Dynamic fracture behavior of SiC whisker-reinforced aluminum alloys

This paper presents a study of dynamic fracture initiation behavior of 2124-T6 aluminum matrix composites containing 0, 5.2, and 13.2 vol pct SiC whiskers. In the experiment, an explosive charge is detonated to produce a tensile stress wave to initiate the fracture in a modified Kolsky bar (split Hopkinson bar). This stress wave loading provided a stress intensity rate, K_I,, of about 2 × 10⁶ MPa√m/s. The recorded data are then analyzed to calculate the critical dynamic stress intensity factor,K _Id, of the composite, and the values obtained are compared with the corresponding quasi-static values. The test temperatures in this experiment ranged from −196 °C to 100°C, within which range the fracture initiation mode was found to be mostly ductile in nature. The micromechanical processes involved in void and microcrack formation were investigated using metallographic techniques. As a general trend, experimental results show a lower toughness as the volume fraction of the SiC whisker reinforcement increases. The results also show a higher toughness under dynamic than under static loading. These results are interpreted using a simple dynamic fracture initiation model based on the basic assumption that crack extension initiates at a certain critical strain developed over some microstructurally significant distance. This model enables us to correlate tensile properties and microstructural parameters, as, for instance, the interspacing of the SiC whiskers with the plane strain fracture toughness.     

Dynamic fracture initiation behavior of an HY-100 steel

An investigation was conducted into the effects of test temperature and loading rate on the initiation of plane strain fracture of an HY-100 steel. Fracture toughness tests were conducted using fatigue precracked round bars loaded in tension to produce a quasi-static stress intensity rate of ·K₁ = 1 MPa√m/s and a dynamic rate of ·K₁ = 2 × 10⁶ MPa√m/s. Testing temperatures covered the range from -150 °C to 200 °C, which encompasses fracture initiation modes involving quasi-cleavage to fully ductile fracture. The results of toughness tests show that the lower-shelf values of fracture toughness were substantially independent of loading rate, while the dynamic values exceeded the quasi-static values by about 50 pct on the upper shelf. In analyzing these results, phenomenological fracture initiation models were adopted based on the requirement that, for fracture to occur, a critical strain or stress must be achieved over a critical distance. In separate tests, the observation of microfracture processes was investigated using fractography and anin situ scanning electron microscope (SEM) fracture technique. The layered ppearance of the fracture surfaces was found to be associated with a banded structure which generally contains many MnS inclusions, probably resulting in a reduction of the fracture toughness values.     

反倾断裂面在边坡稳定分析中的作用

本文根据块体理论使用矢量分析方法结合全平面赤平投影方法对某矿的边坡稳定性进行了分析,着重讨论了反倾断裂面时,在边坡稳定性分析中所起的作用.结果表明,当坡体内同时存在顺坡和反倾断裂面在开采过程的有限时间内,相对仅有从而顺坡断裂面存在的条件,可改善边坡的稳定性.定量的计算表明可提高边坡角7°～8°,描述了反倾断裂面对边坡稳定性的改善程度和特征.