法模型预测性良好、偏差较小、提取条件稳定、可靠性高。 相似文献
8.
9.
以刺玫果总黄酮提取率为考核指标,采用单因素实验考察酶种类及用量、乙醇体积分数、溶液pH值、料液比、提取温度、提取时间、超声功率、超声温度、超声时间、提取方式等对提取效果的影响;在此基础上,采用响应面法优化刺玫果总黄酮的超声辅助酶法提取工艺,确定最优工艺条件为:纤维素酶用量15 mg·g~(-1)、乙醇体积分数60%、溶液pH值5、料液比1∶15(g∶mL)、提取温度50℃、提取时间2.0 h、超声功率450 W、超声温度50℃、超声时间40 min,在此条件下,刺玫果总黄酮提取率达到128.6 mg·g~(-1)。 相似文献
10.
以金银忍冬果为原料,在单因素实验基础上,以液料比(体积质量比)、提取时间、乙醇体积分数为自变量,黄酮类物质提取率为响应值,根据Box-Behnken的中心组合实验设计原理,用响应曲面分析法对工艺过程进行优选,并对预测值的可靠性进行了验证,然后与溶剂回流法做了比较。实验结果表明,提取金银忍冬果中黄酮的最优工艺条件为:提取温度60℃、液料比18.6∶1 mL/g、时间1.32 h、乙醇体积分数71%;响应曲面法所得的优化条件与预测值吻合度较好,相同实验条件下,超声辅助提取法明显优于回流提取法,提取率更高。 相似文献
11.
12.
桑叶黄酮提取分离方法研究 总被引:2,自引:0,他引:2
研究了从桑叶中提取分离黄酮的方法,探讨了提取剂、料液比、回流时间、回流温度等因素对桑叶黄酮提取率的影响,并通过正交实验对提取工艺进行了优化。实验表明,提取最佳条件为:将原料用超声波预处理40 m in(800 W),以80%的乙醇为提取剂,按料液比1∶8提取,回流温度为70℃,AB-8大孔吸附树脂分离,以乙醇洗脱(洗脱速率为1 BV/h),得率为19.3 mg/g,同时测得黄酮的稳定性良好。本方法具有工艺流程简单、提取率高的优点,适合于工业化生产,为同类研究提供了一定的依据。 相似文献
13.
14.
加压提取枳实总黄酮的研究 总被引:1,自引:0,他引:1
采用加压提取法提取枳实中黄酮类成分,并与乙醇回流法比较提取效果。采用单因素试验,考察提取压力、提取温度和溶剂用量等对黄酮提取的影响,并采用正交设计法优化工艺。结果表明最适宜条件为:乙醇体积分数为40%,温度130℃,压力500 kPa,粒径60目,固液质量比1∶20,时间20 min,在此条件下,提取率为4.16%,提取速率为2.08 mg/(g·min)。乙醇回流提取法在相同药材粒径和料液比情况下,提取率为3.44%,提取速率为0.19 mg/(g·min)。加压提取法具有省时和高效的优点。 相似文献
15.
16.
《分离科学与技术》2012,47(2):289-299
ABSTRACTPhenolic compounds were extracted from pistachio hull using microwave-assisted solvent extraction (MASE). The effects of four parameters, microwave power, extraction time, solvent to sample ratio, and ethanol concentration were evaluated. The extraction conditions were optimized by response surface methodology to enhance the total phenolic content (TPC). Optimal conditions were found as 140 W microwave power, 4.5 min extraction time, 19:1 (v/w) solvent to sample ratio, and 56% ethanol concentration to get maximum TPC (62.24 mg GAE/g dry hull). Also, MASE was compared with conventional solvent extraction (CSE) and MASE gave higher TPC, yield, and antioxidant activity. 相似文献
17.
《分离科学与技术》2012,47(18):2779-2785
Ultrasonic-assisted extraction was applied to extract oxyresveratrol from cultured black mulberry bark (OCBMB). The process was optimized by response surface methodology. According to the results of the signal factor test, the Box–Behnken design was employed to investigate the effects of four chosen independent variables (ultrasonic power, extraction time, ethanol concentration, and acetic acid concentration) on the oxyresveratrol extraction, and the response surface plots showed that the parameters exhibited interactive effects. The optimal conditions were as follows: extraction temperature, 50°C; ratio of solution to solid (v/m), 20:1; ultrasonic power, 496.23 W; extraction time, 113 min; ethanol concentration, 70.98%; acetic acid concentration, 0.77%. Under these optimal conditions, experimental values well matched with the predicted values, which indicated the model used had extremely good fitting degree and the response surface methodology for optimizing Ultrasonic-assisted extraction of OCBMB was successful. 相似文献
18.
19.
为获得最佳的荞麦粉黄酮超声提取工艺,在考察单因素的基础上,采用四因素三水平的正交试验,获得最佳的超声提取黄酮工艺条件为:乙醇浓度65%,料液比为1∶45,超声温度60℃,超声时间25 min。在最优工艺条件黄酮得率最高,为20.5 mg/g。 相似文献