共查询到20条相似文献,搜索用时 140 毫秒
1.
2.
3.
4.
5.
用电子自旋共振(ESR)方法研究了含纳米晶粒:a-Si:H薄膜的缺陷态.这种薄膜是用等离子体增强CVD方法制备而成,未经任何后处理过程,在室温观察到可见光范围的光致发光.薄膜的ESR谱由三个部分组成:(1)一对轴向对称超精细谱线,其g∥=1.9967,g⊥=2.0016,其超精细常数为1.2×10-2T;(2)一条各向同性谱线,其g=2.0052.线宽△Hpp=1×10-3T;(3)一条轴向对称谱线,其g∥=2.0057,g⊥=2.0042.以上三部分分别来源于三个不同的顺磁中心本文分析了它们的产生, 相似文献
6.
我们制备了M=2,4,6和10的一系列短周期(GaAs)M/(AlAs)M厂超晶格样品并测量了其椭偏光谱.对这些样品的光频介电函数港进行了分析,并与夏建白等的理论计算结果作了直接比较上述理论计算是对M=4,6和10的超晶格样品作出的,并给出相应的介电函数谱曲线.在光子能量3.5~4.5eV范围的E1峰与瓦峰附近的实验谱的主要特征,与理论计算结果相一致实验谱中的E1峰比理论谱要强些,不同M值的超晶格样品之间的E1峰之差异也大于理论结果。 相似文献
7.
本文用束传播方法(BPM)设计了具有弯曲波导吸收区结构1.3μmInGaAsP/InP超辐射发光二极管(SLD),分析了不同吸收区长度La和弯曲的曲率半径R对SLD特性的影响,给出了直观的结果,并进行了优化设计。在假定吸收区后端面反射率为1,和忽略吸收区内的吸收损耗的条件下,取d=0.2μm,w=2μm,Lp=400μm,La=200μm,R=500μm,I=200mA,经吸收区反射耦合回有源区内的光与有源区前端面入射光的强度比率仅为9.5×10-3。 相似文献
8.
9.
10.
11.
Two new submillimeter laser transitions are reported for CH2 F2 optically pumped by the 9R(34) CO2 line. The new transitions allow us to assign molecular transitions to the complete group of laser lines observed with that pump transition. 相似文献
12.
SiC改性Mg_2SiO_4陶瓷微波衰减性能的研究 总被引:2,自引:1,他引:1
采用热压烧结工艺在1500℃下保温1h,制备了SiC改性Mg_2SiO_4陶瓷,研究了SiC添加量对Mg_2SiO_4陶瓷烧结性能、显微结构及微波衰减性能的影响。初步探讨了该Mg_2SiO_4陶瓷的微波衰减机制。结果表明:当SiC质量分数从0增加到10%,Mg_2SiO_4陶瓷的表观气孔率逐渐增大,烧结性能下降;Mg_2SiO_4陶瓷的谐振频率随之向低频移动,谐振吸收峰的峰值逐渐减小,有效衰减带宽增大。电阻损耗和介质损耗是Mg_2SiO_4陶瓷主要的微波衰减机制。 相似文献
13.
采用激光诱导击穿光谱技术对炉渣中的Ca、Mg含量进行了定量分析。由于炉渣成分复杂,建立的一元回归关系式往往得不到理想的结果,这时需要考虑多个自变量的回归分析问题。为了分析炉渣中Ca、Mg元素的含量,将炉渣中Mg、Ca、Fe、Si、Al的原子谱线强度以及Mg、Ca的离子谱线强度作为输入向量。由于不同谱线强度相差过大时,会使在计算出的权重系数中,不同谱线所占的比重大不相同。为了消除不同谱线强度差距过大的影响,对光谱强度进行标准化处理,把所有谱线强度的值放在了一个相似的范围。综合对比分析了非线性多元函数定标、BP神经网络定标以及径向基网络(RBF神经网络)定标在炉渣成分分析中的作用,并重点分析了RBF神经网络定标相对于传统非线性定标方法的优势。 相似文献
14.
K. Benzerhouni J. Dupre C. Meyer J. Derie J. Walrand G. Blanquet 《Journal of Infrared, Millimeter and Terahertz Waves》1990,11(8):981-994
A tunable diode laser spectrometer was used to perform measurements of half-widths and intensities of several rotational lines in v2-band of ammonia. The intensity measurements of 16 lines of15NH3 allowed us to estimate v2-band strength of this molecule at 298 K to be Sv 0=(550±10) cm?2-atm?1. 相似文献
15.
Magnetization measurements were carried out on bulk Tl2Ba2CaCu2O8 (referred to as Tl-2212) and on various site-selective substituted Tl-2212 samples. At 5K between 0 and 4.5 T, the 5 at.
% Mg-doped Tl-2212 (Tl,Mg-2212) samples displayed enhanced pinning as demonstrated by a field dependent increase of the magnetic
critical-current density Jc by 18 to 25 percent over that of pristine Tl-2212. Excess Mg (10–15 at. %), however, is deleterious. Rietveld refinement
of the x-ray diffraction pattern showed Mg on the Tl sites. Auger electron spectroscopy analysis showed part of the Mg on
grain boundaries. The flux-creep activation energies are higher for flux expulsion than for flux penetration in both Tl-2212
and Tl,Mg-2212 samples; the latter displays higher individual values. Our results demonstrate an increase in the number density
of flux lines as a result of increased density of atomic-size-structural, defects by Mg (5 at. %) doping. In the Tl2−yBa2(Ca1−zYz)Cu2O8−x(z=0–0.3; single phase; x and y represent oxygen and thallium vacancies) system also studied, the Tc decreases as z increases. At z=0.3, the sample becomes an antiferromagnetic semiconductor. 相似文献
16.
半化学法制备钨镁酸铅-钛酸铅陶瓷 总被引:2,自引:1,他引:1
采用半化学法制备了纯钙钛矿结构的0.50 Pb(Mg1/2W1/2)O3-0.50 PbTiO3 (0.50 PMW-0.50 PT)陶瓷。以醋酸镁代替传统氧化物混合法中的MgO,提高了MgO的分散性和反应活性,能够有效地促进钙钛矿相0.50 PMW-0.50 PT的形成和抑制钨酸铅的存在。随着预烧温度的提高,0.50 PMW-0.5 0PT粉体的钙钛矿相含量增加,当预烧温度为850℃和保温时间为2 h时其钙钛矿含量达到100%;随着烧结温度的提高,0.50PMW-50PT陶瓷的晶粒尺寸增大,而陶瓷的介电常数先增大后减小,介电损耗先减小后稍微增大。0.50 PMW-0.50 PT陶瓷的最佳烧结条件为1 050℃,2 h,最大相对介电常数为7 606。 相似文献
17.
Mg batteries as the most typical multivalent batteries are attracting increasing attention because of resource abundance, high volumetric energy density, and smooth plating/stripping of Mg anodes. However, current limitations for the progress of Mg batteries come from the lack of high voltage electrolytes and fast Mg‐insertable structure prototypes. In order to improve their energy or power density, hybrid systems combining Li‐driven cathode reaction with Mg anode process appear to be a potential solution by bypassing the aforementioned limitations. Here, FeS x (x = 1 or 2) is employed as conversion cathode with 2–4 electron transfers to achieve a maximum energy density close to 400 Wh kg?1, which is comparable with that of Li‐ion batteries but without serious dendrite growth and polysulphide dissolution. In situ formation of solid electrolyte interfaces on both sulfide and Mg electrodes is likely responsible for long‐life cycling and suppression of S‐species passivation at Mg anodes. Without any decoration on the cathode, electrolyte additive, or anode protection, a reversible capacity of more than 200 mAh g?1 is still preserved for Mg/FeS2 after 200 cycles. 相似文献
18.
K. Allakhverdiev J. Goldstein N. Fernelius D. Huseinova E. Salaev A. Türker 《Journal of Infrared, Millimeter and Terahertz Waves》2005,26(3):457-466
We report the measurement of the temperature dependence of the absorption spectra of ε- GaSe over the temperature range 300 K to 5 K. Measurements have been made for both the e-ray (polarized parallel to the crystal’s c-axis) and the o-ray (polarized perpendicular to the c-axis), over the spectral range 4000 to 10 cm?1. Nine absorption lines at 417, 440, 499, 546, 891, 945, 1015, 1093, 1270 cm?1 were recorded at 300 K for the e- ray spectra. Some of these lines were identified using the results of a modified single layer, linear chain model of GaSe. The lines at 417, 440 and 499 cm?1 were assigned to local impurity absorption originating from N, Mg and O, respectively. The weak lines at 945, 1015 and 1093 cm?1 were assigned to hole transitions from the acceptor levels to the top of the valence band. Two absorption lines at 891 cm?1 and 1270 cm?1 were assigned to hole transitions from the quasi-local acceptor levels to the double degenerate valence sub-bands Γ5 or Γ6. The origin of lines recorded in the far IR absorption spectra at 20, 37 cm?1 and 362 cm?1 were also identified. 相似文献
19.
20.
本文采用Czchrzlski技术生长出优质的Mg:Er:LiNbO3[(X=2%, 4%, 6%, 8%, y=% (mol%))]晶体,测试Mg:Er:LiNbO3晶体的光损伤阈值,红外光谱和紫外—可见吸收光谱,Mg2+浓度增加抗光损伤能力增加,其中Mg(6mol%):Er:LiNbO3和Mg(8mol%):Er:LiNbO3晶体抗光损伤阈值比LiNbO3晶体提高二个数量级以上。它们的红外光谱OH-吸收峰移到3535cm-1附近。Mg:Er:LiNbO3晶体中随着Mg2+浓度增加吸收边紫移程度增大。研究Mg:Er:LiNbO3晶体抗光损伤阈值增强机理,OH-吸收峰移动机理和吸收边移动机理。采用0.523μm激光进行泵浦获得高的利用率。在波长510—580nm范围内得到Mg:Er:LiNbO3晶体稳态发射谱。掺进4mol%的MgO是Mg:Er:LiNbO3晶体寿命最长的晶体。 相似文献