Design of the Compact Parallel Coupled Wideband Bandpass Filter With Very High Selectivity and Wide Stopband

In this letter, a compact and high performance parallel coupled line wideband bandpass filter (PCL-WBF) with open stubs is designed and implemented on the commercial substrate, RT/Duroid 5880. The PCL-WBF is composed of a one-stage coupled line and two open stubs connected near the input/output ports. The design procedure and limit are discussed in detail. The designed filter was fabricated and measured, showing good characteristics of wide stopband and very high passband selectivity. Measured results also have a good agreement with the simulated results.     

Compact Wideband Bandpass Filters With Wide Upper Stopband

In this letter, a T-shaped microstrip feeding arrangement is proposed to design wideband bandpass filter (BPF) using shorted slot-line resonators. This feed line produces frequency selective external coupling which is utilized to suppress unwanted harmonics. Up to sixth order harmonics are suppressed. Other advantages are low passband group delay variation, ease of fabrication, low insertion loss (IL), and compact size. A fabricated BPF of fractional bandwidth 56.3% at midband frequency 2.3 GHz has a maximum IL of 1.2 dB in its passband and 30-dB upper stopband extends over 11.53 GHz     

Compact Electronically Switchable Parallel-Coupled Microstrip Bandpass Filter With Wide Stopband

In this letter, a compact electronically switchable parallel-coupled microstrip bandpass filter (BPF) based on quarter- wavelength resonators and p-i-n diode switch is proposed. The proposed filter occupies only half the circuit size of the conventional parallel-coupled filter. In addition, the type and length of each coupled-line section is suitably chosen such that the inherent transmission zeros associated with the coupled-lines can be used to reject the spurious passbands effectively. By adding only one p-i-n diode along with a simple bias control circuitry, the proposed filter becomes electronically switchable with no current consumption when the filter is turned off. Specifically, a switchable fourth-order microstrip BPF with a center frequency f₀ of 2 GHz, passband insertion loss less than 3 dB, and wide stopband up to 7.7 f₀ in the ON state is demonstrated. The isolation of the filter is better than 30 dB from dc up to 7.7 f₀ in the OFF state.     

Compact Wide Stopband Ultra Wideband Bandpass Filter Using Multilayer Liquid Crystal Polymer Technology

Novel ultra-wideband (UWB) bandpass filters (BPFs) are proposed based on broadside coupled capacitive-loaded transmission line resonators (C-L TLR) in this letter. By utilizing the wideband harmonic suppression behavior of C-L TLR, the proposed UWB BPFs were designed with wide stopband and implemented using multilayer organic liquid crystal polymer (LCP) technology. As demonstrations, a vialess five-pole BPF was designed first, and then by adopting shunt short-circuited microstrip stubs at input/output ports, a compact UWB BPF was designed to meet FCC-defined UWB indoor mask. The proposed UWB BPFs were fabricated using multilayer LCP technology. Good agreements between simulated and measured results of fabricated filters were observed. The measured results show that the fabricated BPFs have good selectivity, wide stopband and high rejection level. The fabricated UWB BPFs have compact sizes of 15.15 mm by 4.7 mm (about $0.55lambda_{rm g0}$ by $0.17lambda_{rm g0}$); and 9.6 mm by 9.2 mm (about $0.35lambda_{rm g0}$ by $0.33lambda_{rm g0}$), respectively, where $lambda_{rm g0}$ is the guided wavelength of $50~Omega$ microstrip line at 6.85 GHz. They are attractive for UWB communications and radar systems.      

Compact Ultra-Wideband Bandpass Filter With Improved Upper Stopband

In this letter, a design of a compact bandpass filter with wide upper stopband is presented for the ultra-wideband communication systems. The filter structure is composed of a modified square slot-line resonator with parallel microstrip feed lines. Improved upper stopband is obtained by exploiting the frequency dispersive coupling behavior between the feed lines and the resonator. Measurements show that the 20.9 dB upper stopband extends at least up to 20 GHz. Filter occupying area is 0.26lambdag times 0.28g, lambdag being the microstrip line guided wavelength at 6.85 GHz.     

Design of a Wide Stopband Microstrip Bandpass Filter With Asymmetric Resonators

In this letter, a novel microstrip bandpass filter (BPF) with asymmetric resonators is presented. With the asymmetric structure and capacitively loaded coupling, a wide bandwidth with sufficient rejection level can be achieved easily. A full-wave electromagnetic simulator IE3D is used, and the prototype of the BPF is fabricated and measured. Comparisons of simulated results and experimental data are shown; moreover, good match validates the proposed filter.     

Design of a Wide Stopband Microstrip Bandpass Filter With Interdigital Resonators

In this letter, a novel microstrip bandpass filter (BPF) with interdigital resonators is presented. With the interdigital resonators and shorted asymmetrical coupled-lines, a wide bandwidth with sufficient rejection level can be achieved easily. A full-wave electromagnetic simulator IE3D is used, and the prototype of the BPF is fabricated and measured. Comparisons of simulated results and experimental data are shown; moreover, good match validates the proposed filter.      

一种新型宽阻带管状带通滤波器的设计

为改进原管状带通阻带特性,设计了一种新型结构.基于阻抗匹配,可在端头引入任意多“r型”网络.同时其衰减极点能有效抑制“谐振峰”状寄生,阻带拓宽多达1倍频程(现为1.27fo～17fo).改进后,滤波器具有低插损(小于等于0.77 dB)、轻量化(小于等于64 g)、高寄生抑制(大于等于75 dB)等特点.目前,该滤波器...     

High Aspect-Ratio Coplanar Waveguide Wideband Bandpass Filter With Compact Unit Cells

This paper introduces a micromachined thick single-metal-layer high aspect-ratio coplanar waveguide (CPW) wideband bandpass filter with compact unit cells based on the electromagnetic bandgap (EBG) concept. The filter is miniaturized as a result of using the EBG concept in design, and also by realizing high aspect-ratio structures with polymer-based deep X-ray lithography fabrication. Cascaded unit cells in the EBG model consist of capacitive and inductive parallel periodically loaded transmission lines, which determine the filter bandwidth. Compact unit cells are realized by using high aspect-ratio CPW stepped-impedance resonators. The main advantage of this approach is that the high aspect-ratio CPW structures make short unit cells practically realizable, resulting in a compact filter structure. A bandpass filter with 47% bandwidth is designed and fabricated using deep X-ray lithography, and the performance and physical size is compared to a conventional quarter-wavelength-based admittance inverter filter.      

宽阻带小型化双频带通滤波器

文中提出了一种具有宽阻带的紧凑型双频带通滤波器,它采用了折叠短路枝节负载谐振器、紧凑型微 带单元谐振器(CMRC)和阶跃阻抗谐振器结构。由于多个谐振器产生了五个可控传输零点(TZ),该滤波器实现了两个 通带之间的良好隔离度以及宽阻带特性。制作并测试了尺寸紧凑的双频带通滤波器实验样品,测试结果显示,第一通 带和第二通带的中心频率/ 插入损耗分别为0. 66 GHz/0. 8 dB 和1. 73 GHz/0. 7 dB,阻带频率高达10. 5 GHz,抑制水平 超过15 dB。     

一种小型化宽阻带窄带通滤波器研究

为实现滤波器设计小型化,降低带通滤波器的高次谐波干扰,本文结合传统的1/4波长谐振器结构,采用在谐振器微带线上添加开路线的方法,降低高次谐振频点处的插入损耗,消减谐波影响。相比半波谐振器,1/4波长谐振器能有效地减小滤波器尺寸,此外开路线的添加除具有消减高次谐波作用,同时还能降低基频谐振点,促进设计小型化。通过仿真软件对该方案的验证及网络分析仪的实物测试表明,此方案具有良好效果,能广泛应用于窄带通滤波器小型化及谐波抑制。     

A Microstrip Bandpass Filter With Ultra-Wide Stopband

This paper develops a novel microstrip bandpass filter with ultra-wide stopband. With the assistance of open stubs and interdigital capacitors, a very wide stopband with a sufficient rejection level can be achieved easily. Detailed design and synthesis procedures are provided. Moreover, the electromagnetic simulator IE3D is used, and the prototype of the bandpass filter is fabricated and measured. Good agreement between measured and theoretically predicted results demonstrates feasibility of the proposed filter.     

Coplanar Waveguide Bandpass Filters With Compact Size and Wide Spurious-Free Stopband Using Electromagnetic Bandgap Resonators

This work presents a novel coplanar waveguide (CPW) bandpass filter (BPF) that uses electromagnetic bandgap (EBG) resonators to reduce the size and suppress the harmonic responses. The propagation characteristic of the EBG structure is investigated by its associated equivalent circuit model. Compared with the conventional half-wavelength resonator at 5GHz, the EBG resonator is 60.5 % more compact. Based on the EBG CPW resonators, the inductively-coupled two-pole BPF with 3.8% 3-dB bandwidth and 2-dB insertion loss at 5GHz is implemented. This structure generates a 59.6% reduction in size and suppresses a second harmonic passband when compared with a conventional filter. To eliminate the third harmonic response, the proposed EBG CPW BPF further incorporates two EBG structures into its input and output ports and has the merit of a small circuit area     

LTCC Wideband Filter Design With Selectivity Enhancement

A new design scheme for the wideband filters with the low temperature co-fired ceramic (LTCC) technology is proposed in this letter. Based on the traditional second-order combline filter, an extra shunt capacitor is added in the middle of the coupled line, and a new transmission zero is thus obtained. The proposed design not only possesses excellent selectivity at both sides of the passband, the fractional bandwidth can also be as wide as 86%. To validate the design scheme, the proposed technique is applied to the third-order combline filter and realized by using the LTCC technology. The wide-band filter with passband of 3.1–5.1 GHz is obtained. With four transmission-zeros, the selectivity and out-band rejection of the third-order filter is further improved from those of the second-order designs.      

A Wideband Bandpass Filter With Wide Upper Stopband Using Stepped-Impedance Cascadable 180 ° Hybrid Rings

This letter proposes a wideband bandpass filter by cascading two 3-dB stepped-impedance cascadable 180deg hybrid rings with a pair of stepped-impedance lines. Thanks to the stepped-impedance lines, a broad upper stopband is achieved. The stepped-impedance vertically installed planar (VIP) coupler is used to implement the ideal 180deg phase inverter and crossovers. The experimental results show that this 2-GHz center frequency, fourth order filter has a 10-dB return loss bandwidth of 92.5% and upper stopband rejection levels of better than -20 dB up to 6.8 GHz. This proposed filter achieves wide passband and broad stopband performance simultaneously.     

高阻带抑制LTCC 滤波器的设计与实现*

提出了一种基于LTCC技术的新型高阻带抑制带通滤波器的实现方法.采用在并联谐振器的圆柱形电感之间引入感性耦合,在高阻带产生一个传输零点,并且能实现非常好的阻带衰减性能.本文对传统的梳状线带通滤波器结构进行改进,利用过孔的寄生电感效应,将过孔用作谐振杆,明显减小了器件的尺寸.并且通过利用空间耦合的寄生效应,实现滤波器的阻带高抑制传输零点,以满足了对特殊频点高抑制的要求.运用该方法设计了中心频率1.65 GHz,通带200MHz,带外2GHz处衰减大于60dBc的五级带通滤波器.实物测试结果和全波电磁仿真结果吻合较好.     

一种基于互异结构的宽阻带带通滤波器研究

针对带通滤波器的高次谐波干扰,结合目前常用的在输入输出微带馈线上添加开路线构成带阻的方法,采用两个互异的中间添加开路线的阶跃阻抗开环谐振器来实现高次谐振频点的相互分离,达到抑制高次谐波实现宽阻带的目的。通过仿真软件对这一方案的验证及网络分析仪的实物测试证明,该方案具有良好的效果,能广泛应用于带通滤波器的谐波抑制。     

Wideband Bandpass Filter With Reconfigurable Bandwidth

this letter proposes a novel building block for developing tunable wideband bandpass filters. The proposed circuit block mainly consists of short circuit coupled lines and short circuit stubs with pin diodes as tuning elements. This work aims to demonstrate reconfigurable bandwidth of this type of filter. Two filters are designed and fabricated; one can be switched between a fractional bandwidth (FBW) of 16.3% and 35% at a center frequency of 1.9 GHz, and the other can be switched from a FBW of 27.8% to 37.4% at a center frequency of 1.9 GHz. The insertion loss and return loss in the first filter range from 4.17 dB to 0.4 dB and 27.54 dB to 19.04 dB. The second filter exhibits an insertion loss ranging from 0.73 dB to 0.43 dB and a return loss range from 31.1 dB to 27.7 dB. The tested filters show good agreement with EM simulations.