共查询到18条相似文献,搜索用时 187 毫秒
1.
2.
3.
4.
《应用化工》2022,(3):670-674
研究了曼尼希碱1-苯基-3-苯胺基-1-丙酮(PPO)、2-苯甲酰基-3-羟基-1-丙烯(BAA)和3-甲基丁炔醇(MB)的协同缓蚀作用。结果表明,以PPO为主剂、BAA和MB为助剂与分散剂等复配得到了缓蚀剂PBM-Ⅲ,与单独使用曼尼希碱PPO相比,缓蚀剂PBM-Ⅲ缓蚀性能更好,三者之间具有良好的协同缓蚀作用。测得N80钢片在90℃、PBM-Ⅲ加量为1.0%(w)的20%盐酸中的腐蚀速率为1.251 2 g/(m2·h),缓蚀率为99.90%;PBM-Ⅲ在N80钢片表面的吸附模型符合Langmuir吸附等温式,是以阳极控制为主的混合型缓蚀剂。 相似文献
5.
《当代化工》2020,(7)
用三种不同链长的双卤代烃与α-甲基吡啶制备了三种新型的双季铵盐,采用核磁氢谱对其结构表征。分别通过静态失重腐蚀试验、电化学极化曲线和交流阻抗谱(EIS)测定其在15%盐酸中对N80钢的缓蚀作用。腐蚀试验结果表明,随分子中疏水链的增长缓蚀效果逐步提高,溴化1,8-二(α-甲基吡啶)辛烷(BMHD-8)缓蚀效果最佳,浓度为1.5×10~(-2) mol·L~(-1)时,在15%HCl、25℃下对N80钢的缓蚀率达92.0%。电化学实验说明所合成的缓蚀剂属于混合型缓蚀剂。缓蚀剂分子会在N80钢表面形成吸附膜,吸附行为符合Langmuir吸附模型,且同时存在物理与化学两种吸附类型。 相似文献
6.
7.
利用邻氧乙酸苯甲醛缩4-氨基苯甲酸钾盐席夫碱(K2L1)缓蚀剂在20#碳钢表面制备了自组装单分子膜(SAMs),通过电化学方法研究了缓蚀剂的合成条件、自组装时间等因素对成膜的影响,结果表明,合成中KOH与邻氧乙酸苯甲醛按2:1摩尔比进行反应得到的K2L1缓蚀剂在碳钢表面自组装3 h后,可以形成稳定、致密的缓蚀膜。缓蚀性能的研究表明,碳钢表面K2L1-SAMS抑制了碳钢的阴极还原过程,改变了电极表面双电层结构,具有良好的缓蚀效果(最高缓蚀效率可达95%以上),交流阻抗和极化曲线得到的结论是一致的。同时研究表明K2L1的吸附行为符合Langmuir吸附等温式,吸附机理是典型的化学吸附。量子化学计算结果表明,K2L1分子具有多个吸附活性中心,这些活性原子的前线轨道能与碳钢表面铁原子的前线轨道相互作用,因而使得K2L1分子在碳钢表面形成吸附膜,阻止了碳钢在饱和CO2油田水介质中的溶解。X射线光电子能谱(XPS)分析表明,K2L1通过配位键在碳钢表面形成了稳定的缓蚀膜。 相似文献
8.
9.
采用超声波法提取荞麦(Fagopyrum esculentum Moench.)得到荞麦提取物(FEME),采用失重法和电化学法研究FEME对金属铝在1.0 mol/L HCl溶液中的缓蚀性能,并通过扫描电子显微镜(SEM)、原子力显微镜(AFM)表征铝表面的微观形貌,红外光谱(FTIR)测定了FEME在缓蚀前后的官能团结构和化学键组成。结果表明,FEME对铝在1.0 mol/L HCl溶液中有良好的缓蚀性能,30℃下,500 mg/L FEME的缓蚀率达到了86.7%,FEME在铝表面的吸附符合Langmuir吸附等温式,吸附类型为物理吸附和化学吸附相结合的混合吸附型,但20℃时标准吸附Gibbs自由能为-19.22 kJ/mol,体现以物理吸附为主;电化学极化曲线表明,FEME为以抑制阴极析氢反应为主的阴极抑制型缓蚀剂,电化学阻抗谱容抗弧随FEME浓度的增大而明显增大,铝的电荷转移电阻增大,腐蚀抑制作用增强;铝缓蚀后,表面平均粗糙程度和起伏度明显减小,FEME有效吸附在铝表面,达到缓蚀效果。 相似文献
10.
11.
12.
13.
Mahendra Yadav Sushil Kumar Laldeep Gope 《Journal of Adhesion Science and Technology》2013,27(11):1072-1089
Amino acid derivatives, namely, 2-(2-oxo-2-phenothiazin-10-yl)ethylamino)-3-mercaptopropanoic acid (OPEM) and 2-(2-oxo-2-phenothiazin-10-yl)ethylamino)acetic acid (OPEA) were synthesized and investigated as inhibitors for mild steel corrosion in 15% HCl solution using the weight loss, polarization, and electrochemical impedance spectroscopy (EIS) techniques. The inhibition efficiency of both the inhibitors increased with increasing the temperature and concentration of inhibitor. The inhibitors OPEM and OPEA show corrosion inhibition efficiency of 97.5 and 95.8%, respectively, in 200?ppm concentration, at 333?K. Polarization studies showed that both studied inhibitors were of mixed type in nature. The adsorption of inhibitors on the mild steel surface obeys Langmuir adsorption isotherm and the surface of inhibited and uninhibited specimens were analyzed by scanning electron microscopy (SEM). The semiempirical AM1 method was employed for theoretical calculations and the obtained results were found to be consistent with the experimental findings. 相似文献
14.
HCl介质中EDBDP对Q235钢的缓蚀性能研究 总被引:1,自引:0,他引:1
采用失重法和电化学法研究了O,O′-(苯甲基)二硫代磷酸-N,N-二乙铵(EDBDP)在HCl介质中对Q235钢的缓蚀性能,两种方法共同验证了EDBDP是一种优良的缓蚀剂。失重法研究表明:25±1℃时,在5%HCl溶液中,当EDBDP浓度为120 mg/L时,缓蚀率高达99.07%;电化学研究结果表明:EDBDP受HCl浓度、温度和待测时间的影响较小,属于混合型缓蚀剂。吸附拟合表明:EDBDP在Q235钢表面的吸附符合Langmuir吸附等温式,属于几何覆盖效应下的单分子层物理吸附。 相似文献
15.
16.
盐酸中原儿茶醛在钢表面的吸附及缓蚀作用 总被引:1,自引:0,他引:1
用失重法和动电位极化曲线法研究了在1.0mol/L HCl中20~50℃原儿茶醛(3,4-二羟基苯甲醛)在冷轧钢表面上的吸附及缓蚀作用.结果表明:原儿茶醛具有中等程度的缓蚀作用,为混合抑制型缓蚀剂,缓蚀率随原儿茶醛的浓度增加而增大,但随温度的增加而减小;原儿茶醛在钢表面的吸附符合Freundlich吸附模型.通过吸附理论和动力学Arrhenius公式求出了相应的吸附热力学参数(吸附自由能ΔG°,吸附热ΔH°,吸附熵ΔS°)和动力学参数表观活化能Ea,并根据这些参数详细讨论了缓蚀作用机理. 相似文献
17.
M. Abdallah S. O. Al Karanee A. A. Abdel Fattah 《Chemical Engineering Communications》2013,200(11):1406-1416
The corrosion behavior of nickel, Inconel 600, and Inconel 690 in different concentrations of HCl solutions and its inhibition by clove oil was studied using potentiostatic polarization measurements. As the acid concentration increases, the rate of corrosion increases, indicating that HCl accelerates the dissolution of nickel and its alloys. The inhibition efficiency of the clove oil was found to increase with increase of its concentration. The inhibitive action of this oil was discussed in view of adsorption onto the metal surface. The adsorbed layer acts as a barrier between the metal surface and aggressive solution, leading to a decrease in corrosion rate. The adsorption process follows Langmuir adsorption isotherms. It was found that the clove oil provides good protection to nickel and its alloys against pitting corrosion in chloride-containing solution using potentiodynamic anodic polarization techniques. 相似文献