Effects of chloride and sulfate on the rate of oxidation of ferrous ion by H2O2

The rates of oxidation of Fe(II) by H(2)O(2) in the presence of sodium perchlorate, sodium nitrate, sodium chloride and sodium sulfate salts (0-1M) have been compared in the study. Experiments were carried out in a batch reactor, in the dark, at pH <3, 25+/-0.5 degrees C and at controlled ionic strength (< or =1M). The experimental results showed that the rates of oxidation of Fe(II) in the presence of chloride, nitrate and perchlorate were identical. In the presence of sulfate, the rate of oxidation of Fe(II) was faster and depended on the pH and the concentration of sulfate. The pseudo second-order rate constants for the reaction of H(2)O(2) with Fe(2+), FeCl(+) and FeSO(4) were determined as 55+/-1, 55+/-1 and 78+/-3 M(-1) s(-1), respectively.     

Photocatalytic degradation of reactive black 5 in aqueous solutions: Effect of operating conditions and coupling with ultrasound irradiation

The degradation of reactive black 5 (RB 5), a representative diazo dye found in textile effluents, by means of ultraviolet irradiation (9W UVA) over TiO(2) suspensions, ultrasound irradiation (80kHz, 135W) and their combined application was investigated. Several commercial TiO(2) catalysts were screened and an anatase Hombicat UV 100 sample exhibited considerable activity in terms of solution decoloration, COD and ecotoxicity reduction. Photocatalytic degradation increased with increasing TiO(2) loading (in the range 0.05-1g/L) and decreasing dye concentration (in the range 120-20mg/L) and solution pH (in the range 9-2.6). At the typical conditions employed in this study (60mg/L dye, 0.25mg/L catalyst, ambient pH=5.8, oxygen sparging), complete decoloration was achieved after 60min of reaction. Addition of H(2)O(2) up to 0.01M hindered degradation, scavenging the photogenerated holes and hydroxyl radicals. Ultrasound irradiation resulted in low decoloration, e.g. less than 10% after 60min at 60mg/L dye and oxygen sparging and slightly improved under an argon atmosphere. The simultaneous application of ultraviolet and ultrasound irradiation resulted in increased decoloration compared to that achieved by photocatalysis and sonolysis operating separately; moreover, the overall sonophotocatalytic effect was greater than the additive effect of the two processes, implying possible synergy.     

Comparison of UV/H(2)O(2) and UV/TiO(2) for the degradation of metaldehyde: Kinetics and the impact of background organics

The kinetics of photodegradation of the pesticide metaldehyde by UV/H₂O₂ and UV/TiO₂ in laboratory grade water and a natural surface water were studied. Experiments were carried out in a bench scale collimated beam device using UVC radiation. Metaldehyde was efficiently degraded by both processes in laboratory grade water at identical rates of degradation (0.0070 and 0.0067 cm² mJ⁻¹ for UV/TiO₂ and UV/H₂O₂ respectively) when optimised doses were used. The ratio between oxidant and metaldehyde was significantly higher for H₂O₂ due to its low photon absorption efficiency at 254 nm. However, the presence of background organic compounds in natural water severely affected the rate of degradation, and whilst the pseudo first-order rate constant of degradation by UV/H₂O₂ was slowed down (0.0020 cm² mJ⁻¹), the degradation was completely inhibited for the UV/TiO₂ process (k′ = 0.00007 cm² mJ⁻¹) due to the blockage of active sites on TiO₂ surface by the background organic material.     

Ozone oxidation for the alleviation of membrane fouling by natural organic matter: A review

Membrane fouling by natural organic matter is one of the main problems that slow down the application of membrane technology in water treatment. O₃ is able to efficiently change the physico-chemical characteristics of natural organic matter in order to reduce membrane fouling. This paper presents the state-of-the-art knowledge of the reaction mechanisms between natural organic matter and molecular O₃ or OH radicals, together with an in-depth discussion of the interactions between natural organic matter and membranes that govern membrane fouling, inclusive the effect of O₃ oxidation on it.     

In situ electrochemical and photo-electrochemical generation of the fenton reagent: a potentially important new water treatment technology

In this work, the design and construction of an annular tube reactor for the electrochemical and photo-electrochemical in situ generation of H2O2 are described. By cathodic reduction of dissolved oxygen and the coupled oxidation of water at a UV-illuminated nanocrystalline-TiO2 semiconductor anode, it was found that the electrochemically generated H2O2 can be employed to readily oxidize the model compound Direct Yellow-52 in dilute acidic solution at high rates in the presence of small quantities of dissolved iron(II). Although, the model organic compound is chemically stable under UV radiation, its electrochemical oxidation rate increases substantially when the semiconductor anode is illuminated as compared to the same processes carried out in the dark.     

Measurement of the initial phase of ozone decomposition in water and wastewater by means of a continuous quench-flow system: application to disinfection and pharmaceutical oxidation

Due to a lack of adequate experimental techniques, the kinetics of the first 20s of ozone decomposition in natural water and wastewater is still poorly understood. Introducing a continuous quench-flow system (CQFS), measurements starting 350 ms after ozone addition are presented for the first time. Very high HO. to O3 exposures ratios (Rct=integralHO.dt/integralO3dt) reveal that the first 20s of ozonation present oxidation conditions that are similar to ozone-based advanced oxidation processes (AOP). The oxidation of carbamazepine could be accurately modeled using O3 and HO. exposures measured with CQFS during wastewater ozonation. These results demonstrate the applicability of bench scale determined second-order rate constants for wastewater ozonation. Important degrees of pharmaceutical oxidation and microbial inactivation are predicted, indicating that a significant oxidation potential is available during wastewater ozonation, even when ozone is entirely decomposed in the first 20s.     

Electrochemical oxidation of organics in water: Role of operative parameters in the absence and in the presence of NaCl

The electrochemical oxidation of organics in water was investigated theoretically and experimentally to determine the role of several operative parameters on the performances of the process in the presence and in the absence of sodium chloride. Theoretical considerations were used to design the experimental investigation and were confirmed by the results of the electrochemical oxidation of oxalic acid (OA) at boron doped diamond (BDD) or IrO₂-Ta₂O₅ (DSA-O₂) anodes in a continuous batch recirculation reaction system equipped with a parallel plate undivided electrochemical cell. Polarization curves and chronoamperometric measurements indicated that, in the presence of chlorides, the anodic oxidation of OA is partially replaced by an indirect oxidation process. This result was confirmed by electrolyses experiments that show that, in the presence of suitable amount of chlorides, oxidation of OA takes place mainly by a homogeneous process. Interestingly, a very different influence of the nature of the anodic material, the flow rate and the current density on the performances of the process arises in the absence and in the presence of chlorides so that optimization of the two processes requires very different operative conditions. In the absence of chlorides, high current efficiency (CE) is obtained at BDD when most part of the process is under charge transfer controlled kinetics, i.e. when low current densities and high flow rates are imposed. On the other hand, in the presence of NaCl, higher CE are generally obtained at DSA anode when high current densities and low flow rates are imposed, i.e. when a high concentration of chemical oxidants is obtained as a result of the chloride oxidation. The effect of other operative parameters such as the OA concentration and the pH were further investigated.     

Effect of biological and chemical oxidation on the removal of estrogenic compounds (NP and BPA) from wastewater: an integrated assessment procedure

A major source of the wide presence of EDCs (Endocrine Disrupting Compounds) in water bodies is represented by direct/indirect discharge of sewage. Recent scientific literature reports data about their trace concentration in water, sediments and aquatic organisms, as well as removal efficiencies of different wastewater treatment schemes. Despite the availability of a huge amount of data, some doubts still persist due to the difficulty in evaluating synergistic effects of trace pollutants in complex matrices. In this paper, an integrated assessment procedure was used, based on chemical and biological analyses, in order to compare the performance of two full scale biological wastewater treatment plants (either equipped with conventional settling tanks or with an ultrafiltration membrane unit) and tertiary ozonation (pilot scale).Nonylphenol and bisphenol A were chosen as model EDCs, together with the parent compounds mono- and di-ethoxylated nonylphenol (quantified by means of GC-MS). Water estrogenic activity was evaluated by applying the human breast cancer MCF-7 based reporter gene assay. Process parameters (e.g., sludge age, temperature) and conventional pollutants (e.g., COD, suspended solids) were also measured during monitoring campaigns.Conventional activated sludge achieved satisfactory removal of both analytes and estrogenicity. A further reduction of biological activity was exerted by MBR (Membrane Biological Reactor) as well as ozonation; the latter contributed also to decrease EDC concentrations.