共查询到19条相似文献,搜索用时 109 毫秒
1.
多自由度反共振制样粉碎机的分析与设计 总被引:4,自引:0,他引:4
本文对当前常用的制样粉碎机进行了动力学分析,论证了其工作原理为单自由度受迫振动。经多次试验,提出了改制样粉碎机单自由度为多自由度的最佳方案。当满足双反共振条件时,设计的新型反共振制样粉碎机具有体积小、重量轻、耗能少、电动机使用寿命长、价格便宜及隔振效果好等优点。 相似文献
2.
3.
提出了一种局部投影消噪和递归定量分析相结合的轴向柱塞泵故障识别方法。以轴向柱塞泵故障振动信号为研究对象,首先用局部投影消噪方法对振动信号进行消噪;其次对消噪后的振动信号绘制递归图,进而通过递归定量分析对递归图所反映出的系统动力学信息进行特征提取,选择确定率(DET)和递归熵(ENTR)2个特征构成特征向量,构成故障特征样本;然后通过核模糊C均值聚类(KFCMC)方法对训练样本进行聚类,进而依据最小欧氏距离准则对测试样本进行故障识别;最后,将递归定量分析方法和相空间复杂网络定量特征方法进行对比。结果表明,基于递归定量分析的轴向柱塞泵故障识别方法具有更高的故障确诊率。 相似文献
4.
5.
6.
李炯辉 《机械工人(热加工)》2008,(11):11-15,71
本文介绍的现代金相试样制备新技术,它可在更短的时间、更低的制样成本,能正确地显现被检材料的真实组织;同时能更好地实现重现性。 相似文献
7.
提出一种基于多环锁相+DDS结构的C波段小步进频率合成器系统。采用注入锁相振荡技术为DDS设计了高稳定、低相噪参考源,利用10MHz和100MHz整数步进环路改善了系统的杂散及相噪性能。该频率合成器工作频率范围为4.6~5.3GHz,频率步进为1kHz。测试结果表明了合成器具有频谱纯、相噪低、杂散抑制能力强等特点,可满足实际系统需要。 相似文献
8.
通过对国内外各类型粉碎机的研究,设计了一种粗饲料机型。在设计方案中,对传统粉碎机的结构做了系统的研究,并对一些重要参数进行改进和校核计算,使其成为结构紧凑、性能稳定、生产率高、能耗低的高效饲料粉碎机。 相似文献
9.
10.
11.
A Mayer 《Ultramicroscopy》2001,90(1):61-69
The inverse scattering technique we presented previously to enable a sample reconstruction from the diffraction figures obtained by electronic projection microscopy is reforrmulated within the Fresnel-Kirchhoff formalism, which describes the sample as a two-dimensional mask. The method relies on the use of singular values decomposition techniques, thus providing the best least-squares solutions and enabling a reduction of noise. The technique is applied to the analysis of a two-dimensional nanometric sample that is observed in Fresnel conditions with an electronic energy of 40 eV. The algorithm turns out to provide results with a mean relative error around 1% and to be very stable against random noise. 相似文献
12.
13.
14.
We describe and characterize a simple, low cost, low phase noise microwave source that operates near 6.800 GHz for agile, coherent manipulation of ensembles of (87)Rb. Low phase noise is achieved by directly multiplying a low phase noise 100 MHz crystal to 6.8 GHz using a nonlinear transmission line and filtering the output with custom band-pass filters. The fixed frequency signal is single sideband modulated with a direct digital synthesis frequency source to provide the desired phase, amplitude, and frequency control. Before modulation, the source has a single sideband phase noise near -140 dBc/Hz in the range of 10 kHz-1 MHz offset from the carrier frequency and -130 dBc/Hz after modulation. The resulting source is estimated to contribute added spin-noise variance 16 dB below the quantum projection noise level during quantum nondemolition measurements of the clock transition in an ensemble 7 × 10(5) (87)Rb atoms. 相似文献
15.
通过提高HP型中速磨出口温度试验,分析提高HP型中速磨出口温度的安全性与经济性,指出提高磨煤机出口温度的可行性和经济效益。 相似文献
16.
对中速磨煤机的工作原理、结构特点进行分析,阐述几种提高中速磨煤机出力l及煤种适应性的措施,并针对不同的工况、煤种提出建议。 相似文献
17.
ZGM-95中速磨煤机的适应性局部改造 总被引:1,自引:0,他引:1
根据ZGM-95中速磨煤机在长时间、满负荷运行工况下出现的问题,对中速磨的磨盘、迷宫密封等局部提出了技术改造方案.通过改造后的中速磨机既满足负荷增加的需要,又降低其故障率,节省了维修费用,提高了中速磨机运行的经济性. 相似文献
18.
中速磨煤机的常见故障分析及点检管理 总被引:3,自引:0,他引:3
介绍了中速辊盘式磨煤机在运行中常见的故障,并进行了原因分析;根据发生故障的原因,确定了磨煤机的点检部位及主要点检内容,并对点检内容进行了有效管理,能够及时准确断定磨煤机的健康状态等级,针对不同等级采取相应措施,避免"过维修"和"欠维修"的发生. 相似文献