High-pressure dc sputtering of High-Tc BPSCCO thin films withTc(0) above 100 K

High-T _c Bi(Pb)-Sr-Ca-Cu-O thin films have been made on single-crystal MgO substrates using high-pressure dc sputtering technique. X-ray studies confirm the crystallinity and highly oriented structure withc-axis perpendicular to the substrate. By optimizing the annealing schedule the formation of the high-T _c phase is stabilized. The best film exhibited superconducting transition temperature with zero-resistance temperature,T _c(0), as high as 101 K. Temperature dependence ofJ _c indicates the presence of Josephson-type weak links.     

Effect of Bi/Pb ratio and annealing temperature onT c and formation of high-T c phase in Bi-Pb-Sr-Ca-Cu-O superconductor

We studied the effect of Bi/Pb ratio and annealing temperature onT _c and formation of the high-T _c ; phase in Bi-Pb-Sr-Ca-Cu-O superconductor by the three-step reaction process. The optimum Bi/Pb ratio is about 1.8∶0.3 and the optimum annealing temperature is about 845–855°C. It is found that a variate high-T _c phase existed at the higher annealing temperature. The zero-resistance temperature of the variate high-T _c phase decreased when the annealing temperature increased, although the phase is isostructural with the 110 K phase.     

Observation of X-band SQUID signals in a High-Tc superconducting film device

A microwave superconducting magnetometer is described in which a microstrip resonator is coupled to a two-hole high-T _c thin-film SQUID device. Both the microstrip circuit and the thin-film SQUID were fabricated by photolithography techniques. The YBCO thin film was deposited on single-crystal substrate of yttria-stabilized zirconia [YSZ(100)] by an ion beam sputtering technique producing a superconducting transition measured at a critical temperature ofT _c =92 K to within T 3 K. Non linear oscillatory behavior was observed in the microstrip resonator when inductively coupled to the SQUID. This nonlinear behavior yielded a microwave device in which the reflected microwave power varied with applied DC magnetic flux.     

High-Tc superconductor in an a.c. field

The behavior of high-T _c oxides in an alternating field is studied. The short coherence length and the layered structure require an unconventional microscopic analysis. The complex conductivity(, k) is evaluated. The frequency and temperature dependences of the impedance are obtained (in the region of small frequencies). The effect of impurities is discussed. The microwave properties of the proximity system S_h-N (S_h and N are high-T _c and normal films, respectively) are discussed.     

On the characteristic voltage of high-Tc superconductors

The critical currents and normal resistances of the small bridges from yttrium-based high-T _c superconducting ceramics have been measured. The characteristic voltage of these bridges was found to be approximately 20 V. This effect can be explained if, between the ceramic grains, there are contacts of an order of one crystalline cell in size.The authors are grateful to V. N. Polushkin for his help in this investigation.     

t-Model mechanism of high-Tc cuprates

A doublon formalism ofd-p model Hubbard Hamiltonian is studied only with transfer integrals, and without the superexchange term. This gives excellent doping-dependent features ofT _c in high-T _c cuprates.     

A phase diagram of new high-Tcsuperconductors

A phase diagram of new high-T _c superconductors as highly pinning superconductors of the second type is presented. The diagram includes both vortex glass and vortex liquid phases.     

Theab-plane optical conductivity of high-Tc superconductors

There is anisotropy in theab-plane optical properties of the high-temperature superconductors, both in the normal state and in the superconducting state. In both states, two components appear in the optical conductivity: a free carrier part and a midinfrared component. BelowT _c , the free carriers form the superconducting condensate. In YBa₂Cu₃O_7–, the anisotropy of the penetration depth shows that the chains contribute strongly to this superfluid. In Bi₂Sr₂CaCu₂O₈, where chains are absent, there is stillab plane anisotropy. BelowT _c a finite absorption parallelb remains at frequencies as small as 20 meV. This anisotropy could be due to anisotropy either of the superconducting gap or the midinfrared component.     

Preparation of YBa2Cu3O7–x high-Tcceramic superconductors from melt

Fabrication of high-T _c ceramic superconductor in the system Y₂O₃-BaO-CuO by melting a mixture of component oxides has been investigated. The compositions of the resulting specimens and the effects of heat treatment have been investigated. It was determined that molten material was composed of phases including BaCuO₂, CuO, Y₂O₃, and Y₂BaCuO₅. A subsequent heat treatment in air produced a nominal amount of the high-T _c phase, while heat treatment in an O₂ atmosphere resulted in a significantly large percentage of the superconducting phase.     

Magnetic hysteresis of the zero-resistance critical temperature of high-Tc granular superconductors

We have found a notorious hysteretic behavior in the dependence of the zero-resistance critical temperature obtained through resistivity () versus temperature (T) measurements with applied field (H _e ) in High-T _c granular superconductors. This behavior is explained semi-quantitatively based on the analogy between the present observation and a similar hysteresis found in the field dependence of the transport critical current in these materials.     

Superconductivity of 2212 phase in Bi-based high-Tc superconductors

In the Bi-based high-T _c superconductors, three superconducting transition points were observed above the liquid-N₂ temperature range. Allotropes of the 2212 phase were found. These allotropes were metastable and can interchange with the 2212 phase, and theirT _c's vary from 85 to 100 K.     

Specific heat of the high-Tc oxide superconductors

We review the specific heat measurements on La₂CuO₄, La_2–xM_xCuO₄ (M = Ca, Sr, and Ba), YBa₂Cu₃O₇, and the Bi-Ca-Sr-Cu-O and Tl-Ca-Ba-Cu-O systems. Tables of properties derived from the data are presented. Results on RBa₂Cu₃O₇ (R=rare earth elements other than Y) are summarized, as are results on YBa₂(Cu_3–xM_x)O₇ (M=Zn, Cr, Fe, or Ni). The difficulties of analyzing the specific heat data, and specifically the separation of the contributions associated with magnetic impurities, are discussed. It is tentatively concluded that the data nearT _c are consistent with BCS theory, although they show evidence of fluctuation effects. It is also concluded that the low-temperature zero-field data on a majority of the high-T _c oxide superconductors provide evidence of anintrinsic term that is proportional toT, a result that is inconsistent with a gap in the electronic density of states.     

CO2 laser annealing of plasma-deposited high-Tcsuperconducting thick films

Recent advances in the fabrication of high-T _c superconducting thick films demand processing techniques which can eliminate film/substrate interdifiusion that occurs during subsequent post-annealing heat treatment after the film is deposited, thereby limiting the application of the thick films for devices. The present study evaluates laser annealing techniques for plasma-deposited Y-Ba-Cu-O thick films using a high-energy CO₂ laser (10.6m) in a continuous wave mode. The results are compared with those obtained by conventional furnace annealing techniques necessary for post-heat treatment of as-deposited superconducting thick films. The high-T _c superconducting phase is recovered by cationic diffusion during subsequent post-annealing heat treatment. Crystallographic phases and microstructural characterization have been performed using XRD, SEM, and EPMA analytical techniques. The significance of the technology lies in the elimination of film/substrate interdiffusion problems, thereby resulting in high-quality superconducting thick films. The technology will significantly reduce the post-annealing times usually required by conventional furnace annealing techniques.     

Tcenhancement in superconductor-semiconductor arrays

Subsequent to our observation that the Tl- and Bi-based cuprate high-T _c superconductors are built of superconductor-semiconductor arrays (P. C. W. Fung and W. Y. Kwok,J. Superconduct., this issue), we investigate in this paper the possibility ofT _c enhancement arising from the effect of change of phonon spectrum and the effect of size quantization when one or more semiconductor blocks is attached to the basic superconductor in the unit cell.     

Parallel-plate resonator of variable spacer thickness for accurate measurements of surface impedance of high-Tc superconductive films

Measurements of microwave surface impedance of high-T _c films at gigahertz frequencies and nitrogen temperature are performed. A simple technique employing a parallel-plate resonator with liquid nitrogen as a dielectric spaces is suggested. The use of a precise mechanical device provides smooth changing of distance between films from 200m down to zero. Coupling to the resonator is accomplished by means of two small antennas-half-wave vibrators for frequency 10 GHz. The method for determining resistivity and magnetic field penetration depth was based on the analysis of spacer thickness dependences of the resonator quality factor and frequency. YBa₂Cu₃O₇ films produced by a laser deposition technique on CaNdAlO₄ substrates withT _c =91 K andj _c =10⁷ A/cm² and on NdGaO₃ substrates withT _c =91 K andj _c =10⁶ A/cm² are examined, and the valuesR _s =0.6 m,=348 nm atf=8.97 GHz andR _s =0.5 m,=250 nm atf=10.12 GHz, respectively, are obtained at 77 K.     

Some general remarks on metastability and high-Tcsuperconductivity

Some considerations of atomic arrangement and electronic structure of high-T _c superconductive materials are collected to explain the unique behavior of these perovskite-type materials.     

Magnetic field enhancement of high-Tc superconducting pancake coils by Mu metal sheets

High permeability ring-shaped mu metal sheets have been used to enhance magnetic fields in the bore of Bi-based high-T _c superconducting coils. The central magnetic fieldB ₀, generated by pancake coils placed between mu metal sheets, was measured at liquid nitrogen temperature 77 K. The increasing rate (IR) of the central magnetic fieldB ₀ for single pancake coils was from 15 to 63% by using a 0.1 mm thick mu metal sheet. IR was decreased when the originalB ₀ value increased. The thickness of mu metal sheets also affected IR. It was found that IR increased as the number of mu metal sheets was increased. In a test double-pancake coil IR reached 101%,B ₀ was enhanced from 902 to 1815 G, when the total thickness of mu metal sheets on the top and bottom surface of the coil was 2.0 mm. These results indicate that the well-designed high-permeability materials can significantly enhance the magnetic fields generated by high-T _c superconducting coils and magnets.     

Pair density and gaplessness in high-Tc cuprates

The results ofSR and heat capacity studies on high-T _c superconducting cuprates, particularly in the overdoped regime, are presented, and it is shown that the pair density falls away to zero on either side of optimum doping. This is modelled in terms of a finite pair lifetime and depression of the condensate density through intrinsic pairbreaking interactions. This behavior appears to underlie the generic dependence ofT _c upon doped hole concentration. The emerging picture of gapless or near gapless superconductivity in the high-T _c cuprates is confirmed from infrared studies both in our laboratory and elsewhere.SR is also used to prove the rather high density of pairs which proximity-condense on the CuO chains in 123, 247, and 124. This is most clearly exposed through studies on the model system Yb_1–x Ca _x Ba_1.6Sr_0.4Cu₃O_7– which allows pair breaking on the chains and planes to be independently manipulated throughx and.     

Microwave absorption in high-Tc superconductors

We have investigated the 9- and 10-GHz microwave properties of bulk samples of strontium and barium substituted La₂CuO₄ and YBa₂Cu₃O₇ and one YBa₂Cu₃O₇ MBE film on SrTiO₃. Anomalous microwave absorption is seen especially for poorly compacted bulk ceramic samples. Transitions were generally broadened nearT _c and the residual losses were high. The real part of the surface impedance could be fit belowT _c to the empirical equation with an added term linear in temperature. The microwave response of the film was masked by paraelectric absorption and acoustic resonances in the substrate.     

Influence of long-range and strong correlation effects on the electron-phonon coupling in high-Tc oxides

Calculations of the Eliashberg function ²F and the corresponding transport function _tr ² F for high-T _c oxides are presented using a screened ionic model (rigidly shifted ionic potentials screened by charge carriers in the CuO₂ planes within the RPA) for the electron-phonon coupling. It is shown that this model yields a large difference between the transport and the superconducting electron-phonon interaction due to imperfect screening and contributions beyond nearest-neighbor interactions. Using these results, the electron and the lattice heat conductivities are calculated both in the normal and the superconducting state and compared with experiment. Finally, effects due to a strong on-site electron-electron repulsion are included in leading order in an 1/N expansion, whereN is the number of spin degrees of freedom. In particular, it is shown for the infiniteU, one-band Hubbard model that correlations tend to suppress _tr ² F strongly and ² F somewhat.The author thanks M. Kulic for discussions and cooperation on the topic discussed in Section 4.