共查询到20条相似文献,搜索用时 62 毫秒
1.
GIS组合电器中不同绝缘缺陷引起的局部放电会产生不同的分解化合气体,相应的分解化合气体成份、含量以及产生速率等也有差异。这样使得通过分析分解产物的组分来判断故障类型成为可能,并可以通过检测设备中SF6气体分解气体组分及化合产物,来判断绝缘缺陷类型、性质、程度及发展趋势。 相似文献
2.
本文主要归类并总结SF6气体绝缘类性的电气设备在运行中经常出现的局部放电故障类型,并针对此类设备故障类型提出采用超声波局放带电检测方法来诊断与检测,另外还对电气设备故障诊断采用超声波方法的检测与应用原理进行分析,并通过超声波方法检测SF6气体绝缘电气设备比较典型的故障图谱进行比照分析.同时本文还根据实例来探讨超声波检测SF6气体绝缘电气设备局部放电情况,而实际应用结果证明SF6绝缘电气设备采用超声波检测局部放电情况具有较高的准确性与灵敏度,可以精准的检测出自由金属颗粒、悬浮放电以及电晕放电等缺陷问题,该种检测方法多在带电检测方面、交接试验方面以及电气设备出厂试验方面具有较高的应用前景与使用价值. 相似文献
3.
国内SF6气体绝缘类的电气设备常发生局部放电故障,影响电力系统的安全稳定运行。针对这种情况,文中提出了基于电气设备局部放电的超声波检测技术,对电气设备进行局部放电故障检测与诊断,同时对电力变压器的在线监测进行诊断,最终给出电力变压器的检测图谱。通过使用超声波对SF6气体绝缘类电气设备进行实例验证,结果表明采用超声波技术可以准确地检测出电气设备的电晕放电、悬浮放电等故障。 相似文献
4.
气体绝缘设备中的六氟化硫(SF6)会在高压下分解,造成故障,影响电气系统安全。介绍了一种SF6质量在线检测和分析系统的设计方法,以解决电气设备中SF6气体质量难以在线检测和分析的问题。从功能模块划分、电路软硬件设计和系统集成等方面,介绍了检测系统的基本组成。通过检测实验和外场测试,验证了设计的可行性。本研究可以为多种SF6分解产物的检测提供新的手段。在提高现场检测效率的同时,保护工作人员的人身安全,对电气系统的安全运转具有重要意义。 相似文献
5.
6.
7.
变电站室外GIS设备常见故障处理技术研究 总被引:2,自引:1,他引:1
室外GIS设备是变电站中的核心设备,其内部放电故障将会影响变电站供电安全可靠性。针对GIS设备故障危害,结合实际工作经验,对变电站室外GIS设备内部故障发生的原因和检测技术进行归纳总结,以便提高GIS设备故障处理效率。最后,结合变电站GIS设备I母电流互感器间隔气室SF6绝缘气体气压下降故障处理实例,对变电站室外GIS设备故障处理技术措施进行了详细分析,从GIS设备故障处理后投运试验效果可知,所采取的处理方案正确,故障得到有效处理。 相似文献
8.
带电检测电缆终端以及变压器等电气设备时,可以将设备内部缺陷致使的局部放电缺陷有效并及时的查找出来,以免设备内部局部放电缺陷引发更大的运行事故与故障.本文主要针对某区域某变电站(220kV)中电缆终端设备带电检测局部放电现象的实例进行分析,并探讨超声波定位结果、超高频局放检测以及高频局放检测,通过气象色谱方法来分析设备可疑部位SF6气体的气体分解产物,以便将断路器内部缺陷与故障及时推测出来,最终解体检查该断路器,发现断路器内部存在有多处的放电缺陷,该实例表明电缆采用高频局部放电检测方法是有效并可行的. 相似文献
9.
通过检测SF6分解物可发现GIS设备故障,但设备内部分解物扩散效应会影响检测的故障特征组分气体含量,从而导致判断设备故障存在不足,因此文中针对典型SF6分解物SO2在GIS设备内部的扩散效应和影响因素进行研究。文中基于CFD技术,仿真模拟SO2在设备内部的扩散效应,在压力为0.4 MPa条件下,研究了10种初始浓度对SO2扩散的影响,拟合得到了初始浓度与扩散均匀时浓度的函数关系式,为判断故障的严重性提供理论依据。保持初始浓度不变,在压力分别为0.4 MPa、0.5 MPa、0.6 MPa、0.7 MPa和0.8 MPa的条件下,得到SO2扩散达到均匀的时间分别为3 940 s、3 850 s、3 740 s、3 630 s和3 550 s,结果表明SF6气体的压力环境对SO2扩散有一定的影响,压力越大,SO2扩散均匀所需要的时间越短。文中综合讨论了压力和初始浓度共同作用对SO2 相似文献
10.
变电站GIS设备为全部或部分采用气体而不采用处于大气压下的空气作为绝缘介质的金属封闭开关设备。GIS的安装过程本身就是控制GIS运行质量的最后一个关键阶段。变电站GIS设备安装过程中的存在三大要素:即清洁度、密封性和真空度。保证清洁度是GIS现场安装过程中最首要的任务,若在GIS内部有金属微粒存在导体有划痕、凸凹不平之处,都将破坏GIS内部的电场结构的性能,使得电场畸变,产生过电压而击穿绝缘,而施工现场要保持清洁的工作环境,是保证GIS设备安装质量的关键。密封性是GIS绝缘性能的关键,SF6气体泄露会造成GIS致命的故障,GIS安装过程中的密封效果主要取决于法兰盘接口密封圈的安装调整情况,密封性检查应贯穿于整个安装过程中。真空度的要求是控制SF6含水量的重要保证措施,它不仅能减少SF6气体本身的水分,也减少了罐内其他物质(绝缘体、密封体等)内所含的水分。 相似文献
11.
From rate-distortion analysis to resource-distortion analysis 总被引:1,自引:0,他引:1
《Circuits and Systems Magazine, IEEE》2005,5(3):6-18
The ultimate goal in communication system design is to control and optimize the system performance under resource constraints. As the communication paradigm evolves from the conventional desktop computing, wired, and centralized communication to current mobile, wireless, distributed, and massive communication, video encoding and transmission operate under more and more resource constraints. In traditional video communication applications, such as digital TV broadcast, the major constraint is in the form of transmission bandwidth or storage space, which determines the encoding bit rate. Rate-distortion (R-D) theories have been developed to model the relationship between the coding bit rate and signal distortion. For video communication over mobile devices, the video encoding and transmission operate under additional resource constraints, such as energy supply and on-board computation capability. Therefore, there is a need to extend the traditional R-D analysis to resource-distortion analysis by incorporating the new resource constraints into the R-D analysis framework. In distributed and massive wireless video sensor networks, the resource utilization behaviors of individual video sensors should be well-coordinated through network-level rate allocation and optimum routing so as to maximize the overall performance. In this paper, we start from the classical R-D theory developed by Shannon over 50 years ago, and then review the R-D modelling techniques for modern image and video compression systems. We study the resource-distortion analysis framework for video communication over wireless devices. As one step further, we present the research problem of resource allocation and performance optimization for video compression and communication over a network of wireless communication devices. 相似文献
12.
针对在三维空间做匀速运动的目标,应用非线性系统的可测性理论,对方位-到达时间TMA(目标运动分析)的可测性进行了分析.基于方位和到达时间方法的单站无源定位技术,是通过观测站接收目标辐射源两次TOA(脉冲到达时间)测量之间由于目标运动所造成目标与观测站之间的径向距离发生变化的信息,对目标进行定位.结果表明在观测站与辐射源间的方位角和俯仰角变化率不能同时为零的情况下,观测机不必做机动就可以实现观测. 相似文献
13.
语法分析作为编译过程中继词法分析之后的一个阶段,其主要任务是对词法分析的输出结果进行分析,识别合法的语法单位。随着软件工程领域的发展,对现有软件系统进行维护、重构的需求大量增加,逆向工程作为一种软件工程方法在市场需求下孕育而生,对源代码进行逆向分析从中获取关键信息成为逆向工程的基础,语法分析由此有了非传统意义的运用,成为软件逆向工程中必不可少的一部分。 相似文献
14.
Park S. Principe J.C. Smith J.R. Reid S.A. 《IEEE transactions on bio-medical engineering》1990,37(8):803-811
An interactive design and analysis tool for displaying and quantifying multiple channels of data is presented. The system allows one to easily visualize multiple data channels and simultaneously observe the effects of filters on the data and to evaluate signal detection algorithms. The software is designed for a workstation environment; it will find application in a variety of applications where one needs to simultaneously visualize multiple data channels. TDAT is being used for the design and evaluation of filters and detection algorithms for electroencephalogram (EEG) waveforms, and it is serving as a prototype of a paperless system to be used by electroencephalographers. This paper describes the general software structure of the system and illustrates many of the system features with examples. 相似文献
15.
本文主要通过检索和分析在电视与投影中使用触屏技术的中国专利申请,分析在该领域中国专利申请的申请量、申请区域、申请人及发展趋势,并尝试对触屏技术提出一些有益的建议。 相似文献
16.
17.
18.
19.
20.
《IEE Review》1989,35(2):77-79
Image analysis systems perform measurements or quantification of features in an image. One of the most recently developed areas for the use of image analysis is industrial machine vision, in which the image analyser contributes to the automation of an industrial processing system. One such application is in guiding robots, the image analyser locates the part, checks its conformity to the required model and directs the robot to grasp the part or perform some operation on it 相似文献