共查询到10条相似文献,搜索用时 15 毫秒
1.
《热处理技术与装备》2012,(4):64
锂锰氧化物薄膜的二极管激光器热处理Diode laser heat treatment of lithium manganese oxide films作者:J.Prll,R.Kohler,A.Mangang,S.Ulrich,M.Bruns,H.J.Seifert,W.Pfleging期刊:Applied Surface Science,Vo.258,Issue 12,1 April 2012,P:5146-5152 相似文献
2.
Diamondabrasivetoolsareextensivelyusedintheprocessingofstone ,frominitialsawingtofinalfinishing .Infact,abrasiveprocessingofgraniteandmarbleforconstructionisthemostimportantfactorintheconsumptionofindustrialdiamond .Duringgrinding ,diamondabrasivegritsonthewheelsurfaceinteractwiththeworkpieceanddothecutting .Theenergyexpendedbythegrindingprocesscanleadtoelevatedtemperaturesatthegrindingzone ,whichmaycausethermaldamagetotheworkpieceandpromotewheelwear.Accordinglyextensivepastresearchhasbeenconc… 相似文献
3.
4.
5.
6.
研究了淬火+回火(No.1钢)及淬火+冷处理+回火(No.2钢)两种处理工艺下,超级马氏体不锈钢组织和性能的差异。结果表明:两钢中基体组织均为回火马氏体,但经过冷处理的No.2钢马氏体板条更平直,尺寸更小。在No.1、No.2钢中,随回火温度的升高,逆变奥氏体含量的变化趋势都为先增高后降低。在No.1、No.2钢中逆变奥氏体达到最大值的回火温度分别为650℃,700℃。No.2钢中Ni元素富集点含量比No.1钢低,但Ni富集点数比No.1钢多。No.1、No.2钢的硬度变化趋势都为先快速降低后缓慢回升,但在相同回火温度下,No.2钢的硬度值更低。 相似文献
7.
《中国铸造》2009,6(4):378-382
19. Microstructural Evolution of AZ91 Alloy Containing 3%Ca Prepared by Cooling Slope
A. ravani, H. Aashuri, P. Davami, A. Narimannezhad, A. Foroughi and M. Kiani
Globulization of the grain refined AZ91 magnesium alloy with Ca on a cooling slope was investigated. Dendntic morphology of the grains was transferred into round and well distributed small particles as a result of grain-refinement effect of Ca in the alloy. 相似文献
8.
将制备的β-Si3N4晶种(添加剂为Yb2O3)加入到α-Si3N4起始原料中,经热压烧结获得试样.在相同的烧结条件下,与未添加晶种时的氮化硅相比,加入8%的晶种后氮化硅的热导率在各温度点高出3 W.m-1.K-1~5 W.m-1.K-1.随着温度的升高,两者的热导率均明显降低.当温度从室温升至1 200℃时,未添加晶种的氮化硅的热导率从36.2W.m-1.K-1下降到7.74 W.m-1.K-1;添加了晶种的氮化硅热导率从40.1 W.m-1.K-1下降到10.4 W.m-1.K-1.同时,利用XRD和SEM分别对热压试样的相组成和显微结构进行了分析. 相似文献
9.