X波段砷化镓单片驱动功率放大器

介绍了X波段砷化镓单片驱动功率放大器的结构设计、CAD设计、工艺制作及测试结果。该放大器工作频率高、增益高,同时具有一定的输出功率,适用于各种应用环境。X波段砷化镓单片驱动功率放大器工作在8~10 GHz,典型输出功率≥20.5 dBm,功率增益≥19 dB,工作电流≤100 mA。     

X波段及DBS接收用PHEMT单片低噪声放大器

报道了X波段及DBS接收用单片低噪声放大器的研制结果。利用CAD软件对单片电路进行优化设计，设计工作包括MBE材料、PHEMT器件和单片电路三部分。在研制过程中，开展了关键工艺的专题研究。研究结果为：单级单片放大器在10：5－11．6GHz范围内，NF≤1．82dB，G≥7.72dB；在11．7－12．2GHz范围内，NF≤1．80dB，G≥6．8dB；双级放大器在10．4－11．1GHz范围内，NF≤1．96dB，G≥15．3dB，最低噪声系数为1．63dB，最高增益为16．07dB。     

X波段GaN单片电路低噪声放大器

采用0.25μm GaN HEMT制备工艺在AlGaN/GaN异质结材料上研制了高性能X波段GaN单片电路低噪声放大器.GaN低噪声单片电路采取两级微带线结构,10V偏压下芯片在X波段范围内获得了低于2.2 dB的噪声系数,增益达到18 dB以上,耐受功率达到了27 dBm.在耐受功率测试中发现GaN低噪声HEMT器件...     

Ka波段宽带低噪声放大器研究

采用两级宽带单片集成放大器（MMIC）级联，并用微带功率均衡器对放大器的平坦度进行修正。最终实现的Ka波段全频段低噪声放大器的性能——频率范围：26．5—40GHz，增益：30dB，增益平坦度：〈5dB，噪声：≤4．5dB，输入输出端1：2驻波：≤2．2，1dB压缩点功率〉7dBm。     

C波段低噪声放大器的设计

介绍了C波段低噪声放大器的设计和研制过程,并给出了研制结果.它采用平衡式电路结构来达到宽带、低噪声的性能.该放大器在5～6GHz的性能指标为:小信号功率增益GP≥30dB,增益波动△GP≤0.8dB,输出P-1≥10dBm,噪声系数NF≤1.0dB,输入驻波比≤1.2:1,输出驻波比≤1.2:1.     

X波段双级单片功率放大器

本文利用比较符合实际的MESFET器件物理模型,采用集总元件匹配网络设计了单级和双级的x波段单片功率放大器。单级放大器中心频率为10.0GHz,带宽1.3GHz,线性输出功率126mW时,增益为5.2dB。双级放大器中心频率为9.4GHz,带宽0.8GHz,输出功率P_0≥1 00mW,增益G_p≥7dB,带内增益平坦度⊿G_p≤±0.5dB。较好的样品在9.6GHz下输出功率P_0≥250mW,G_p为9.4dB。     

X波段PHEMT功率单片放大器

报道了X波段8W AlGaAs/InGaAs/GaAs PHEMT MMIC功率单片放大器的设计和研制.放大器采用两级拓扑结构,输入输出为50Ω阻抗匹配,芯片面积为4.5mm×3mm.测试结果显示,在7.5V和1.5A的DC偏置下,输出功率在8W以上,功率附加效率为30%,功率增益为15dB.     

X波段PHEMT功率单片放大器

报道了X波段8W AlGaAs/InGaAs/GaAs PHEMT MMIC功率单片放大器的设计和研制.放大器采用两级拓扑结构,输入输出为50Ω阻抗匹配,芯片面积为4.5mm×3mm.测试结果显示,在7.5V和1.5A的DC偏置下,输出功率在8W以上,功率附加效率为30%,功率增益为15dB.     

X波段GaN MMIC低噪声放大器设计

采用SiC衬底0.25 μm AlGaN/GaN高电子迁移率晶体管(HEMT)工艺,研制了一款X波段GaN单片微波集成电路(MMIC)低噪声放大器(LNA).放大器采用三级级联拓扑,第一级采用源极电感匹配,在确保良好的输入回波损耗的同时优化放大器噪声系数;第三级采用电阻电容串联负反馈匹配,在尽量降低噪声系数的前提下,保证良好的增益平坦度、输出端口回波损耗以及输出功率.在片测试表明,在10 V漏级电压、-2 V栅极电压偏置下,放大器静态电流为60 mA,8～12 GHz内增益为22.5 dB,增益平坦度为±1.2 dB,输入输出回波损耗均优于-11 dB,噪声系数小于1.55 dB,1 dB增益压缩点输出功率大于11.9 dBm,其芯片尺寸为2.2 mm×1.1 mm.装配测试表明,噪声系数典型值小于1.6 dB,可承受33 dBm连续波输入功率.该X波段GaN低噪声放大器与高功率放大器工艺兼容,可以实现多功能集成,具有广阔的工程应用前景.     

单片微波GaAs功率FET放大器的设计、制造和性能表征

本文描述了三级和四级单片GaAs功率FET放大器的设计、制造和性能表征。每个放大器芯片的尺寸为1mm×4mm。概述了这些单片放大器的工艺。用一个四级放大器在接近9GHz的频率下,以27dB的增益获得了高达1W的输出功率。所采用的电路布局十分灵活,它允许外接键合引线用作为旁路电感器而使放大器在C波段或S波段工作。用一个改进的四级放大器,在3.5GHz下以28dB的增益得到2W的输出功率,其功率附加效率为36.6%。     

Cost-effective test solutions for smart card and other integrated flash applications

From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.     

An improved parallel thinning algorithm with two subiterations

The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.     

Theoretical analysis of the relationship between the Brillouin gain coefficient and the strain in the optical-fiber sensors

The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.     

Novel fiber-optical interferometer with miniaturized probe for in-hole measurements

Today, micro-system technology and the development of new MEMS （Micro-Electro-Mechanical Systems） are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.     

Teleportation of an arbitrary unknown N-qubit entangled state under the controlling of M controllers

A new quantum protocol to teleport an arbitrary unknown N-qubit entangled state from a sender to a fixed receiver under M controllers(M < N) is proposed. The quantum resources required are M non-maximally entangled Greenberger-Home-Zeilinger (GHZ) state and N-M non-maximally entangled Einstein-Podolsky-Rosen (EPR) pairs. The sender performs N generalized Bell-state measurements on the 2N particles. Controllers take M single-particle measurement along x-axis, and the receiver needs to introduce one auxiliary two-level particle to extract quantum information probabilistically with the fidelity unit if controllers cooperate with it.     

Diode-end-pumped Nd:YVO4/LBO lasers with 4.2W continuous-wave output at 457 nm

A continuous-wave (CW) 457 nm blue laser operating at the power of 4.2 W is demonstrated by using a fiber coupled laser diode module pumped Nd: YVO4 and using LBO as the intra-cavity SHG crystal With the optimization of laser cavity and crystal parameters, the laser operates at a very high efficiency. When the pumping power is about 31 W, the output at 457nm reaches 4.2 W, and the optical to optical conversion efficiency is about 13.5% accordingly. The stability of the out putpower is better than 1.2% for 8 h continuously working.     

Call for Papers

正Wireless Body-area Networks The last decade has witnessed the convergence of three giant worlds:electronics,computer science and telecommunications.The next decade should follow this convergence in most of our activities with the generalization of sensor networks.In particular with the progress in medicine,people live longer and the aging of population will push the development of wireless personal networks     

Call for Papers—Feature Topic,Vol.12,No.7,2015

正Information Centric Networking Information-Centric Networking(ICN) is an emerging direction in Future Internet architecture research,gaining significant tractions among academia and industry.Aiming to replace the conventional host-to-host communication model by a data-centric model,ICN treats data content as the first     

JOURNAL OF ELECTRONICS(CHINA)

正~~     

NOTICE OF CHANGING JOURNAL OF ELECTRONICS （CHINA） TO MICROSYSTEMS ＆ NANOENGINEERING

正Journal of Electronics(China)(JE)was founded in 1984,sponsored by the Institute of Electronics,Chinese Academy of Sciences.JE is one of the first English academic journals in China in the field of Electronics and Information technology.The journal was published quarterly since it was launched in 1984 to 2003,then it is published bimonthly till now.During