共查询到20条相似文献,搜索用时 156 毫秒
1.
现行烟气抬升高度计算标准中所采用的烟囱温降值偏大于理论和实测值,个别火电厂烟囱温降偏大的原因系漏风所引起,但在烟气抬升高度计算中毋需考虑漏风温降。为此建议对“火电厂大气污染物排放标准”中的烟囱温降取值进行修改。 相似文献
2.
3.
为解决燃机余热锅炉烟囱在使用过程中存在腐蚀和飞锈的问题,对余热锅炉烟囱内壁采用超音速电弧喷涂锌技术,文章介绍了超音速电弧喷涂技术特点以及在烟囱内壁喷涂中的施工工艺。实施结果表明,涂层对锅炉内壁具有良好的防腐作用。燃机烟囱实施喷涂后运行效果良好,延长了使用寿命。该技术方法可靠,有广泛的应用前景。 相似文献
4.
通过分析制冷系统和太阳能烟囱热气流发电系统的技术和特点,提出了太阳能烟囱制冷系统.将太阳能烟囱系统与制冷系统相结合进行制冷,可实现制冷不用电.该系统由烟囱、集热棚、蓄热层、涡轮机、开启式制冷压缩机、冷凝器和变速器等组成.介绍了太阳能烟囱制冷系统的结构特点、工作原理以及系统相关参数的计算方法.分析结果表明,太阳能烟囱制冷系统结构简单,运行维护方便,制冷不用电,无污染,具有良好的环境效应,可根据环境温度改变压缩机运行转速调节供冷负荷,能有效解决热带及沙漠地区的供冷及供电问题. 相似文献
7.
采用计算流体动力学(CFD)方法分析了烟囱对太阳能烟囱发电系统效率的影响。通过对烟囱高度、烟囱形状、烟囱内表面粗糙度和温度对系统的影响分析表明:在其它条件不变的情况下,烟囱高度和直径对系统效率影响最为显著,其次是形状,最后是烟囱内表面粗糙度和温度。 相似文献
8.
论述了无旁通烟囱余热锅炉的起动特点,介绍了过热器应力腐蚀现象,指出了对于无旁通烟囱余热锅炉不可采用常规的方式煮炉,给出了两种切实可行的煮炉方案。 相似文献
9.
10.
11.
12.
13.
火力发电厂传统的圆锥形烟囱普遍存在着正压运行的情况,这为电厂的正常运行埋下了安全隐患.本文进行了烟囱形状优化问题的研究。采用Fluent软件模拟了顶部区域为圆锥、圆柱和倒圆锥三种情况下的烟囱内部速度和压力分布状况,通过比较发现,将烟囱顶部适当区域改为圆柱或倒圆锥形,显著减少烟囱内正压区,其中倒圆锥形对改善烟囱内的压力分布更为有利。 相似文献
14.
叙述了秦岭电厂3、4号机组烟气脱硫改造工程烟囱的实际情况,分析了国内大部分电厂脱硫烟囱运行工况现状。针对秦岭电厂3、4号机组烟气脱硫改造工程湿烟囱的防腐,提出,确实可行的最佳防腐方案。 相似文献
15.
文中以大唐呼图壁热电厂2×300 MW工程为例介绍火力发电厂烟囱玻璃钢内筒运输、找正、对口、湿糊、提升、就位的方法. 相似文献
16.
A novel solar thermal power plant with a floating chimney stiffened on a mountainside segment by segment is proposed. The novel power plant is suitable for the special topography in China (i.e., a vast desert belt surrounded by high mountain chains up to thousands of meters). An investigation of its performance is carried out using a simple mathematical model. The levelized electricity cost and the potential of the proposed solar chimney power generation in the large desert regions in Northwest China are also estimated. The results show that the levelized electricity cost of the proposed power generation is competitive with that of clean coal power plant, that the potential power obtained from the proposed power plant in the Taklamakan Desert or the Badain Jaran Desert can satisfy the total electricity consumption in China, and that the total potential power in the twelve deserts and sands, reaching 25,761 TWh per year, can even supply the electric power needs over the world, which are rapidly increasing. 相似文献
17.
采用无GGH脱硫工艺时,必须对电厂原有烟囱进行内衬防腐材料或贴衬钛钢板的改造,为保证主机和脱硫系统正常运行,需在烟囱改造期间设置临时过渡措施。着重介绍一种位于吸收塔顶的非金属可整体拆卸式脱硫临时烟囱。 相似文献
18.
19.
太阳能烟囱与垂直轴风机耦合发电可行性分析 总被引:1,自引:0,他引:1
通过分析太阳能烟囱热气流发电和垂直轴风力机发电的技术及特点,提出了太阳能热气流烟囱与垂直轴风力机耦合发电的方法。对风力机—太阳能热气流烟囱互补发电系统的可行性进行了分析。互补发电的功率输出持续、稳定,具有大规模并网的良好条件,是实现太阳能与风能综合利用的有效途径。 相似文献
20.
A large number of researchers have paid great attention to solar chimney (SC) power generating technology, but only a few have studied the chimney configuration. Taking a 10 MW SC system as an example, the physical and mathematical models illustrating the fluid flow, heat transfer and output power features of the system are established. Based on constraints such as equal chimney bottom section area or equal chimney surface area, the impact of several sizes of three different chimney configurations upon the chimney outlet air temperature and velocity, system output power and efficiency is analyzed and the influence of the height‐to‐diameter ratio (H/D) of the cylindrical chimney on system performance is studied as well. After a comprehensive analysis of system output power and efficiency, it is proved by the numerical simulation that the cylindrical chimney would be the best choice among the three basic configurations, whose optimum H/D value ranges from 6 to 8. Copyright © 2011 John Wiley & Sons, Ltd. 相似文献