两流非对称中间包内控流装置优化的水模型研究

通过水模型实验和数值模拟,研究了两流非对称中间包采用不同控流装置时流体流动的特性.结果表明:圆形湍流控制器与单挡墙组成的控流装置中间包两出口流体流动差异较大;非对称长方形湍流控制器和多孔挡墙组成控流装置的中间包,两流之间的平均停留时间差异是圆形湍流控制器和单挡墙组成控流装置中间包的2/3,且近长水口侧出口的平均停留时间...     

八流方坯连铸中间包控流装置优化的水模研究

通过八流方坯连铸中间包水模实验,研究了不同控流装置对其流动特性的影响。研究表明:对比原挡墙,中间包的控流装置改为新挡渣墙后,表征中间包流动特性的流动特性因素有了明显的改善。在新挡墙的基础上,对稳流器和挡坝等控流装置关于控流效果的影响进行了实验研究,发现每个方案中的一个或者多个控流参数有利于进一步改善中间包的控流效果。通过对比和分析这几种控流方案对改善中间包内流体流动特性的效果,确定了最优方案。     

连铸中间包不同控流装置使用效果比较的模拟研究

采用水力学数学模拟的方法,研究了3号多孔挡墙和U挡墙对昆钢小方坯连铸中间包流动特性的影响。水力学模拟依据相似原理,用"刺激—响应"实验方法,测定不同工况下停留时间分布(RTD)曲线,得到两种挡墙对中间包流体流动的影响。然后用数学模拟的方法验证水力学模拟的合理性。研究结果表明:3号多孔挡墙可以延长1号、2号水口响应时间及平均停留时间,缩短了3号水口响应时间及平均停留时间,控制各流流动趋于一致。中间包内流体流动特性得到明显改善。使用U挡墙后,钢液的平均停留时间Ta有了大幅增加,但各水口的初次响应时间差距较大,各流的流动特征一致性较差。因而,3号多孔挡墙控流效果优于U挡墙。     

侧孔长水口两流非对称中间包流场优化

 中间包流体流动直接影响连铸坯的质量,为了缩小非对称中间包两流之间的流动差异,利用水模型和数值模拟方法,研究了侧孔长水口中间包流体流动特性。研究结果表明：直通型长水口、圆形湍流控制器和单挡墙结构中间包两出口流体差异较大,侧孔长水口和多孔挡墙结构中间包两流之间平均停留时间差异是直通型长水口中间包的3/4,且近长水口侧出口的平均停留时间延长7.7%。     

六流方坯连铸中间包结构优化水模实验

 通过六流方坯连铸中间包水模实验,研究了不同控流装置对其流动特性的影响。采用笔者提出的多流中间包流动特性分析模型及各流流动特性一致性的分析方法进行了定量描述。结果表明,带横墙和不带横墙的“V”型挡墙均能明显改善各流流动特性的一致性,与不带横墙的“V”型挡墙组合挡坝的数量、高度均对流动特性有影响,在较优的“V”型挡墙与挡坝组合控流装置基础上加入抑湍器后控流效果更佳。通过实验研究,提出了优化方案。     

两流非对称中间包结构优化与应用研究

采用水模型实验、数值模拟相结合的方法分析了原型中间包和优化中间包在钢流流场、中间包流动特性方面的差异.结果表明:优化中间包2#水口平均停留时间延长了8.0%,两水口流体平均停留时间之差下降了36.3%.流体在优化中间包内流动轨迹更加复杂,延长了流体在中间包内停留时间.通过工业实验证实了优化方案的可行性.工业试验表明:采用圆形湍流控制器加单挡墙组成控流装置的原型中间包,两水口钢液平均温差为5℃,浇注得到的钢坯试样中,140~300μm夹杂物数量为0.7 mg;而采用非对称长方形湍流控制器加多孔挡墙组成控流装置的中间包,两水口钢液平均温差为3℃或2℃,约为原型中间包两水口钢液平均温差的1/2;浇注得到的钢坯试样中,140~300μm夹杂物数量为0.2 mg,约为原型中间包的1/3.说明采用非对称长方形湍流控制器加多孔挡墙组成控流装置的中间包对两水口温度的均一性起到了显著作用,且更能有效地去除钢液中的夹杂物.     

六流矩形坯连铸中间包结构优化的水模型研究

通过六流矩形坯连铸中间包的水模试验,研究了不同控流装置对其流动特性的影响。研究结果表明,稳流器和多孔挡墙能明显改善各流流动特性的一致性,在此基础上加设方形孔挡墙能有效减小死区体积。合理的中间包组合控流装置为稳流器＋多孔挡墙＋方形孔挡墙。     

重钢5流方坯连铸中间包控流装置的数理研究

对重钢24t中间包控流装置进行水力学模型试验和数值模拟,通过测定停留时间分布(RTD)曲线和夹杂物的排除量,研究了不同尺寸湍流控制器对中间包流体流动特性的影响。研究结果表明,使用合适的湍流控制器和现有挡墙设置组合,可以延长水口响应时间及平均停留时间,提高活塞流区体积分数30%及降低死区体积分数50%,中间包内流体流动特性得到改善。     

两流非对称中间包流场准对称化的数学物理模拟

通过水模型实验和数值模拟,研究了不同湍流控制器下两流非对称中间包内流体流动特性。数值模拟结果表明：湍流控制器几何结构对两流非对称中间包流体流动特性有明显影响。圆形湍流控制器内流场涡心靠近底部,出口处流体流速垂直向上;中间包流场涡心靠近长水口,涡心高度与挡墙高度基本同高,中间包表面波动大,容易发生卷渣现象。不对称长方形湍流控制器底部为不对称波浪形,流场涡心靠近出口,流体以一定角度从湍流控制器出口流出;其右侧出口面积大于左侧,水口右侧流体流量大于左侧;由于增大了出口面积,出口处流体速度减小,中间包表面平稳。水模型结果表明采用不对称湍流控制器中间包两流之间的平均停留时间差比圆形湍流控制器中间包减少1/4,算术平均值增加5.3%,说明非对称湍流控制器增强了中间包去除夹杂物能力且能有效缩小两流之间流体流动的差异。     

三流中间包内控流装置优化

通过1∶2模型实验和数值模拟,研究了设置弧形挡墙中间包内钢液流动的特性。水模实验结果表明:弧形挡墙中间包各流平均停留时间比原型中间包提高了一倍,弧形挡墙中间包各流之间平均停留时间最大差异比原型中间包降低了5s。数值模拟结果表明:相对于原型中间包,弧形挡墙的中间包内的钢液流经路径较复杂、停留时间更长,夹杂物有足够时间碰撞聚合去除。水模实验与数值模拟研究结果一致。     

China's Major Non-ferrous Metals Imports & Exports

正~~     

Zinc Production by Province in 2014

正~~     

80% of Chinese Firms Purchasing Overseas Mines Ended up in the Red

<正>Minmetals Resources acquired the world’s largest copper mine under construction for USD5.85 billion.One after another,listed companies Jien Nickle,China Molybdenum and Chihong Zinc and Germanium raised money to get involved in overseas mining projects…SOEs and private enterprises are engaged in a frenzy of overseas mine purchasing.A reporter with Economic     

Copper Processing Profit Dropped Sharply,Copper Consumption Will Face Impact in the Second Half of the Year

正Judging from China’s copper consumption field,the biggest consumption unit is electric power,which accounts for 47%of total consumption;it is followed by light industry sector,including household electrical appliance,machinery,durable goods and hardware etc,which accounts for 22%of total consumption;followed by transportation field,     

Central Geological Prospecting Fund Newly Added 16.47 Million Tonnes of Bauxite in 2013

正In 2013,the Central Geological Prospecting Fund(CGPF)Project newly discovered 15 ore fields,including 3 large above ore fields,and 5medium sized ore fields.The reporter learned from the recently published"Annual Report of Central Geological Prospecting Fund Project(2013)"that,from 2006 to 2013 the CGPF     

Manufacturers of Copper Tube for Central Air Conditioner Use Face Mounting Pressure in the Final Quarter of the Year

正This year,the investment growth rate of real estate industry continued to slow down,sold area of commercial housing also dropped significantly,which brought huge pressure to the domestic air conditioning manufactures.In the first half of the year,by relying on high growth in national financial expenditure,along with investment in public infrastructure     

Xinjiang Ranks No.1 in Production of Primary Aluminum in China

正Kang Yi,Honorary Chairman of China Nonferrous Metals Industry Association,said recently at the Forum on Development of the Non-ferrous Metals Industry in Central and Western China held in Zhengzhou that,as more and more electrolytic aluminum factories in Xinjiang came into operation,the electrolytic aluminum output of Xinjiang had reached2,275,000 tons in the first 7 months this year,     

Shenhuo Coal Industry and Electricity Power Completed800,000 t/a Aluminum Project in Xinjiang

正"Xinjiang project has been completed according to schedule,but total completion and total start of production are two different concepts,after completion it still needs a gradual process of reaching production target."On the morning of November 3,Shenhuo Coal Industry and Electricity Power told investors the above statement on the investor interaction platform.     

Guangdong Metal Transaction Center has Become the Second Largest Precious Metal Transaction Platform Nationwide

正The reporter learned from Guangdong Province Precious Metal Transaction Center that in 2013the Center maintained healthy development momentum,and had become the second largest precious metal transaction platform in China in terms of market size;currently Guangdong is quickening steps of financial innovation for the Center,aiming to build a transaction center with international core competitiveness.     

Seven Rare Earth Projects Involving Close to 3 Billion Yuan Investment Landed In the HighTech Zone

正On May 22,Baotou Rare Earth Industry Cooperation Consultation MeetingProject Agreement-signing Ceremony was held in Ningbo,nearly 40 enterprises from Ningbo,Guangdong,Hunan,and Shanxi participated in project consultation.After multi-lateral communication,agreements were signed for a total of 7 rare earth projects successfully.