共查询到20条相似文献,搜索用时 343 毫秒
1.
2.
针对无线 Mesh 网络中传统单径路由协议的不足,提出一种基于动态源路由协议(DSR)的多路径路由算法(IDSR).该算法通过在路由发现过程引入带宽和最大转发次数等限制条件,保证了多条路由请求信息的获取;通过在节点不相交的多径选择过程中引入多 QoS 路由代价函数,有效地实现多路径的选择;通过提供多 QoS 保障,使算法具有较高的求解效率,避免了单径路由的不稳定等特点.实验结果表明,IDSR 算法在无线 Mesh 网络的路由中具有更好的 QoS 性能. 相似文献
3.
4.
移动Ad hoc网络(MANET)是一种由无线移动主机/节点组成的动态自治网络.在MANET中进行有带宽保证的按需路由选择具有重要意义.本文提出一种新的按需路由算法LABGR(Location Aided Bandwidth Guaranteed Routing).LABGR以节点当前位置信息为基础,在路由选择过程中把路径稳定性和节点能量受限问题结合起来,采用受限扩散路由方法,利用多种机制避免在全网中进行扩散,限制路由请求过程中被影响的节点数目,有效提高了路由请求效率并且保证了链路带宽.本文还对LABGR算法特性进行了深入分析. 相似文献
5.
6.
7.
8.
9.
传感器网络的部署环境以及节点自身的限制,导致传感器节点很容易出现故障并且难以维护。在基于树的数据收集过程中,节点故障或者链路拥塞会造成较高的通信时延,甚至数据丢失。针对该问题提出以森林作为路由结构进行数据收集的策略。首先提出一个建立森林的算法,然后以多棵树作为路由结构进行数据收集。理论分析和实验结果表明,提出的方法可以有效减少数据收集过程中的数据丢失,在有25个故障节点的情况下,3棵树的森林路由结构收集的数据量与基于连通支配集的路由树收集的数据量相比多55%,并且能降低数据收集的延迟。 相似文献
10.
11.
聚对苯撑苯并双(口恶)唑发光及其器件制备 总被引:2,自引:0,他引:2
采用光谱技术,研究了聚对苯撑苯并双(口恶)唑(PBO)溶液的光敏发光特性,并用相对法估算出溶液发光效率在50%范围.结合光谱技术、半导体电学和电化学等研究手段,具体研究了以PBO为发光层的单层电致发光器件,研究结果显示,电致发光与薄膜的光致发光有具有相同的发光中心,峰值位于510 nm左右.同时发现,由于存制备过程中不同处理条件使得不同厚度薄膜残留的掺杂物质浓度不同,从而引起薄膜的导电性的不同.使得器件的阈值场强随PBO厚度的减小而逐渐增加. 相似文献
12.
在高密度小尺寸的系统级封装(SiP)中,对供电系统的完整性要求越来越高,多芯片共用一个电源网路所产生的电压抖动除了会影响到芯片的正常工作,还会通过供电网路干扰到临近电路和其他敏感电路,导致芯片误动作,以及信号完整性和其他电磁干扰问题.这种电压抖动所占频带相当宽,几百MHz到几个GHz的中频电源噪声普通方法很难去除.结合埋入式电容和电源分割方法的特点,提出一种新型高性能埋入式电源低通滤波结构直接替代电源/地平面.研究表明,在0.65~4GHz的频带内隔离深度可达-40~75 dB,电源阻抗均在0.25ohm以下,实现了宽频高隔离度的高性能滤波作用.分别用电磁场和广义传输线两种仿真器模拟,高频等效电路模型分析这种低通滤波器的工作原理以及结构对隔离性能的影响,并进行了实验验证. 相似文献
13.
Aluminium was a primary material for interconnection in integrated circuits (ICs) since their inception. Later, copper was introduced as interconnect material which has better metallic conductivity and resistance to electromigration. As the aggressive technology scaling continues, the copper resistivity increased because of size effects, which causes increase in delay, power dissipation and electromigration. The need to reduce the resistor-capacitor??????? delay, dynamic power utilisation and the crosstalk commotion is as of now the fundamental main impetus behind the presentation of new materials. The purpose of this paper is to do a survey of interconnect material used in IC from introduction of ICs to till date. This paper studies and reviews new materials available for interconnect application which are optical interconnects, carbon nanotube (CNT), graphene nanoribbons (GNRs) and silicon nanowires which are alternatives to copper. While doing a survey of interconnect material, it is found that multiwalled CNTs, multilayer GNR and mixed CNT bundles are promising candidates and are ultimate choice that can strongly address the problems faced by copper but on integration basis copper would last for coming years. 相似文献
14.
C. Fulk R. Sporken J. Dumont D. Zavitz M. Trenary B. Gupta G. Brill J. Dinan S. Sivananthan 《Journal of Electronic Materials》2005,34(6):846-850
We investigate the properties of arsenic (As) covered Si(211) and Si(311) surfaces by analyzing data from x-ray photoelectron
spectroscopy (XPS) and low-energy electron diffraction (LEED) images. We then create a model using total surface energy calculations.
It was found that both Si(211) and Si(311) had 0.68±0.08 surface As coverage. Si(211) had 0.28±0.04 Te coverage and Si(311)
had 0.24±0.04 Te coverage. The Si(211) surface replaces the terrace and trench Si atoms with As for a lower surface energy,
while the Si edge atoms form dimers. The Si(311) surface replaces all terrace atoms and adsorbs an As dimer every other edge
site. These configurations imply an improvement in the mean migration path from the bare silicon surface by allowing the impinging
atoms for the next epitaxial layer, tellurium (Te), to bind at every other pair of edge atoms, and not the step terrace sites.
This would ensure a nonpolar, B-face growth. 相似文献
15.
光子晶体微腔发光二极管 总被引:1,自引:0,他引:1
光子晶体微腔因其具有增强自发辐射、定向输出和单模工作的能力而受到广泛关注。介绍了光子晶体微腔发光二极管的基本原理、设计、特性、制作及其典型器件。 相似文献
16.
The power generation demand is increasing day-by-day throughout the world, therefore, the use of hybrid systems becomes a significant solution. The hybrid renewable energy system (HRES) is used for delivering power in various regions in order to overcome intermittence of wind and solar resources. Because of increasing environmental problems, for example, greenhouse gas emission and energy cost have interested novel research into substitute methods in favour of electrical power generation. Maximum Power Point Tracking (MPPT) control method is a vast deal of novel research used for enhancing the efficiency of HRES. The authors have revealed that the hybrid techniques i.e. Global MPPT, fuzzy-neuro systems, Adaptive Neuro-Fuzzy Inference System (ANFIS), Perturbed and Observe (P&O) + Adaptive Neural Network (ANN) etc. can provide best results as compared to other MPPT control methods. This paper offering a state of art review of MPPT control techniques for HRES. 相似文献
17.
18.
Fangqiu Wang Chenghua Wang Shengkui Zhou 《International Journal of Electronics》2013,100(10):1765-1788
Impulse radio ultra-wideband (IR-UWB) ranging and positioning require accurate estimation of time-of-arrival (TOA) and direction-of-arrival (DOA). With receiver of two antennas, both of the TOA and DOA parameters can be estimated via two-dimensional (2D) propagator method (PM), in which the 2D spectral peak searching, however, renders much higher computational complexity. This paper proposes a successive PM algorithm for joint TOA and DOA estimation in IR-UWB system to avoid 2D spectral peak searching. The proposed algorithm firstly gets the initial TOA estimates in the two antennas from the propagation matrix, then utilises successively one-dimensional (1D) local searches to achieve the estimation of TOAs in the two antennas, and finally obtains the DOA estimates via the difference in the TOAs between the two antennas. The proposed algorithm, which only requires 1D local searches, can avoid the high computational cost in 2D-PM algorithm. Furthermore, the proposed algorithm can obtain automatically paired parameters and has better joint TOA and DOA estimation performance than conventional PM algorithm, estimation of signal parameters via rotational invariance techniques algorithm and matrix pencil algorithm. Meanwhile, it has very close parameter estimation to that of 2D-PM algorithm. We have also derived the mean square error of TOA and DOA estimation of the proposed algorithm and the Cramer-Rao bound of TOA and DOA estimation in this paper. The simulation results verify the usefulness of the proposed algorithm. 相似文献
19.
超宽带脉冲信号的光学生成方法研究 总被引:1,自引:0,他引:1
近年来超宽带(UWB)通信技术迅猛发展,在测量、雷达技术、民用和军事无线通信中有着重要的应用,UWB-over-fiber技术已经成为目前研究的热点,其中就包括UWB脉冲信号的产生方法。区别于传统的电子学方法,光子学产生方法不受电子瓶颈制约,可以实现很高的带宽,并且具有抗电磁干扰、重量轻、结构紧凑的优点。通过对比国内外本领域研究成果,讨论及总结了以下三种原理的UWB脉冲信号的光学生成方法:1)相位调制-强度调制转换(PM-IM);2)半导体光放大器(SOA)的非线性效应;3)频谱塑形和色散所致频域-时域映射,然后对各种方案进行了对比分析。 相似文献
20.
多孔硅发光机制的分析 总被引:4,自引:0,他引:4
从量子力学的基本理论出发讨论了量子限制效应,推导出多孔硅有效禁带宽度增量并用量子限制效应和表面态及其物质在发光中作用的理论解释了PS光致发光的实验现象。 相似文献