Realization of a dual-mode bandpass filter exhibiting either a Chebyshev or an elliptic characteristic by changing perturbation's size

A dual-mode resonator with square patches attached to inner corners of a conventional microstrip loop resonator is proposed. The two types of coupling between the degenerate modes are described by changing the perturbation's size for realization of either a Chebyshev or an elliptic function filter. A novel type of dual-mode microstrip bandpass filter using degenerate modes of this type of dual-mode resonators is developed. It is shown that the perturbation's size determines the filter characteristic, whether it is Chebyshev characteristic or elliptic characteristic.     

A reduced-size dual-mode bandpass filter with capacitively loaded open-loop arms

A novel type of dual-mode microstrip bandpass filter using degenerate modes of a dual-mode microstrip square loop resonator with capacitively loaded open-loop arms is proposed. Such a dual-mode bandpass filter with a 0.75% bandwidth at the center frequency of 1.603 GHz is designed and fabricated to demonstrate the design of reduced-size microstrip filters. It is shown that the proposed filter has a size reduction of about 59% at the same center frequency, as compared with the dual-mode bandpass filters such as microstrip patch, cross-slotted patch, square loop and ring resonator filter.     

A novel dual-mode bandpass filter with wide stopband using the properties of microstrip open-loop resonator

A novel dual-mode microstrip square loop resonator is proposed using the slow-wave and dispersion features of the microstrip slow-wave open-loop resonator. It is shown that the designed and fabricated dual-mode microstrip filter has a wide stopband including the first spurious resonance frequency. Also, it has a size reduction of about 50% at the same center frequency, as compared with the dual-mode bandpass filters such as microstrip patch, cross-slotted patch, square loop, and ring resonator filter.     

低损耗双模微带贴片带通滤波器研究

首先提出了一种新颖、简单的带有两个切角的双模微带带通滤波器结构。该结构使用单个贴片谐振器并且没有耦合缝隙,通带两端各有一个衰减极点,可以有效减小滤波器的辐射损耗。对该滤波器结构进一步改进,又提出了一种中心频率1.8GHz相互正交槽线的新型双模微带带通滤波器结构。该滤波器在中心频率1.8GHz处,回波损耗达到31.65dB,通带内最小插损为0.01dB,3dB带宽为19.44%。研究结果表明该结构可以进一步减小辐射损耗,并且可以减小滤波器的体积,有利于小型化。     

Performance improvement and size reduction of microstrip dual-mode bandpass filter

A novel miniaturised dual-mode bandpass filter with multi-arc resonators is proposed. The size of the dual-mode filter can be reduced significantly by using the microstrip dual-mode resonator consisting of multi-arcs; meanwhile insertion loss and spurious response suppression are improved A prototype filter is designed and implemented at 3.6 GHz with 2.8% fractional bandwidth, which shows a low passband insertion loss of 1.02 dB and a wide stopband with rejection better than 20 dB up to about 8.5 GHz.     

Dual-mode microstrip bandpass filter using ring of arrows resonator

A dual-mode microstrip bandpass filter using the degenerate modes of a modified square ring structure is proposed. The size of the new structure is 50% less than conventional dual-mode bandpass microstrip square resonator filters at the same centre frequency. Measurements are in good agreement with designed values.     

Millimeter-Wave Ultra-Wideband Bandpass Filter Employing Dual-Mode Ring Resonators Fed by Step-Impedance Coupled Lines

This paper presents a novel millimeter-wave ultra-wideband (UWB) bandpass filter (BPF) based on microstrip dual-mode rectangular ring resonators. In order to get strong coupling between the input/output line and the dual-mode ring resonators, a step-impedance parallel-coupled structure is adopted for the design of the filter. On the other hand, transmission zeros are produced by the dual-mode resonator. As a consequence, the filter has low insertion-loss in its passband, sharp attenuation in its lower and upper stopbands and very wide stopbands. As an example, a filter with two dual-mode ring resonators is designed and fabricated. The measured frequency property of the fabricated filter shows good agreement with the simulated response.     

Novel planar, square-shaped, dielectric-waveguide, single-, and dual-mode filters

This paper presents a novel concept of a square-shaped dielectric-waveguide resonator, which can easily realize a dielectric-waveguide cross-coupled filter or a dielectric-waveguide dual-mode filter, using the conventional printed circuit board (PCB) process. This planar dielectric-waveguide resonator has a higher Q value than a microstrip resonator. The physical mechanisms of both single- and dual-mode filters are elucidated. Some new coupling structures are developed for undergoing the PCB process. Filter design procedures are detailed. Design curves for the coupling coefficients of internal- and external-coupling structures are determined by full-wave finite-element-method electromagnetic calculations. Measurement results are highly consistent with theory for all trial filters. This study offers an effective means of producing low-cost high-performance planar circuit filters.     

Compact Dual-Mode Open Loop Microstrip Resonators and Filters

A novel compact microstrip dual-mode resonator and filter are proposed. The characteristics of the dual mode resonator are investigated. It is found that the filter response exhibits a desirable stopband response where the first spurious passband naturally occurs at $3{rm f}_{0}$. Finally, methods of miniaturizing such resonators and filters are discussed. The proposed structure was able to achieve 60% size reduction.      

Fractal Dual-Mode Open-Loop Quasi-Elliptic Bandpass Filter with Source-Load Coupling

To realize the feature of small size and high selectivity, a microstrip miniature fractal quasi-elliptic bandpass filter (BPF) with two transmission zeros (TZs) near each skirt is investigated in this paper. The TZs are created by source-load coupling between the input and output E-shaped feeding structures. By using a dual-mode Minkowski fractal shorted stub loaded open-loop resonator, the proposed BPF achieved a size reduction of 97.5% compared with the conventional square dual-mode loop BPF. Even mode analysis is adopted to characterize the Minkowski structure. The frequency responses of the current BPF were simulated and measured with good agreement.     

A novel microstrip square-loop dual-mode bandpass filter with simultaneous size reduction and spurious response suppression

In this paper, a new capacitively stepped-impedance resonator(CSIR) is proposed to develop the microstrip square-loop dual-mode bandpass filter. Using this new design, simultaneous size reduction and spurious response suppression for the dual-mode bandpass filter can be achieved. An analytical formulation of this novel resonator is given in order to elucidate the spurious frequencies relocation design. Together with this formulation, a generalized dual-mode bandpass filter model is developed so as to ease the analysis of transmission zero and insertion loss. A prototype filter is designed at 900MHz with 1.5% fractional bandwidth. Significant spurious suppressions up to 33 and 35 dB are measured at 1.8 and at 2.7 GHz, respectively. A circuitry size reduction of 54% is achieved when compared with that of the conventional structure. Moreover, the CSIR allows frequency tuning and, thus, a varactor-tuned filter is designed and a measured tunable center frequency between 1.5-1.62GHz is demonstrated. Utilizing the proposed structure, not only size reduction,as well as spurious response suppression, but also center frequency tuning can be achieved.     

A joint field/circuit model of line-to-ring coupling structures andits application to the design of microstrip dual-mode filters and ringresonator circuits

A joint field/circuit model is proposed in this paper to characterize a class of line-to-ring coupling structures for design and optimization of microstrip dual-mode filters and ring resonator circuits. The generic model is derived from field theory and presented in terms of circuit elements by applying a newly developed numerical deembedding technique called “short-open calibration” in a deterministic method-of-moments scheme. It provides a new design strategy for characterizing and optimizing electrical performance of the line-to-ring coupling structures. Such three-port topologies are explicitly formulated by using an equivalent network having circuit elements calculated by the proposed joint field/circuit model. Three microstrip tightly coupling geometries and their related ring resonators are studied with the extracted J-inverter susceptance parameters. Experiments are performed to validate the joint model and also show coupling characteristics of the three types of line-to-ring circuit for the design of ring resonators and dual-mode filters. With this new technique, an optimized microstrip dual-mode filter is successfully designed and the prediction agrees well with our measurements     

Bandpass filter design using a microstrip triangular loop resonator with dual-mode operation

A bandpass filter (BPF) design using a dual-mode microstrip triangular loop resonator is presented for the first time. The circuit produces frequency responses with one real finite frequency transmission zero and one imaginary finite frequency zero on either side of the passband. Depending on the perturbation arrangement, the nature of the coupling between degenerate modes causes the zeros to exchange their axis locations from real to imaginary and from imaginary to real while keeping their magnitude. This behavior results in frequency responses that are suitable for applications with asymmetrical requirements. Results show 8% bandwidth filters with insertion loss ranging from 0.82 dB to 1.4dB at 10 GHz. Advantages in size reduction and design flexibility are demonstrated when the triangular loop is compared to other dual-mode resonators.     

新型三角贴片加槽双模滤波器的设计

为了实现微波滤波器的小型化,文中设计了一个新型的三角贴片加槽双模滤波器。通过加槽的设计,使谐振器的工作频率进一步降低,从而实现了滤波器的小型化及低损耗;同时研究了该结构尺寸参数的变化对通带中心频率的影响。最后利用HFSS对滤波器进行了仿真,得到工作频率为2.352～45 GHz以及5.64～5.65 GHz的双通带带通滤波器。整个滤波器采用微带结构,经过仿真优化,得到的滤波器的滤波特性符合预期的要求。     

新型的平面双模椭圆函数带通滤波器

根据传统的方形贴片双模滤波器,提出了一种新颖的带有两个切角的平面双模带通滤波器结构.该结构使用单个贴片谐振器并且没有耦合缝隙,通带两端各有一个衰减极点,有效减小了滤波器的辐射损耗.对该滤波器结构进行改进,又提出了一种带有两个相互正交、长度不等槽线的双模椭圆函数带通滤波器结构.该滤波器在中心频率1.8GHz处,回波损耗达到31.53 dB,通带内最小插损达到0.01 dB,3 dB相对带宽为19.44%.采用Ansotf公司的En-sem ble 8.0仿真软件进行的仿真研究.仿真结果表明该结构可以更加有效地减小辐射损耗,增加带宽,且体积比传统滤波器减小了约40%,有利于小型化.     

一种基于DGS结构的新型双模双通带滤波器

提出了一种新颖的基于缺陷地结构(DGS)的双模双通带滤波器.该滤波器由印制板顶面的一个方形谐振单元和另一个巧妙嵌入在印制板底面DGS中的方形谐振单元并联构成,具有结构紧凑、易于加工的特点.每个谐振单元都具有双模单通带传输特性,可通过公共馈线同时激励实现双模双通带滤波.两个谐振单元的谐振频率相对可调,提高了设计上的灵活性.为减少辐射损耗并改善高频通带插损,使用准共面波导缺陷地结构对底面谐振单元进行了改进.最后,实验制作了两种双模双通带滤波器,测试结果与仿真结果吻合较好.     

A novel microstrip dual-mode bandpass filter with harmonic suppression

A novel dual-mode microstrip bandpass filter (BPF) with harmonic suppression is presented in this letter. The filter is composed of a perturbed square-ring resonator and two end-open L-shaped microstrip lines for the input and output of the resonator. The harmonic suppression of the BPF may be realized by choosing a proper length for the L-shaped microstrip line. The BPF has been investigated numerically and experimentally. Measured results show that the stop-band of the filter is increased up to near the third-order harmonic of the square-ring resonator due to harmonic suppression, and the rejection level is kept below -27dB.     

一种新型广义交叉耦合滤波器的设计

含广义交叉耦合的N个谐振器滤波器,即含源-负载交叉耦合的滤波器能产生N个传输零点,通过给出这种滤波器的等效网络模型和传输函数,设计了两种新颖六边形结构的含源-负载交叉耦合的微带滤波器,一种为对称结构,一种为非对称结构.对其进行了仿真分析,仿真结果与理论值吻合较好.与传统两腔发夹形滤波器相比,这种两腔六边形结构的滤波器尺寸要缩小27.5%,频率选择性更高.     

新型双模介质波导滤波器

为满足5G基站射频前端的要求,提出了一种新型双模介质波导滤波器.在表面镀银的介质填充波导腔里设置两个盲孔和一个耦合槽,可有效控制一对TE201奇偶模.应用上述结构,设计了一个单腔双模滤波器、一个三腔四阶滤波器和一个六腔七阶滤波器.仿真和测试结果表明,在同样阶数下,引入一个双模谐振器能够有效减小滤波器体积:二阶滤波器体积...     

Compact dual-mode elliptic-function bandpass filter using a singlering resonator with one coupling gap

A novel microwave dual-mode elliptic-function bandpass filter with one coupling gap structure is proposed. This filter has a 4.7% bandwidth at 1.805 GHz with 1.73 dB insertion loss. The filter provides less field perturbation of the ring resonator than conventional filters. Without the output coupling gap between the feed line and the ring resonator, a low insertion loss has been obtained. This compact, high performance filter is useful for mobile and personal communication systems