光通信系统中一种改进的LLR-BP译码算法

光通信系统中低密度奇偶校验(Low-density Parity-check,LDPC)码采用对数似然比置信传播(Log-likelihood Ratio Belief Propagation,LLR-BP)算法进行译码时,在高信噪比区域迭代译码过程中会出现变量节点外部信息振荡不收敛而导致译码纠错性能的降低.为满足光通信系统的要求,提出了一种削弱外部消息振荡的改进LLR-BP译码算法.该算法通过引入加权系数平衡前后两次迭代之间变量节点传递的外部信息,明显减缓了外部信息的振荡现象.仿真结果表明:与传统LLR-BP译码算法相比,该改进LLR-BP算法具有更佳的误码性能,同时降低变量节点外部信息振荡现象并加快了译码的收敛速度.     

非规则LDPC码简化译码算法研究

主要介绍了低密度奇偶校验码(LDPC)的基本概念及规则和非规则两种典型的LDPC码的结构,简要介绍了LDPC码的译码算法,在此基础上,引出两种非规则LDPC码的简化译码算法,仿真验证算法较大地降低了译码复杂度,并在高信噪比下性能损失较小.     

基于变量节点更新改进的最小和算法

LDPC码是一种具有稀疏性且接近香农极限的线性分组码。目前被广泛应用的LDPC简化算法的译码性能损失较多,译码性能和复杂度折中的算法具有重要价值。对几种已知的译码算法进行了深入研究,提出一种基于变量节点更新改进的最小和算法,该算法与最小和算法、归一化最小和算法复杂度相当,但译码性能得到约0.5 d B和0.2 d B的提高,在中高信噪比区,更加接近LLR-BP算法的性能。     

低复杂度的自适应置信差分迭代译码算法

针对中短码长的低密度奇偶校验规则码(Low Density Parity Check, LDPC)规则码,该文采用消息更新规则改进和因子图变换方法,提出一种低复杂度差分迭代译码算法。在置信传播算法的基础上,仅当变量节点的消息值振荡时引入差分映射策略,得出一种选择性的置信差分规则,自适应地调整校验节点消息的归一化系数,提高译码性能。同时,采用展开校验节点的图变换方法,将计算复杂度从随节点度分布指数性增长降至线性增长。分别在高斯白噪声信道和瑞利衰落信道下进行仿真实验,结果表明该算法和基于图变换的其他低复杂度译码算法相比,性能优越且复杂度低,和对数似然比的置信传播算法(LLR-BP)相比,高信噪比区域内的性能优异,低信噪比区域内的计算复杂度明显降低。     

AWGN信道下LDPC码的译码算法研究

在高斯白噪声(AWGN)信道情况下,针对LDPC码的译码算法进行深入分析后,对适用于低密度奇偶校验(LDPC)码的硬判决译码算法与软判决译码算法进行了仿真与对比分析,并通过引入乘性校正因子以降低软判决算法中对数域置信传播(LLR-BP)算法的变量消息相关性。仿真分析表明改进后的LLR-BP算法与原算法相比,在几乎不增加计算复杂度的情况下,其译码纠错性能得到了明显的改善。因而改进后的LLR-BP算法具有明显的优越性。     

对数似然比置信传播算法的改进

改进对数似然比置信传播(LLR BP)算法,以提高其对低密度奇偶校验(LDPC)码的译码性能。在变量节点间加入信道响应相关性,并在算法中预设迭代次数,以使变量节点间传递的外部信息达到平衡,降低外部信息震荡现象,并保障译码不会因所需迭代次数过大而终止。改进型LLR BP算法可降低误码率,并在信噪比(SNR)较小时降低译码迭代次数。     

串行级联LDPC码及其传输性能分析

提出了一种简化的LDPC译码算法,以减小译码算法的复杂度.以非规则LDPC码作为内码,串联一个高码率规则LDPC码作为外码,可降低或消除错误平层.将此串行级联LDPC码在M-QAM调制信道上进行了仿真分析,结果表明其性能优于RS码,可有效利用带宽,同时保证数据可靠传输.     

基于串行消息传递机制的QC-LDPC码快速译码算法研究

针对准循环LDPC(QC-LDPC)码基于洪水消息传递机制译码算法的不足,该文提出了一种快速的分组串行译码算法。该算法通过将LDPC码的校验节点(或变量节点)按一定规则划分成若干个子集,在每一轮迭代过程中,依次对各个子集中的校验节点(或变量节点)并行地进行消息更新,提高了译码速度。同时根据分组规则,提出了一种有效的分组方法,并通过分析发现基于循环置换阵的准循环LDPC码非常适合采用这种分组译码算法进行译码。通过对不同消息传递机制下准循环LDPC码译码算法性能的仿真比较,验证了在复杂度不增加的情况下,该译码算法在继承了串行译码算法性能优异和迭代收敛快等优点的同时,极大地提高了准循环LDPC码的译码速度。分析表明,分组串行译码算法译码速度至少为串行译码算法的p倍(p为准循环LDPC码校验矩阵中循环置换阵的行数或列数)。     

一种低码率的LDPC码在LTE-A中的性能研究

本文通过分析LTE-Advanced系统中准循环LDPC码校验矩阵的构造方法,在不改变母码矩阵的基础上,采用一种灵活的扩展方法,构造了一种低码率的LDPC码。采用一种很实用的编码算法和差分译码算法,在MATLAB仿真平台下,比较了这种LDPC码和Turbo码的性能。结果表明：在短码情况下,这种LDPC码在低信噪比下性能略低于Turbo码,但随着信噪比的增加,LDPC码性能优于Turbo码;在长码情况下,LDPC码的性能明显优于Turbo码。为LTE-Advanced系统的信道编解码器的硬件设计提供了一套有效的编译码算法方案,具有较好的实用价值。     

一种适用于大数逻辑可译LDPC码的自适应译码算法

大数逻辑可译低密度奇偶校验(LDPC)码是一类具有较大列重的码,针对此类特殊的LDPC码,提出了一种基于整数可靠度的低复杂度自适应译码算法。在译码的过程中,算法对每个校验节点分别引入不同的自适应修正因子对外信息进行修正。仿真表明提出的自适应译码算法的性能与和积译码算法的性能相当,在误码率(BER)约为10-5时两种算法性能之间仅有0.1 d B的差异。所提算法具有复杂度低、可并行操作、全整数的信息传递等优点,十分有利于工程实现。     

Cost-effective test solutions for smart card and other integrated flash applications

From its emergence in the late 1980s as a lower cost alternative to early EEPROM technologies, flash memory has evolved to higher densities and speedsand rapidly growing acceptance in mobile applications.In the process, flash memory devices have placed increased test requirements on manufacturers. Today, as flash device test grows in importance in China, manufacturers face growing pressure for reduced cost-oftest, increased throughput and greater return on investment for test equipment. At the same time, the move to integrated flash packages for contactless smart card applications adds a significant further challenge to manufacturers seeking rapid, low-cost test.     

An improved parallel thinning algorithm with two subiterations

The parallel thinning algorithm with two subiterations is improved in this paper. By analyzing the notions of connected components and passes, a conclusion is drawn that the number of passes and the number of eight-connected components are equal. Then the expression of the number of eight-connected components is obtained which replaces the old one in the algorithm. And a reserving condition is proposed by experiments, which alleviates the excess deletion where a diagonal line and a beeline intersect. The experimental results demonstrate that the thinned curve is almost located in the middle of the original curve connectivelv with single pixel width and the processing speed is high.     

Theoretical analysis of the relationship between the Brillouin gain coefficient and the strain in the optical-fiber sensors

The relation between the power of the Brillouin signal and the strain is one of the bases of the distributed fiber sensors of temperature and strain. The coefficient of the Bfillouin gain can be changed by the temperature and the strain that will affect the power of the Brillouin scattering. The relation between the change of the Brillouin gain coefficient and the strain is thought to be linear by many researchers. However, it is not always linear based on the theoretical analysis and numerical simulation. Therefore, errors will be caused if the relation between the change of the Brillouin gain coefficient and the strain is regarded as to be linear approximately for measuring the temperature and the strain. For this reason, the influence of the parameters on the Brillouin gain coefficient is proposed through theoretical analysis and numerical simulation.     

Novel fiber-optical interferometer with miniaturized probe for in-hole measurements

Today, micro-system technology and the development of new MEMS （Micro-Electro-Mechanical Systems） are emerging rapidly. In order for this development to become a success in the long run, measurement systems have to ensure product quality. Most often, MEMS have to be tested by means of functionality or destructive tests. One reason for this is that there are no suitable systems or sensing probes available which can be used for the measurement of quasi inaccessible features like small holes or cavities. We present a measurement system that could be used for these kinds of measurements. The system combines a fiber optical, miniaturized sensing probe with low-coherence interferometry, so that absolute distance measurements with nanometer accuracy are possible.     

Teleportation of an arbitrary unknown N-qubit entangled state under the controlling of M controllers

A new quantum protocol to teleport an arbitrary unknown N-qubit entangled state from a sender to a fixed receiver under M controllers(M < N) is proposed. The quantum resources required are M non-maximally entangled Greenberger-Home-Zeilinger (GHZ) state and N-M non-maximally entangled Einstein-Podolsky-Rosen (EPR) pairs. The sender performs N generalized Bell-state measurements on the 2N particles. Controllers take M single-particle measurement along x-axis, and the receiver needs to introduce one auxiliary two-level particle to extract quantum information probabilistically with the fidelity unit if controllers cooperate with it.     

Diode-end-pumped Nd:YVO4/LBO lasers with 4.2W continuous-wave output at 457 nm

A continuous-wave (CW) 457 nm blue laser operating at the power of 4.2 W is demonstrated by using a fiber coupled laser diode module pumped Nd: YVO4 and using LBO as the intra-cavity SHG crystal With the optimization of laser cavity and crystal parameters, the laser operates at a very high efficiency. When the pumping power is about 31 W, the output at 457nm reaches 4.2 W, and the optical to optical conversion efficiency is about 13.5% accordingly. The stability of the out putpower is better than 1.2% for 8 h continuously working.     

Call for Papers

正Wireless Body-area Networks The last decade has witnessed the convergence of three giant worlds:electronics,computer science and telecommunications.The next decade should follow this convergence in most of our activities with the generalization of sensor networks.In particular with the progress in medicine,people live longer and the aging of population will push the development of wireless personal networks     

Call for Papers—Feature Topic,Vol.12,No.7,2015

正Information Centric Networking Information-Centric Networking(ICN) is an emerging direction in Future Internet architecture research,gaining significant tractions among academia and industry.Aiming to replace the conventional host-to-host communication model by a data-centric model,ICN treats data content as the first     

JOURNAL OF ELECTRONICS(CHINA)

正~~     

NEXT GENERATION WIRELESS NETWORKS–ESPECIALLY THE USE OF MILLI-MICROWAVE BANDS

The global bandwidth shortage of wireless communications has motivated the exploration of the naillimeter wave （ram-wave） frequency spectrum for the next generation wireless communications. Recent advances in RF CMOS technology and high speed baseband signal processing technologies have enabled tile extensive research and development of turn-wave wireless communications. The multi gigabit per second data rate of ram-wave system will lead to applications in many important scenarios, such as WPAN, WLAN,back-haul for cellular system. And the frequency bands include 28 GHz, 38 GHz, 45GHz, 60GHz, E-BAND and even beyond 100 GHz. The propagation and the imitation of the RF circuits design in these frequency bands make the directional antennas be inevitable for mm-wave communications.