A series of poly(γ-benzyl L-glutamate)-block-poly(ethylene glycol) (PBLG-block-PEG)/poly(L-lactic acid) (PLLA) blend membranes were prepared by casting the polymer blend solution in chloroform. Surface morphologies of the PBLG-block-PEG/PLLA blend membranes were investigated by atomic force microscopy (AFM) and scanning electron microscopy (SEM). Thermal, mechanical, and chemical properties of PBLG-block-PEG/PLLA blend membranes were studied by thermogravimetric analysis (TGA), tensile tests, and contact angle testing. It was found that the introduction of PLLA could exert outstanding effects on the morphology and the properties of polypeptide copolymer membrane. 相似文献
The effect of polyaniline and poly(ethylene glycol) diglycidyl ether on tensile properties, morphology, thermal degradation, and electrical conductivity of poly(vinyl chloride)/poly(ethylene oxide)/polyaniline conductive films was studied. The poly(vinyl chloride)/poly(ethylene oxide)/polyaniline conductive films were prepared using a solution casting technique at room temperature until a homogeneous solution was produced. Poly(vinyl chloride)/poly(ethylene oxide)/polyaniline/poly(ethylene glycol) diglycidyl ether conductive films exhibit higher electrical properties, tensile strength, modulus of elasticity but lower final decomposition temperature than poly(vinyl chloride)/poly(ethylene oxide)/polyaniline conductive films. Scanning electron microscopy morphology showed that the polyaniline more widely dispersed in the poly(vinyl chloride)/poly(ethylene oxide) blends with the addition of poly(ethylene glycol) diglycidyl ether as surface modifier. 相似文献
A new kind of binary polymer brushes was synthesized from two immiscible polymers, PMMA and PEG, on GPS‐modified silicon wafers. Surface composition, layer thickness, coverage, chain density, wetting ability, morphology and protein adsorption of the binary brushes were investigated by XPS, ellipsometry, AFM and contact angle measurements. The results show that both PMMA and PEG were successfully grafted onto the surface. The surface coverage and the chain density of PMMA and PEG brushes can be controlled by modulating the reaction temperature and time. This kind of binary polymer brushes exhibits a distinct microphase‐separated structure and excellent protein‐preventing property.
